Physics › Section U · Quantum and atomic physics › Topic U.6
X rays and uses of atomic excitations
Knock an inner electron out of a heavy atom and it answers with an X-ray; excite outer electrons in the right way and they answer with fluorescent colours or laser light. Hospital scanners, crystal structures, highlighter pens and supermarket barcode readers all rest on the same energy levels.
A ray that sees through skin
In 1895 Wilhelm Röntgen noticed a screen glowing near a cathode-ray tube covered in black card. The tube was giving off an unknown, penetrating radiation, which he called X rays. Within weeks he had photographed the bones in his wife's hand, and in 1901 he received the first Nobel Prize in Physics. X rays are electromagnetic radiation with wavelengths of roughly 0.01 to 10 nm, so each photon carries about 0.1 to 100 keV.
How an X-ray tube works
In an X-ray tube, electrons boil off a hot filament, are accelerated through a potential difference \(V\) of tens of kilovolts, and slam into a metal target, the anode, often tungsten. Most of their energy heats the anode; a small fraction becomes X rays in two ways. First, an electron swerving and slowing near a nucleus radiates, because accelerated charges emit electromagnetic waves. This braking radiation, called bremsstrahlung, forms a smooth, continuous spectrum. Second, an incoming electron can knock an inner electron out of an anode atom, and the atom then emits a characteristic X-ray. These appear as sharp peaks on top of the continuous spectrum.
The short-wavelength cutoff
Each electron arrives with kinetic energy \(eV\). Usually it loses that energy in many collisions, but at most it can put all of it into a single photon. That photon has the highest possible energy and so the shortest wavelength, set by \(eV = hc/\lambda_{\min}\):
No X rays have shorter wavelengths, so the bremsstrahlung spectrum stops sharply there. With the voltage in volts, the maximum photon energy in eV has the same number: a 100 kV tube makes photons of up to 100 keV. The cutoff depends only on the voltage, not on the anode metal. Raising the voltage makes more penetrating X rays.
Worked example: a medical X-ray tube
A tube runs at 80.0 kV. Find the maximum photon energy and the cutoff wavelength, and say what happens if the voltage is doubled. 1. Each electron gains \(eV = 80.0\) keV, so the maximum photon energy is 80.0 keV. 2. Cutoff: \(\lambda_{\min} = hc/(eV)\), and with \(hc = 1240\ \text{eV}\cdot\text{nm}\),
3. Doubling to 160 kV doubles the maximum energy to 160 keV and halves the cutoff to 0.00775 nm. 4. Check: 0.0155 nm is well inside the X-ray range, and a higher voltage giving a shorter wavelength makes sense.
Characteristic X rays
In a heavy atom the inner electrons are bound very tightly. The shells are labelled K (n = 1), L (n = 2), M (n = 3) and so on. If a fast electron ejects a K-shell electron, an electron from a higher shell drops into the vacancy and the atom emits a photon carrying the energy difference. An L-to-K drop gives the Kα line and an M-to-K drop the more energetic Kβ line; drops into an L-shell vacancy give L lines. Because these energies depend on the element, the lines identify it. In 1913 Henry Moseley showed that the Kα energy rises roughly as \((Z - 1)^2\), which proved that the periodic table should be ordered by atomic number Z.
Worked example: copper's Kα line
Estimate the energy and wavelength of the Kα X-ray of copper, Z = 29. 1. Model: an L electron falls into a K vacancy. The one remaining K electron shields one unit of nuclear charge, so treat the falling electron as being in a hydrogen-like atom with effective charge Z − 1 = 28. 2. Use the Bohr energies, \(E_n = -13.6(Z-1)^2/n^2\) eV, for a drop from n = 2 to n = 1:
3. Wavelength: \(\lambda = 1240/8000\), about 0.155 nm. 4. Check: the measured line is 8.05 keV at 0.154 nm, so this rough model works within 1%.
