Physics › Section V · Nuclear physics and its applications › Topic V.1

Nuclear radioactivity and its detection

Some atoms give off energetic radiation all by themselves, with no fuel and no switch. Learning what that radiation is, how far it travels and how instruments catch it is the entry point to all of nuclear physics.

A discovery by accident

In 1896 Henri Becquerel found that uranium salts darkened a photographic plate wrapped in black paper, even in a drawer with no light. The effect was the same whether the uranium was a pure metal or locked in a compound, hot or cold. Anything that depends on electrons, such as chemical bonding or temperature, made no difference, so the rays had to come from the nucleus. Marie and Pierre Curie then discovered two far more active elements, polonium and radium, and Marie Curie named the effect radioactivity. Each emission carries an energy of order 1 MeV, about a million times the few electronvolts involved in a chemical reaction.

Three kinds of radiation

Ernest Rutherford sorted the rays by how easily they were stopped, naming them alpha (α) and beta (β); Paul Villard found a third, far more penetrating kind in 1900, which Rutherford later named gamma (γ). A magnetic field separates them. Alpha particles curve one way, so they are positive; beta particles curve the other way, so they are negative; gamma rays go straight, so they carry no charge. Later work identified each one. An alpha particle is a helium-4 nucleus, two protons and two neutrons, with charge \(+2e\). A beta particle is an electron created in the nucleus at the moment of decay, not one taken from the electron cloud. A gamma ray is a high-energy photon from a nucleus dropping to a lower energy state.

Ionising radiation

All three kinds carry enough energy to knock electrons out of atoms and molecules, which is called ionisation. Any radiation that does this, nuclear or not (X-rays and high-energy ultraviolet light included), is called ionising radiation. In air, an alpha particle loses on average about 35 eV for every ion pair it makes, more than twice the ionisation energy of nitrogen or oxygen molecules (about 12 to 16 eV), because much of the energy goes into exciting molecules without ionising them. Ionisation is both the harm and the clue: it breaks molecules in cells, and nearly every detector senses the ions and electrons it leaves.

Range: why alpha stops first

The range of radiation is how far it travels through a material before losing its energy. At equal energy, alpha has the shortest range, beta goes further, and gamma goes furthest. Two factors explain the order. Charge: an alpha particle has twice the charge of a beta particle, so it pulls harder on the electrons it passes, and a gamma ray has no charge at all. Speed: an alpha particle is about 7300 times as massive as an electron, so at the same energy it moves far more slowly and spends longer near each atom, giving it more chances to ionise. Denser materials, with more electrons per cubic metre, shorten the range of all three.

Typical ranges and shielding

A typical alpha particle from a radioactive source is stopped by a sheet of paper, a few centimetres of air or the dead outer layer of skin. A beta particle travels up to a few metres in air and is stopped by a few millimetres of aluminium. Gamma rays have no definite range. Each layer of a given thickness removes the same fraction of the photons that reach it, so the beam shrinks layer by layer but never quite reaches zero. The thickness that removes half is the half-value thickness. Gamma shielding therefore uses centimetres of lead or metres of concrete, enough to cut the intensity to a safe level.

Worked example: an alpha particle in a magnetic field

An alpha particle of mass \(6.645 \times 10^{-27}\) kg and kinetic energy 5.30 MeV enters a uniform 1.00 T field at right angles. Find its speed and the radius of its path. 1. Convert the energy:

K = (5.30 \times 10^6)(1.602 \times 10^{-19}) = 8.49 \times 10^{-13}\ \mathrm{J}

2. The speed is small compared with c, so use \(K = \tfrac{1}{2}mv^2\):

v = \sqrt{\frac{2K}{m}} = \sqrt{\frac{2(8.49 \times 10^{-13})}{6.645 \times 10^{-27}}} = 1.60 \times 10^7\ \mathrm{m/s}

3. The magnetic force provides the centripetal force, so \(r = \frac{mv}{qB}\) with \(q = 2e\):

r = \frac{(6.645 \times 10^{-27})(1.60 \times 10^7)}{(3.204 \times 10^{-19})(1.00)} = 0.332\ \mathrm{m}

