Anatomy & Physiology › Section R · Blood vessels and circulation › Topic R.2

Blood flow, pressure, and resistance

Blood moves only because pressure pushes it from where pressure is high to where it is low, against the resistance of the vessels. Three linked quantities, flow, pressure and resistance, explain a blood pressure reading, why narrowed arteries matter so much, and how blood gets back to the heart.

Flow, pressure and resistance

Blood flow is the volume of blood moving through a vessel, organ or the whole circulation per unit time, in mL/min or L/min. It is driven by a pressure difference, \(\Delta P\), and opposed by resistance, \(R\):

F = \frac{\Delta P}{R}

Doubling the pressure difference doubles flow; doubling resistance halves it. Blood pressure is the hydrostatic pressure blood exerts on vessel walls, measured in millimetres of mercury (mmHg): the height in millimetres that the pressure would push a column of mercury. Pressure is highest in the aorta and falls along the circuit, most steeply across the arterioles, to near zero where the venae cavae enter the right atrium.

Systolic, diastolic and pulse pressure

Arterial pressure rises and falls with every beat. The peak, during ventricular ejection, is the systolic pressure; the lowest value, just before the next ejection, is the diastolic pressure. A reading such as 120/80 mmHg gives systolic over diastolic. The difference between them is the pulse pressure:

\mathrm{PP} = P_{\mathrm{sys}} - P_{\mathrm{dia}}

For 120/80 it is 40 mmHg. Pulse pressure is the surge you feel as a pulse at the wrist or neck. A persistently wide pulse pressure can reflect stiff arteries, which recoil poorly; a very narrow one can reflect a small stroke volume.

Mean arterial pressure

Because the heart spends longer in diastole than in systole at rest, average arterial pressure lies closer to diastolic than to systolic. A common estimate of mean arterial pressure (MAP) is

\mathrm{MAP} \approx P_{\mathrm{dia}} + \frac{\mathrm{PP}}{3}

MAP is the average pressure pushing blood into the tissues. In healthy adults it is usually somewhere around 70 to 110 mmHg; if it falls much below about 60 mmHg for long, organs such as the brain, heart and kidneys may not receive enough blood. The one-third rule works best at resting heart rates; at high rates systole fills more of each cycle and the estimate becomes rougher.

Worked example: pulse pressure and MAP

A resting reading is 120/80 mmHg. Find the pulse pressure and the estimated MAP. 1. Pulse pressure: \(120 - 80 = 40\) mmHg. 2. One third of it: \(40 \div 3 = 13.3\) mmHg. 3. MAP: \(80 + 13.3 = 93.3\) mmHg. 4. Check: the result must lie between diastolic and systolic, and closer to diastolic, because diastole lasts longer; 93.3 is 13.3 above 80 but 26.7 below 120, so it does. A simple average, 100 mmHg, would overestimate MAP.

Measuring blood pressure

Arterial pressure is usually measured over the brachial artery with a sphygmomanometer, an inflatable cuff with a pressure gauge, often automated today. In the manual method, the cuff is inflated until it closes the artery and then slowly deflated while a stethoscope is held over the artery below it. When cuff pressure drops just below systolic pressure, blood spurts through the narrowed artery with each beat, making tapping Korotkoff sounds; that pressure is read as systolic. As the cuff deflates further, the sounds fade and stop when flow becomes smooth again; that pressure is read as diastolic.

Blood pressure categories

The American Heart Association and American College of Cardiology (AHA/ACC) guideline of 2017, whose categories were kept in their 2025 update, classifies adult readings in mmHg approximately as follows. Normal: systolic below 120 and diastolic below 80. Elevated: systolic 120 to 129 and diastolic below 80. Stage 1 hypertension: systolic 130 to 139 or diastolic 80 to 89. Stage 2 hypertension: systolic 140 or higher, or diastolic 90 or higher. When the two numbers fall in different categories, the higher category applies. Other bodies, such as European societies, draw some lines differently. A category is assigned from repeated, properly taken measurements interpreted by a clinician, never from one reading, and these figures are for study only.

