Biology › Section L · Plant form and physiology › Topic L.4

Transport of water and solutes

A plant moves water a hundred metres upward with no pump in sight, then ships sugars wherever they are needed - all by managing one number: water potential.

Two pipelines, one currency

Xylem carries water and dissolved minerals upward from root to leaf; phloem carries the sugars of photosynthesis to wherever growth or storage demands them. The two tissues are physically separate, so both cargoes can move at once. What unifies them is water potential, written psi: the difference in potential energy between the water in a sample and pure water, measured in megapascals, with pure water defined as zero. Water always flows from higher potential to lower and keeps flowing until the difference is erased.

Four parts that sum to one gradient

Total water potential is the sum of four components: solute potential, pressure potential, gravity potential, and matric potential. Change any one and the total shifts, and water redistributes. For water to travel from soil to air, the totals must form a falling staircase: soil above root, root above stem, stem above leaf, leaf above atmosphere. Water responds only to differences in the totals, not to individual components - but because solutes and pressure are adjustable, the plant retains real control over the staircase.

Solute and pressure: the adjustable pair

Solute potential is always zero or negative - dissolving solutes ties up water's energy in hydrogen bonds - and cytoplasm typically sits at -0.5 to -1.0 MPa. It is a dial the plant turns: pumping solutes into a cell lowers its potential and pulls water in by osmosis. Pressure potential, also called turgor, is the cell wall's pushback against the water inside, and it can be positive or negative. Well-watered cells run 0.6 to 0.8 MPa and can reach 1.5 MPa - over 200 pounds per square inch, several times a car tyre. When a leaf loses water and pressure potential nears zero, it wilts; watering reverses the arithmetic.

Gravity and matric: the fixed pair

The other two components are fixed. Gravity potential is always negative or zero, consuming about 0.1 MPa per ten metres of height - negligible for a fern, but roughly an extra 1 MPa for the leaves of the tallest redwoods. Matric potential comes from water binding to dry, water-loving surfaces such as the cellulose of cell walls and the starch of a seed, which can hold water at potentials as low as -2 MPa. Once a seed or soil is fully wetted, matric potential goes to zero, so a well-watered plant usually ignores it.

Pull, don't pump: transpiration and cohesion-tension

The main engine of xylem transport is transpiration - evaporation at the leaf surface - which creates a negative pressure, or tension, of around -2 MPa at the leaf surface (stronger in dry air, weaker in humid air). Inside the leaf, water evaporates from the wet walls of mesophyll cells into internal air spaces, and the shrinking film drags tension into the xylem, pulling on the whole connected column. The column survives because water molecules cohere with each other and adhere to xylem walls - the cohesion-tension theory of sap ascent - and at night, when stomata shut, the same forces hold it in place. The lift is passive: no ATP. The price is vulnerability: gas bubbles form under tension (cavitation) and break the stream into an embolism that can plug a vessel. Rings keep vessels from collapsing, and small perforations between vessel elements limit bubble size.

Guard cells and water-wise lifestyles

Up to 90 percent of the water a root absorbs is lost through open stomata - the same pores carbon dioxide must enter for photosynthesis. The waxy cuticle seals the rest of the surface, so the stomata are the main valve, and two guard cells flank each pore, opening and closing in response to light intensity and quality, the leaf's water status, and carbon dioxide levels. Habitat tunes this trade: xerophytes and epiphytes, with scarce water, grow thick cuticles, sunken stomata or dense trichomes, while a prickly pear's leaves are spines and its water-storing stem photosynthesises. Mesophytes take the middle road, and aquatic hydrophytes barely struggle with water loss.