4. Check: \(v\) is about 5% of \(3.00 \times 10^8\) m/s, so the classical formula was fair.

Detectors: film, Geiger tubes and ionisation

Photographic film, the first detector, long served in personal film badges. The most familiar instrument is the Geiger tube: a metal cylinder filled with low-pressure gas, with a thin wire along its axis held a few hundred volts positive. Radiation that ionises the gas frees electrons, which race towards the wire, gaining enough energy to ionise more atoms on the way. This avalanche gives a pulse of current, heard as a click and recorded as one count. Every pulse is about the same size whatever started it, so a Geiger counter reports how often radiation arrives, not its energy or type.

Scintillators and solid-state detectors

A scintillator is a crystal, plastic or liquid that gives off a brief flash of light when radiation deposits energy in it; sodium iodide crystals are a common choice for gamma rays. The flash is turned into an electric pulse by a photomultiplier tube. Light frees an electron from a photocathode by the photoelectric effect, and the electron is accelerated onto a series of electrodes called dynodes, each releasing several electrons for every one that hits it. The pulse size stays proportional to the energy deposited, so a scintillator measures energy as well as counting. Solid-state detectors, made of silicon or germanium, turn ionisation directly into a current and give even sharper energy measurements.

Worked example: counting with a photomultiplier

A photomultiplier has 10 dynodes, and each releases on average 4 electrons for every electron that strikes it. If one photoelectron leaves the photocathode, how many electrons reach the output? 1. After the first dynode there are 4 electrons; after the second, \(4 \times 4 = 16\). 2. Each stage multiplies by 4 again, so after 10 stages the number is \(4^{10}\). 3. \(4^{10} = 1{,}048{,}576\), about \(1.0 \times 10^6\) electrons. 4. Check: a pulse of about \(1.7 \times 10^{-13}\) C is easy for ordinary electronics to register, while a single electron is not. The gain is a power, not a product: \(10 \times 4 = 40\) would badly underestimate it.

Common mistakes to avoid

First, thinking a beta particle is an orbital electron knocked out of the atom; it is created in the nucleus. Second, mixing up the order of range: the most strongly ionising radiation, alpha, has the shortest range. Third, giving gamma rays a fixed range; each layer removes a fraction, so two half-value thicknesses leave one quarter, not zero. Fourth, expecting a Geiger counter to identify the radiation or its energy; it only counts. Fifth, leaving energies in MeV inside \(K = \tfrac{1}{2}mv^2\); convert to joules first, using \(1\ \mathrm{eV} = 1.602 \times 10^{-19}\) J.

Key takeaways

Radioactivity is the spontaneous emission of radiation from unstable nuclei, unaffected by chemistry or temperature. Alpha particles are helium-4 nuclei (+2e), beta particles are electrons made in the nucleus (−e), and gamma rays are uncharged photons. All three ionise. At equal energy, alpha has the shortest range and gamma the longest, because of charge and speed; gamma rays are reduced by a fixed fraction per layer. Geiger tubes count events through gas avalanches; scintillators with photomultipliers, and solid-state detectors, also measure energy.

Flashcards

Flashcard

Radioactivity

Spontaneous emission of radiation by unstable nuclei

Discovered by Becquerel in 1896 with uranium.

Test your understanding

Question 1 of 5

A narrow beam containing alpha, beta and gamma radiation passes at right angles through a magnetic field. What happens?

Question 2 of 5

An alpha particle (mass 6.645 × 10⁻²⁷ kg) has a kinetic energy of 4.00 MeV. What is its speed?

Question 3 of 5

A lead absorber has a half-value thickness of 1.5 cm for certain gamma rays. What fraction of the gamma rays gets through 4.5 cm of this lead?

Question 4 of 5

Which information does a simple Geiger counter provide?

Question 5 of 5

A photomultiplier has 8 dynodes, and each releases 5 electrons for every electron that strikes it. How many electrons reach the output for one photoelectron?

← Previous topicNext topic →