Anatomy & Physiology › Section I · Muscle tissue › Topic I.2

Fibre contraction and relaxation

Once calcium floods a muscle fibre, millions of tiny myosin heads start pulling on actin, each one powered by a molecule of ATP. This topic follows that pull from the switch that starts it to the pumps that end it, and asks where the fibre finds its ATP.

Picking up the signal

The topic Muscle tissues and skeletal muscle ended with an action potential racing down the T-tubules and calcium ions (Ca²⁺) pouring out of the sarcoplasmic reticulum (SR) into the sarcoplasm. That rise in Ca²⁺ is the trigger for contraction. As long as Ca²⁺ stays high and ATP is available, the fibre keeps generating force and, if the load allows, keeps shortening. When Ca²⁺ is pumped away, it relaxes. Everything in this topic happens inside the sarcomeres, the repeating units that line each myofibril.

The troponin-tropomyosin switch

Each thin filament is a twisted double strand of actin with binding sites for myosin. In a resting fibre those sites are covered by tropomyosin, a long protein strand lying along the actin. Tropomyosin is held in place by troponin, a small protein complex that also has a binding site for Ca²⁺. When Ca²⁺ binds troponin, troponin changes shape and drags tropomyosin away from the binding sites. Myosin heads can now attach to actin, forming cross-bridges. Remove the Ca²⁺ and tropomyosin slides back, covering the sites again.

The sliding filament model

During contraction, neither actin nor myosin gets shorter. Instead, myosin heads pull the thin filaments past the thick filaments towards the M line, so the Z discs at each end of the sarcomere move closer together. As the overlap grows, the I band and the H zone narrow, while the A band, set by the length of the thick filaments, stays the same width. Shorten every sarcomere in a myofibril and the whole fibre shortens. The model was proposed independently in 1954 by Andrew Huxley and Rolf Niedergerke and by Hugh Huxley and Jean Hanson.

The cross-bridge cycle

Each myosin head repeats four steps, much as an oar is pulled, lifted and swung forward. 1. Attachment: a cocked head, still holding ADP and phosphate (Pi), binds an exposed site on actin. 2. Power stroke: Pi is released, the head pivots towards the M line and drags the thin filament roughly 10 nm, and then ADP is released. 3. Detachment: a new ATP binds the head, which lets go of actin. 4. Re-cocking: myosin's own ATPase splits that ATP into ADP and Pi, and the released energy swings the head back into its high-energy position, ready to bind again further along.

Worked example: counting power strokes

A sarcomere shortens from 2.4 μm to 2.0 μm. If each power stroke moves a thin filament about 10 nm, how many cycles must the heads acting on one thin filament complete, at the least? 1. The sarcomere shortens by 0.4 μm in total. 2. Both halves shorten equally, because thin filaments at each end are pulled towards the centre, so each thin filament slides 0.2 μm, which is 200 nm. 3. Cycles: 200 nm ÷ 10 nm = 20. 4. Each cycle uses one ATP per head, so a single shortening uses ATP many times over. 5. Check: thousands of sarcomeres and heads work at once, which is why active muscle consumes ATP so fast.

Relaxation, and rigor mortis

Relaxation begins when the motor neuron stops releasing acetylcholine. Acetylcholinesterase clears the cleft, the sarcolemma and T-tubules repolarise, and the SR's release channels close. ATP-driven pumps in the SR membrane then move Ca²⁺ back into storage. With Ca²⁺ gone from troponin, tropomyosin covers the binding sites, cross-bridges stop forming and tension falls. So ATP is needed for both detachment and calcium pumping. After death, ATP production stops and the heads stay locked to actin, producing the stiffness called rigor mortis, which fades over the following days as the proteins break down.