What sets resistance: Poiseuille's law

Resistance depends on blood viscosity, \(\eta\), vessel length, \(L\), and above all vessel radius, \(r\). For smooth flow in a tube, Poiseuille's law gives

R \propto \frac{\eta L}{r^4}

Thicker blood, as when the hematocrit is high, raises resistance; vessel length changes little in adults, except that added body tissue needs more vessels. Radius dominates because it enters to the fourth power: halving the radius multiplies resistance by \(2^4 = 16\). That is why small changes in arteriole diameter control flow so powerfully, and why narrowing by plaque matters so much.

Worked example: a narrowed arteriole

Smooth muscle narrows an arteriole so that its radius falls by 20%. If the pressure difference across it stays the same, how do resistance and flow change? 1. New radius: \(0.8r\). 2. By Poiseuille's law, resistance scales with \(1 \div r^4\), so the factor is \(1 \div 0.8^4 = 1 \div 0.4096 = 2.44\). 3. Resistance rises to 2.44 times its old value. 4. Flow is \(\Delta P \div R\), so it falls to \(0.4096\), about 41.0% of the original. 5. Check: a modest 20% narrowing cuts flow by more than half, consistent with the steep fourth-power rule.

Compliance and arteriosclerosis

Compliance is a vessel's ability to stretch as pressure rises. Healthy elastic arteries are compliant: they expand with each stroke volume and recoil in diastole. In arteriosclerosis, arteries stiffen and lose compliance, so each ejection meets more resistance and systolic and pulse pressures rise; the heart must work harder. The commonest form is atherosclerosis, in which plaques of lipids, cholesterol and immune cells build up in the tunica intima, narrowing the lumen. If a plaque ruptures, a clot may form on it and block the artery. Smoking, high LDL cholesterol, high blood pressure, diabetes and physical inactivity are established risk factors.

Getting blood back: low-pressure return

By the time blood reaches the venules, its pressure is only around 10 to 20 mmHg, and near the right atrium it is close to 0, so venous return needs help. Velocity also changes along the way: it is slowest in the capillaries, whose combined cross-sectional area is far larger than the aorta's, then rises again in veins. Three mechanisms aid return. In the skeletal muscle pump, contracting limb muscles squeeze deep veins, and valves let blood move only toward the heart. In the respiratory pump, breathing in lowers thoracic pressure and raises abdominal pressure, drawing blood upward. And venoconstriction stiffens vein walls.

Common mistakes to avoid

First, averaging systolic and diastolic to get MAP: diastole lasts longer, so use diastolic plus one third of pulse pressure. Second, treating radius as a simple proportion: resistance depends on the fourth power, so halving radius raises it sixteenfold. Third, confusing pressure with flow: flow depends on the pressure difference and resistance, not pressure alone. Fourth, assuming blood is fastest in capillaries because they are narrow: their total cross-section is the largest, so flow there is slowest. Fifth, labelling a person from a single reading.

Key takeaways

Flow equals pressure difference divided by resistance. Blood pressure is written systolic over diastolic; pulse pressure is their difference, and MAP is about diastolic plus a third of pulse pressure. Korotkoff sounds mark systolic and diastolic readings. AHA/ACC categories, kept in 2025: normal below 120/80, elevated 120-129/below 80, stage 1 130-139 or 80-89, stage 2 140 or 90 and above. Resistance rises with viscosity and length and falls with the fourth power of radius. Stiff arteries raise pressure, and muscle and respiratory pumps return venous blood.

Flashcards

Flashcard

F = ΔP / R

Flow equals pressure difference divided by resistance

Double R, halve the flow.

Test your understanding

Question 1 of 5

A resting blood pressure is 135/85 mmHg. What is the estimated mean arterial pressure?

Question 2 of 5

If an arteriole's radius doubles while everything else stays the same, what happens to its resistance?

Question 3 of 5

In a textbook exercise, the average of properly repeated readings is 132/78 mmHg. Which AHA/ACC category does that average fall into?

Question 4 of 5

During a manual blood pressure measurement, what does the first Korotkoff sound indicate?

Question 5 of 5

Why is blood flow slowest in the capillaries?

← Previous topicNext topic →