← Back to Physics

Angular variables and inertia

Spinning wheels, planets, and figure skaters all rotate. Rotation has its own versions of position, velocity, acceleration, and mass.

Angles in radians

Rotation is measured in radians: an angle in radians is arc length divided by radius, \(\theta = s/r\). One full turn is \(2\pi\) radians, about 6.28, so 1 rad is about 57.3°. Radians make the equations linking rotation and linear motion simple.

Angular velocity and acceleration

Angular velocity is the rate of change of angle, \(\omega = \Delta\theta/\Delta t\), in rad/s. Angular acceleration is \(\alpha = \Delta\omega/\Delta t\), in rad/s². A motor at 3000 revolutions per minute turns at \(3000 \times 2\pi / 60 \approx 314\) rad/s.

Linking rotation and linear motion

A point at radius r on a rotating object moves with tangential speed \(v = \omega r\) and has tangential acceleration \(a_t = \alpha r\). Every point shares the same angular velocity, but outer points move faster: on a spinning record, the outer edge travels much faster than points near the centre.

Rotational kinematics

For constant angular acceleration, the kinematics equations carry over with \(\theta\) for x, \(\omega\) for v, and \(\alpha\) for a: \(\omega = \omega_0 + \alpha t\), \(\theta = \omega_0 t + \tfrac{1}{2}\alpha t^2\), and \(\omega^2 = \omega_0^2 + 2\alpha\theta\). A wheel speeding up from rest at 2.0 rad/s² reaches 10 rad/s in 5.0 s.

Moment of inertia

The rotational version of mass is the moment of inertia, \(I = \sum mr^2\), measured in kg·m². It depends on both mass and how far the mass is from the axis. Mass far from the axis contributes much more, because of the r squared factor.

Common shapes

For mass M and radius R: a thin hoop about its centre has \(I = MR^2\); a solid disk or cylinder \(\tfrac{1}{2}MR^2\); a solid sphere \(\tfrac{2}{5}MR^2\). A thin rod of length L has \(\tfrac{1}{12}ML^2\) about its centre and \(\tfrac{1}{3}ML^2\) about one end. Tightrope walkers carry long poles to increase their moment of inertia and slow any tipping.

Rotational kinetic energy

A rotating object has kinetic energy \(KE_{rot} = \tfrac{1}{2}I\omega^2\). Flywheels store energy this way and are used in some buses, power grids, and racing cars. A rolling object has both translational and rotational kinetic energy.

Worked example

A 2.0 kg solid disk of radius 0.30 m spins at 10 rad/s. Its moment of inertia is 0.5 x 2.0 x 0.09 = 0.090 kg·m², so its rotational kinetic energy is 0.5 x 0.090 x 100 = 4.5 J. A point on its rim moves at 10 x 0.30 = 3.0 m/s. A hoop of the same mass and radius would have twice the moment of inertia and twice the energy.

Key takeaways

Angles are measured in radians, with 2 pi per turn. Angular velocity and angular acceleration are measured in rad/s and rad/s squared; 3000 rpm is about 314 rad/s. Tangential speed is omega r and tangential acceleration alpha r. The kinematics equations carry over to rotation. Moment of inertia, the sum of m r squared, depends on how mass is distributed: MR squared for a hoop, half MR squared for a disk, two fifths MR squared for a sphere. Rotational kinetic energy is half I omega squared.

Flashcard

Radian

Arc length over radius

2 pi per turn.

Check your understanding

A hoop and a solid disk have the same mass and radius. Which has the larger moment of inertia?

Take the unit quiz

← Previous lesson Next lesson →