Sources and sinks

The phloem cargo is photosynthate - mostly sucrose - from photosynthesising tissues. Any structure producing more sugar than it uses is a source; any structure burning or storing it is a sink: roots, young shoots, fruits and seeds, and storage organs (a tuber or bulb can be either, depending on season). Each source usually feeds its nearest sink - the highest leaves ship up to the shoot tip, the lowest ship down to the roots, and middle leaves ship both ways at once. That makes phloem multidirectional, unlike the one-way xylem, and the destinations shift with age: early growth feeds roots, vegetative growth feeds shoots, reproduction pours sugar into seeds, fruits, and tubers.

Translocation by pressure flow

Sucrose made in mesophyll reaches the phloem through cytoplasmic channels called plasmodesmata, then is loaded into sieve-tube elements (cells with reduced cytoplasm, joined end to end by sieve plates) against its concentration gradient - ATP spent to build a proton gradient that a sucrose-H-plus symporter exploits, with companion cells handling the metabolic work. Loading moves everything: the sap reaches up to 30 percent sugar, its water potential plunges, water floods in from the xylem by osmosis, and the rising pressure drives bulk flow toward a sink. There the sucrose is unloaded for growth or converted to starch, water returns to the xylem, and the pressure difference collapses.

Worked example: the houseplant that rises again

A pothos slumps flat by afternoon, and an hour after watering it stands crisp again. Follow the potentials. As the soil dried, its water potential fell until roots could no longer replace what transpiration removed; water left the leaf cells and their pressure potential slid toward zero, so the cells went slack. Watering raises the soil's potential well above the root's, so water crosses root membranes, climbs the xylem, and refills leaf cells, where rigid walls convert it back into turgor. No new machinery: the same arithmetic runs in the favourable direction.

Worked example: which way does the water go?

Suppose a leaf's total water potential measures -1.0 MPa while its petiole reads -0.7 MPa, and a root cell holds solute potential -0.8 MPa with pressure potential +0.3 MPa. First: which way does water move between petiole and leaf? From higher to lower - petiole into leaf, feeding transpiration. Second: what is the root cell's total? Add the components: -0.8 plus +0.3 equals -0.5 MPa, and if the surrounding soil water sits at -0.2 MPa, the difference drives water inward. You never need to know which component created a potential - the totals alone decide the direction.

Common mistakes to avoid

First, thinking plants pump water up the xylem - the lift comes from transpiration's pull plus cohesion and adhesion, entirely passive. Second, saying water moves toward higher solute concentration - it moves toward lower total water potential, which pressure can complicate. Third, treating gravity and matric potential as adjustable - a plant can change neither, and matric potential vanishes in wet tissue. Fourth, calling stomata permanently open - guard cells open and close them against water loss. Fifth, giving phloem a single direction - each source feeds its nearest sink, so flow runs several ways at once. Sixth, forgetting the ATP bill - loading sugar costs energy; the pressure-driven flow afterward does not.

Key takeaways

Xylem lifts water passively; phloem distributes sucrose under pressure. Both obey water potential - the megapascal-scaled difference from pure water, always sending water from higher to lower - which sums four components: solute and pressure, adjustable by the plant, and gravity and matric, which are not. Transpiration generates around -2 MPa of tension, cohesion-tension explains the column's survival, cavitation and embolism are the failures, and guard cells gate the water-for-carbon trade. In the phloem, symporter loading at a source draws in water, and pressure flow carries the sap to sinks.

Flashcards

Flashcard

water potential

The difference in potential energy between water in a sample and pure water, in megapascals.

Pure water is defined as zero; water always flows from higher water potential to lower, which drives every movement through the plant.

Test your understanding

Question 1 of 5

Water moves between two plant compartments under which condition?

Question 2 of 5

A well-watered plant's leaves suddenly wilt in the afternoon sun. What has happened to the pressure potential of its leaf cells?

Question 3 of 5

What is the main driver of water movement upward through the xylem?

Question 4 of 5

Sucrose is actively loaded into a sieve-tube element at a source. What happens next?

Question 5 of 5

How does phloem transport differ from xylem transport in its pattern of flow?

← Previous topicNext topic →