Work and the work-energy theorem
Energy is the ability to cause change, and work is how forces transfer energy. The work-energy theorem links the work done on an object to its change in speed.
Defining work
A constant force does work \(W = Fd\cos\theta\) on an object, where d is the displacement and \(\theta\) is the angle between the force and the displacement. Work is a scalar, measured in joules: 1 J is the work done by a 1 N force acting over 1 m. Pushing a crate 3.0 m with a 20 N horizontal push does 60 J of work.
Positive, negative, and zero work
Work is positive when the force has a component along the motion, negative when it opposes the motion, as friction usually does, and zero when the force is perpendicular to the motion. Carrying a bag horizontally at constant height, your upward force does no work on it, and gravity does no work on a satellite in a circular orbit.
Angled forces
Only the component of force along the displacement does work. Pulling a sled 5.0 m with a 100 N force at 30° above the horizontal does \(100 \times 5.0 \times \cos 30° \approx 433\) J of work. The vertical component lightens the load on the ground but does no work on the sled's horizontal motion.
Kinetic energy
Kinetic energy is the energy of motion: \(KE = \tfrac{1}{2}mv^2\). Because it depends on speed squared, doubling speed quadruples kinetic energy. A 1500 kg car at 20 m/s has \(\tfrac{1}{2}(1500)(400) = 300{,}000\) J, while at 10 m/s it has only 75,000 J.
The work-energy theorem
The work-energy theorem states that the net work done on an object equals its change in kinetic energy: \(W_{net} = \Delta KE\). Accelerating that 1500 kg car from 10 to 20 m/s requires 225,000 J of net work. Bringing it to a stop requires the brakes to do negative work equal to its kinetic energy.
Variable forces
When a force varies with position, the work is the area under the force-position graph. For forces that change smoothly, calculus finds this area by integration. This applies to springs, gravity over large distances, and the force from expanding gas in an engine.
Springs and Hooke's law
An ideal spring exerts a force proportional to its stretch or compression: \(F = -kx\), Hooke's law, after Robert Hooke (1678), where k is the spring constant. The work needed to stretch it by x is the triangle area under the graph, \(\tfrac{1}{2}kx^2\). Stretching a spring of k = 200 N/m by 0.10 m takes 1.0 J.
Worked example
A 0.20 kg puck slides at 5.0 m/s across rough ice and comes to rest. Its initial kinetic energy is 0.5 x 0.20 x 25 = 2.5 J, so friction does -2.5 J of work. If the kinetic friction force is 0.50 N, the stopping distance is 2.5/0.50 = 5.0 m, found without needing the acceleration or time.
Key takeaways
Work by a constant force is F d cos theta, measured in joules; it is positive along the motion, negative against it, and zero when perpendicular. Only the force component along the displacement does work. Kinetic energy is half m v squared, so it quadruples when speed doubles. The work-energy theorem says net work equals the change in kinetic energy, which gives stopping distances directly. Work by a variable force is the area under the force-position graph. Hooke's law, F = -kx, gives spring work of half k x squared.
Flashcard
F d cos theta
Check your understanding
You carry a heavy bag at constant height across a room at constant speed. How much work does your upward force do on the bag?