X rays at work
Dense materials containing heavier atoms, such as the calcium in bone, absorb X rays more strongly than soft tissue, so they cast shadows on a detector. Because X-ray photons can ionise atoms, doses are kept as low as possible. A computed tomography (CT) scanner sends beams through the body from many directions, and a computer builds cross-sectional images; Godfrey Hounsfield and Allan Cormack shared the 1979 Nobel Prize in Medicine for it. X-ray wavelengths match the spacing of atoms in crystals, so X rays diffract from them. This X-ray crystallography revealed the structures of proteins and, through Rosalind Franklin's images, DNA.
Fluorescence and phosphorescence
An excited atom or molecule usually drops back in about \(10^{-8}\) s. If it returns in several smaller steps, it emits photons of lower energy, and so longer wavelength, than the one it absorbed. This is fluorescence: ultraviolet light in, visible light out. It makes highlighter ink and some minerals glow under an ultraviolet lamp, and coatings called phosphors in fluorescent tubes and white LEDs turn ultraviolet or blue light into other colours. Some excited states are metastable: they last far longer, from milliseconds to hours. A material that keeps glowing after the light is removed, such as glow-in-the-dark paint, is phosphorescent.
Lasers
In 1917 Einstein showed that a photon whose energy matches a transition can stimulate an excited atom to emit an identical photon, with the same energy, direction and phase. Normally most atoms are in lower states, so photons are absorbed more often than they stimulate emission. A laser pumps energy in, electrically or with light, until a metastable level holds more atoms than a lower level, a population inversion. Then each photon triggers others in a chain. Mirrors at the two ends send light back and forth to build it up, and one partly transparent mirror lets the beam out. The word laser abbreviates light amplification by stimulated emission of radiation, and the light is monochromatic, coherent and highly directional.
Worked example: the helium-neon laser
In a helium-neon laser, a discharge excites helium atoms, which pass their energy to neon atoms in collisions, raising them to a long-lived level at 20.66 eV above the ground state, and the lasing transition takes them down to a level at 18.70 eV. Find the wavelength of the laser light. 1. Photon energy: \(\Delta E = 20.66 - 18.70 = 1.96\) eV. 2. Wavelength: \(\lambda = hc/\Delta E = 1240/1.96\), which is 633 nm. 3. Interpret: 633 nm is red light, the familiar colour of these lasers. 4. Check: the photon carries under a tenth of the 20.66 eV pumped in, because both levels lie high above the ground state.
Common mistakes to avoid
First, putting the voltage in kilovolts into \(\lambda_{\min} = hc/(eV)\); with \(hc = 1240\ \text{eV}\cdot\text{nm}\), the energy must be in eV. Second, thinking the cutoff depends on the anode metal; it depends only on the voltage. Third, confusing the two parts of the spectrum: bremsstrahlung is continuous, characteristic lines are sharp peaks that depend on the element. Fourth, mixing up Kα and Kβ. Fifth, expecting fluorescence to emit a shorter wavelength than it absorbs; energy is lost, so the emitted light is redder. Sixth, thinking a laser works without a population inversion.
Key takeaways
An X-ray tube gives bremsstrahlung, a continuous spectrum from decelerating electrons, and characteristic lines from refilled inner-shell gaps. The bremsstrahlung cutoff is λ_min = hc/(eV), set only by the accelerating voltage. Kα (L to K) and Kβ (M to K) energies identify the element and rise roughly as (Z − 1)². X rays image bones, build CT scans and reveal crystal structures. Fluorescence re-emits absorbed energy as lower-energy light; phosphorescence uses long-lived metastable states. Lasers use stimulated emission from a population inversion to produce monochromatic, coherent, directional light.
Flashcards
Flashcard
Electromagnetic radiation of roughly 0.01 to 10 nm
Test your understanding
Question 1 of 5
An X-ray tube operates at 50.0 kV. What is the shortest wavelength in its spectrum? Use hc = 1240 eV·nm.
Question 2 of 5
The tungsten anode of an X-ray tube is replaced with a copper one, and the voltage is unchanged. What happens to the spectrum?
Question 3 of 5
What produces a Kα X-ray?
Question 4 of 5
A mineral absorbs ultraviolet light and glows green. Why is the emitted light at a longer wavelength than the absorbed light?
Question 5 of 5
Why does a laser need a population inversion?
