Resistance, capacitance, and RC
Circuits move charge to do useful work. Resistors control current, capacitors store charge, and together they set the timing of many devices.
Current
Electric current is the rate of flow of charge, \(I = \Delta Q / \Delta t\), measured in amperes (A), where 1 A is 1 C/s. By convention, current flows from positive to negative terminals, although in metal wires the moving charges are electrons drifting the other way. The drift speed is slow, often below a millimetre per second, but the signal travels almost at light speed.
Ohm's law and resistance
For many materials, current is proportional to voltage: \(V = IR\), Ohm's law, published by Georg Ohm in 1827. Resistance R is measured in ohms. A wire's resistance is \(R = \rho L / A\): longer, thinner wires resist more, and resistivity \(\rho\) depends on the material, being low for copper and very high for rubber.
Electric power
The power delivered to a circuit element is \(P = IV\), which for a resistor also equals \(I^2R\) and \(V^2/R\). A 60 W bulb on a 120 V supply draws 0.50 A. Electric heaters and toasters deliberately use resistance to turn electrical energy into heat.
Series and parallel
Resistors in series carry the same current, and their resistances add: \(R = R_1 + R_2\). Resistors in parallel share the same voltage, and \(1/R = 1/R_1 + 1/R_2\), so the total is less than the smallest. A 6.0 ohm and a 3.0 ohm resistor give 9.0 ohms in series but only 2.0 ohms in parallel. Household outlets are wired in parallel so each device gets the full voltage.
Kirchhoff's rules
Gustav Kirchhoff's rules (1845) analyse any circuit. The junction rule says the current entering a junction equals the current leaving, a consequence of charge conservation. The loop rule says the voltage changes around any closed loop sum to zero, a consequence of energy conservation.
Capacitors
A capacitor stores charge on two conductors separated by an insulator. Capacitance is \(C = Q/V\), measured in farads. For parallel plates, \(C = \varepsilon_0 A / d\), so larger, closer plates store more. The stored energy is \(\tfrac{1}{2}CV^2\); camera flashes and defibrillators release capacitor energy quickly.
RC circuits
When a capacitor charges through a resistor, the voltage rises quickly at first and then levels off. The time constant \(\tau = RC\) sets the pace: after one time constant, the capacitor reaches about 63% of its final voltage, and after five, over 99%. A 10 kilohm resistor with a 100 microfarad capacitor gives \(\tau\) = 1.0 s. RC circuits time blinking lights and filter signals.
Worked example
A 12 V battery drives current through 6.0 ohm and 3.0 ohm resistors in series. The total resistance is 9.0 ohms, so the current is 12/9.0, about 1.3 A, and the battery supplies 12 x 1.33, about 16 W. If the resistors are instead connected in parallel, the total is 2.0 ohms, the battery delivers 6.0 A, and the power rises to 72 W.
Key takeaways
Current is charge per second, in amperes. Ohm's law, V = IR (1827), relates voltage, current, and resistance; resistance grows with length and falls with cross-sectional area. Power is IV, also I squared R and V squared over R. Series resistances add; parallel resistances combine as reciprocals, giving less than the smallest. Kirchhoff's junction and loop rules come from charge and energy conservation. Capacitance is Q over V, stored energy half C V squared. An RC circuit's time constant RC is the time to reach about 63% of the final charge.
Flashcard
Charge per unit time
Check your understanding
What is the combined resistance of a 6.0 ohm and a 3.0 ohm resistor connected in parallel?