Where ATP comes from

A fibre stores only enough ATP for a few seconds of hard work, so it must regenerate ATP continuously. First, creatine phosphate hands its phosphate to ADP, a fast reaction catalysed by creatine kinase that covers roughly the first 10 to 15 seconds of maximal effort. Next, anaerobic glycolysis splits glucose, from the blood or from stored glycogen, into two pyruvate, for a net gain of 2 ATP. When oxygen supply cannot keep up, pyruvate is converted to lactate, which regenerates the NAD⁺ glycolysis needs. Aerobic respiration in mitochondria is slower but far more productive, making about 30 to 32 ATP per glucose and also burning fatty acids. It supplies most ATP at rest and in moderate activity.

Worked example: two routes to 300 ATP

A group of fibres needs 300 ATP. How many glucose molecules must it use by anaerobic glycolysis alone, and how many by aerobic respiration? 1. Anaerobic glycolysis gives a net 2 ATP per glucose: 300 ÷ 2 = 150 glucose. 2. Aerobic respiration gives about 30 to 32 ATP per glucose: 300 ÷ 30 = 10, and 300 ÷ 32 ≈ 9.4, so about 9 to 10 glucose. 3. Ratio: aerobic respiration extracts about 15 to 16 times as much ATP from each glucose. 4. Check: older books quote 36 to 38 ATP; current estimates are lower because making and exporting each ATP costs more protons than once assumed.

Fatigue and recovery

Fatigue is a fall in a muscle's ability to produce force during sustained use. Its causes are still debated and differ with the type of activity. Proposed factors include accumulating phosphate and hydrogen ions, falling glycogen, and ion imbalances that disrupt Ca²⁺ release from the SR. Lactate itself is no longer seen as the main culprit; it is a fuel that the heart, other muscle fibres and the liver can use. After hard exercise, oxygen use stays raised while the body restores ATP and creatine phosphate, reoxygenates myoglobin and clears lactate. This was once called the oxygen debt; physiologists now call it excess post-exercise oxygen consumption (EPOC).

Duchenne muscular dystrophy

The protein dystrophin anchors the fibre's internal framework, and so its thin filaments, to the sarcolemma. In Duchenne muscular dystrophy (DMD), an inherited condition, a mutation in the dystrophin gene on the X chromosome means little or no dystrophin is made. Without it, the sarcolemma tears during contraction, Ca²⁺ leaks in and the fibres are gradually destroyed. Because the gene is on the X chromosome, DMD mainly affects males, usually showing in early childhood as difficulty with balance and walking. Weakness progresses and eventually affects breathing muscles. Modern care has extended survival, but life expectancy remains shortened.

Common mistakes to avoid

First, saying the filaments shorten: they slide, and only the sarcomere shortens. Second, saying the A band narrows: it stays constant, while the I band and H zone narrow. Third, thinking ATP powers the attachment: ATP binding causes detachment, and its hydrolysis re-cocks the head. Fourth, assuming relaxation is passive: pumping Ca²⁺ back into the SR needs ATP. Fifth, blaming lactate for fatigue or using 36 ATP per glucose without noting that current estimates are about 30 to 32.

Key takeaways

Ca²⁺ binds troponin, which moves tropomyosin off actin's binding sites so myosin can form cross-bridges. In the cross-bridge cycle, heads attach, perform a power stroke of about 10 nm towards the M line, detach when ATP binds, and re-cock when it is hydrolysed. Thin filaments slide; the Z discs approach and the I band and H zone narrow. Relaxation requires ATP-driven Ca²⁺ pumps, and without ATP the heads lock in rigor. ATP comes from creatine phosphate, then glycolysis (net 2 per glucose), then aerobic respiration (about 30 to 32 per glucose).

Flashcards

Flashcard

Tropomyosin

Protein strand that covers myosin-binding sites on actin at rest

Held in place by troponin.

Test your understanding

Question 1 of 5

In a skeletal muscle fibre, which protein binds Ca²⁺ to start contraction?

Question 2 of 5

As a sarcomere contracts, which of these stays the same width?

Question 3 of 5

Which step of the cross-bridge cycle is caused by ATP binding to the myosin head?

Question 4 of 5

Fibres working without enough oxygen need 600 ATP from anaerobic glycolysis alone. How many glucose molecules must they break down?

Question 5 of 5

Why do muscles become rigid in rigor mortis?

← Previous topicNext topic →