Anatomy & Physiology › Section K · Nervous tissue › Topic K.3

Nervous tissue function and the action potential

A neuron stores energy as a voltage across its membrane, built from unequal ion concentrations and selective channels. Release that energy in a controlled burst and you get the action potential, the signal behind every sensation and movement.

From stimulus to movement

You lift a mug of tea hotter than expected. Thermoreceptor endings in the fingertip produce a graded potential, a voltage change whose size matches the stimulus; if large enough, it fires action potentials in the sensory axon. At a synapse in the spinal cord's gray matter, a chemical signal starts a graded potential in the next neuron, and the message is relayed via the thalamus to the cerebral cortex. After integration, upper motor neurons in the precentral gyrus signal lower motor neurons, whose axons release acetylcholine onto muscle. You set the mug down. Every step depends on membrane voltage.

Membranes, channels and gates

Ions cannot cross the hydrophobic core of the phospholipid bilayer unaided. They move through ion channels, proteins whose pores select ions by charge and size, classed by what opens them. Leak channels open and close at random. Ligand-gated channels open when a chemical such as a neurotransmitter binds. Mechanically gated channels open when the membrane is stretched or pressed, as in touch receptors; some sensory channels respond to temperature. Voltage-gated channels open when the membrane potential changes. The sodium-potassium pump (Na⁺/K⁺ ATPase) is a carrier, not a channel: each cycle uses one ATP to move 3 Na⁺ out and 2 K⁺ in, against their gradients.

The membrane potential

The membrane potential is the voltage inside the cell compared with outside, in millivolts (mV). The bulk fluids are electrically neutral; the potential comes from a thin layer of separated charge right at the membrane. Typical textbook values for a mammalian neuron, which vary between cells, are about 140 mmol/L K⁺ inside and 5 mmol/L outside, and about 15 mmol/L Na⁺ inside and 145 mmol/L outside. Each ion feels two forces, its concentration gradient and the electrical gradient. The voltage at which they balance, giving no net flow, is that ion's equilibrium potential.

The Nernst equation

The equilibrium potential of one ion can be calculated from its concentrations. At body temperature, 37 °C, the Nernst equation is

E_{\text{ion}} = \frac{61.5\ \text{mV}}{z}\,\log_{10}\frac{[\text{ion}]_{\text{out}}}{[\text{ion}]_{\text{in}}}

Here \(z\) is the ion's charge (+1 for K⁺ and Na⁺) and the brackets are concentrations. The 61.5 mV factor comes from physical constants at 310 K, so it holds only at body temperature. A positive ion more concentrated outside has a positive equilibrium potential: the inside must be positive to stop more entering. A tenfold ratio gives 61.5 mV for charge +1.

Worked example: potassium and sodium

Find each ion's equilibrium potential from the typical values. 1. Potassium: \(E_{\mathrm{K}} = 61.5 \log_{10}(5/140)\). The ratio is 0.0357, its logarithm is −1.447, so \(E_{\mathrm{K}} = -89.0\) mV. 2. Sodium: \(E_{\mathrm{Na}} = 61.5 \log_{10}(145/15)\). The ratio is 9.67, its logarithm is 0.985, so \(E_{\mathrm{Na}} = +60.6\) mV. 3. Compare with rest, about −70 mV: it lies near \(E_{\mathrm{K}}\) but not on it. 4. Now suppose extracellular K⁺ rises to 10 mmol/L, a typical textbook case of raised blood potassium: \(E_{\mathrm{K}} = 61.5 \log_{10}(10/140) = -70.5\) mV. Rest shifts less negative, changing how easily nerve and heart cells fire. 5. Check the signs: K⁺ is concentrated inside, so its potential is negative.

Why rest is about −70 mV

At rest the membrane has many more open K⁺ leak channels than Na⁺ leak channels. Potassium therefore dominates, pulling the potential towards \(E_{\mathrm{K}}\) (−89 mV), while a small inward leak of Na⁺ pulls it a little towards \(E_{\mathrm{Na}}\). The result is a resting membrane potential of about −70 mV in a typical neuron, though values vary from roughly −60 to −80 mV. The pump adds only a few millivolts directly, by moving three positive charges out for every two in. Its main job is long-term: replacing leaked ions so the gradients never run down. A single action potential moves only a tiny fraction of the cell's ions.

