Magnetic forces and induction
Moving charges create magnetic fields and feel magnetic forces. Changing magnetic fields create electric currents, the principle behind generators and transformers.
Magnetic fields
Magnetic fields are produced by moving charges, including currents in wires and the spinning and orbiting electrons in magnets. The SI unit is the tesla (T). Earth's field at the surface is roughly 25 to 65 microtesla, a fridge magnet a few millitesla, and a hospital MRI scanner around 1.5 to 3 T. Field lines run from north to south poles outside a magnet.
Currents make fields
In 1820, Hans Christian Oersted noticed that a current-carrying wire deflected a compass needle, the first link between electricity and magnetism. A long straight wire creates circular field lines with \(B = \mu_0 I / (2\pi r)\), where \(\mu_0 = 4\pi \times 10^{-7}\) T·m/A. A 10 A current produces 40 microtesla at 5.0 cm, comparable to Earth's field.
Force on a moving charge
A charge moving through a magnetic field feels \(F = qvB\sin\theta\), perpendicular to both its velocity and the field, given by a right-hand rule. Because the force is perpendicular to motion, it does no work and changes only direction, making charges circle with radius \(r = mv/(qB)\). Mass spectrometers and particle accelerators use this.
Force on a wire
A current-carrying wire in a field feels \(F = ILB\sin\theta\). This force drives electric motors, where current loops in a magnetic field experience torques that make them spin, and loudspeakers, where a coil pushes a cone back and forth. Earth's magnetic field also steers charged particles from the Sun towards the poles, producing auroras.
Faraday's discovery
In 1831, Michael Faraday discovered electromagnetic induction: a changing magnetic flux through a circuit induces a voltage. Magnetic flux is \(\Phi = BA\cos\theta\), in webers. Faraday's law gives the induced emf \(\varepsilon = -N\Delta\Phi/\Delta t\) for a coil of N turns. Moving a magnet into a coil, or changing a nearby current, produces a current.
Lenz's law
Lenz's law, the minus sign in Faraday's law, states that the induced current flows so as to oppose the change in flux that caused it. Drop a magnet through a copper tube and induced currents slow its fall dramatically. Magnetic braking on trains and roller coasters uses this effect, producing smooth braking without contact.
Generators and transformers
Generators spin coils in magnetic fields, continually changing the flux and producing alternating current, which supplies most of the world's electricity. Transformers change AC voltages using two coils on a shared iron core: \(V_s/V_p = N_s/N_p\). Stepping 120 V down to 12 V needs ten times fewer turns on the secondary coil. Power lines use high voltages to reduce energy loss.
Worked example
A coil of 100 turns and area 0.010 m² sits perpendicular to a magnetic field that grows steadily from 0 to 0.20 T in 0.10 s. The flux through each turn changes by 0.20 x 0.010 = 0.0020 Wb, so the induced emf is 100 x 0.0020 / 0.10 = 2.0 V. The induced current flows to create a field opposing the increase, as Lenz's law requires.
Key takeaways
Magnetic fields come from moving charges and are measured in tesla; Earth's is about 25 to 65 microtesla. Oersted (1820) showed currents create fields; a long wire gives mu0 I over 2 pi r. Moving charges feel qvB sin theta, perpendicular to motion, so they circle; current-carrying wires feel ILB sin theta, which runs motors. Faraday (1831) found that changing flux induces emf, N times the rate of change of flux. Lenz's law says induced currents oppose the change, enabling magnetic braking. Generators produce AC, and transformers change voltages in proportion to turns.
Flashcard
SI unit of magnetic field
Check your understanding
Why does a magnetic force on a moving charge do no work?