The action potential, phase by phase

1. Depolarisation: a stimulus opens ligand-gated or mechanically gated channels, Na⁺ enters and the membrane becomes less negative. 2. At threshold, about −55 mV, voltage-gated Na⁺ channels open; entering Na⁺ opens still more, a positive feedback loop. 3. The potential overshoots zero and peaks near +30 mV, short of \(E_{\mathrm{Na}}\), because Na⁺ channels inactivate and K⁺ channels begin to open. 4. Repolarisation: voltage-gated K⁺ channels, which open more slowly, let K⁺ leave and the potential falls. 5. Hyperpolarisation: these channels close slowly, so the potential dips below rest towards \(E_{\mathrm{K}}\). 6. Leak channels and the pump restore rest. The spike itself lasts only about 1 to 2 ms.

All-or-none and refractory periods

Once threshold is reached the sequence runs to completion, so every action potential in a neuron has the same size: it is all-or-none. A subthreshold stimulus produces none. A stronger stimulus makes spikes come more often, not bigger, so intensity is coded by frequency. The voltage-gated Na⁺ channel has two gates: an activation gate that opens at threshold and an inactivation gate that closes a fraction of a millisecond later. While inactivation gates are shut, no stimulus can trigger another spike: the absolute refractory period. In the relative refractory period that follows, some Na⁺ channels are still recovering and K⁺ is still leaving, so only a stronger stimulus works.

Propagation: continuous and saltatory

Na⁺ entering one patch of membrane spreads along the inside of the axon and depolarises the next patch to threshold. The patch behind is refractory, so the signal moves only forwards. In an unmyelinated axon every patch fires in turn: continuous conduction, which is slow. In a myelinated axon, voltage-gated Na⁺ channels cluster at the nodes; current spreads quickly under each insulated internode and the action potential is regenerated only at nodes, seeming to leap between them: saltatory conduction, from the Latin for leap. Wider axons also conduct faster, having less internal resistance. Large myelinated fibres reach about 120 m/s; thin unmyelinated fibres manage about 0.5 to 2 m/s.

Worked example: how long does the signal take?

A motor axon runs about 1.0 m from the lower spinal cord to a muscle in the foot. Compare a large myelinated axon conducting at 60 m/s with a thin unmyelinated fibre at 1.0 m/s. 1. Time equals distance divided by speed. 2. Myelinated: \(t = 1.0 \div 60 = 0.0167\) s, or about 16.7 ms. 3. Unmyelinated: \(t = 1.0 \div 1.0 = 1.0\) s. 4. The myelinated fibre is 60 times faster. 5. Check: a delay of milliseconds matches the near-instant feel of moving your foot; a one-second lag would make walking almost impossible. Loss of myelin, as in multiple sclerosis, slows or blocks signals; real symptoms need a qualified professional.

Common mistakes to avoid

First, crediting the pump with most of the resting potential; the K⁺ leak creates it, and the pump maintains the gradients. Second, flipping the Nernst ratio: use outside over inside, then check the sign. Third, believing a strong stimulus makes a bigger spike rather than more frequent ones. Fourth, saying the peak reaches \(E_{\mathrm{Na}}\); it stops near +30 mV. Fifth, crediting repolarisation to the pump instead of voltage-gated K⁺ channels. Sixth, picturing saltatory conduction as a literal jump; current flows inside the axon, and the spike is regenerated at each node.

Key takeaways

Ions cross membranes through leak, ligand-gated, mechanically gated and voltage-gated channels; the pump moves 3 Na⁺ out and 2 K⁺ in per ATP. The Nernst equation gives equilibrium potentials: about −89 mV for K⁺ and +60.6 mV for Na⁺. Rest, about −70 mV, sits near \(E_{\mathrm{K}}\). At threshold, about −55 mV, voltage-gated Na⁺ channels drive the spike to about +30 mV; voltage-gated K⁺ channels repolarise and briefly hyperpolarise. Spikes are all-or-none, refractory periods keep them moving one way, and myelin and wide axons speed them up.

Flashcards

Flashcard

Graded potential

A local voltage change whose size depends on the stimulus

Can trigger an action potential if it reaches threshold.

Test your understanding

Question 1 of 5

Which event is mainly responsible for the repolarisation phase of a neuron's action potential?

Question 2 of 5

At 37 °C, what is the equilibrium potential of a positive ion with charge +1 that is 10 times more concentrated outside the cell than inside?

Question 3 of 5

Why can no stimulus, however strong, trigger a second action potential during the absolute refractory period?

Question 4 of 5

An axon 0.75 m long conducts action potentials at 50 m/s. About how long does a signal take to travel its full length?

Question 5 of 5

A touch receptor's stimulus is made twice as strong. How do the action potentials in its sensory axon change?

← Previous topicNext topic →