Anatomy & Physiology › Section G · The axial and appendicular skeleton › Topic G.4
The pectoral girdle and upper limb
The upper limb is built for reach and dexterity rather than weight bearing. Its girdle hangs on the trunk by a single small joint and is held mostly by muscles, which buys a huge range of movement at the price of some stability.
A girdle built for mobility
Each pectoral (shoulder) girdle has two bones: the clavicle in front and the scapula behind. The girdle attaches the upper limb to the axial skeleton, but its only joint with that skeleton is the small sternoclavicular joint, where the clavicle meets the manubrium of the sternum. The scapula has no bony joint with the ribs at all; muscles hold it against the back of the thoracic cage and slide it around. Because the girdle floats on muscle, the shoulder can move through a far wider range than the hip, though it is also easier to injure.
The clavicle
The clavicle (collarbone) is a slender, S-shaped bone running horizontally across the front of the base of the neck. Its rounded medial (sternal) end joins the manubrium at the sternoclavicular joint. Its flattened lateral (acromial) end meets the scapula's acromion at the acromioclavicular joint. The clavicle acts as a strut that holds the shoulder out to the side, and it passes forces from the upper limb to the axial skeleton. Because it is thin and lies just under the skin, it is one of the most often fractured bones, typically from a fall onto the shoulder or an outstretched hand.
The scapula
The scapula (shoulder blade) is a flat, triangular bone lying on the posterior thorax over ribs 2 to 7. It has medial, lateral and superior borders, and superior and inferior angles. At its lateral angle is the shallow glenoid cavity, which receives the head of the humerus. A prominent ridge, the spine, crosses the posterior surface and ends laterally as the acromion, the bony tip of the shoulder. The spine divides the back into the smaller supraspinous fossa above and the larger infraspinous fossa below; the front surface is the subscapular fossa. The hook-like coracoid process points forwards beneath the clavicle and anchors muscles and ligaments.
The humerus
The arm, between shoulder and elbow, contains one bone. Proximally, the humerus has a rounded head facing medially into the glenoid cavity, ringed by the anatomical neck. Nearby are two bumps for muscle tendons, the greater and lesser tubercles, with the intertubercular groove between them. Below them the shaft narrows at the surgical neck, a common fracture site in older adults. Midway down the lateral shaft is the roughened deltoid tuberosity for the deltoid muscle. Distally, two projections, the medial and lateral epicondyles, give attachment to forearm muscles; the ulnar nerve passes behind the medial epicondyle, the spot people call the funny bone.
The elbow end of the humerus
The distal humerus carries two joint surfaces side by side. Medially, the spool-shaped trochlea articulates with the ulna. Laterally, the rounded capitulum articulates with the head of the radius. Three hollows receive the forearm bones at the extremes of movement. On the posterior surface, the deep olecranon fossa receives the olecranon of the ulna when the elbow straightens. On the anterior surface, the coronoid fossa receives the ulna's coronoid process and the smaller radial fossa receives the radial head when the elbow bends fully. Matching trochlea to ulna and capitulum to radius is a frequent exam point.
The ulna and the radius
The forearm, between elbow and wrist, has two parallel bones joined along their length by the interosseous membrane. In anatomical position, the ulna is medial, on the little finger side. Its large proximal end forms the olecranon, the point of the elbow, and a C-shaped trochlear notch that grips the trochlea; below the notch is the coronoid process. Distally, the ulna ends in a small head and the ulnar styloid process. The radius is lateral, on the thumb side. Its proximal end is a disc-shaped head that spins against the capitulum and the ulna, with the radial tuberosity just below. Distally, the radius widens and forms most of the wrist joint, ending in the radial styloid process.
The wrist and hand
The wrist has eight carpal bones in two rows of four. Listed from lateral (thumb side) to medial, the proximal row is the scaphoid, lunate, triquetrum and pisiform, and the distal row is the trapezium, trapezoid, capitate and hamate. The carpals form an arch whose front is bridged by a band of connective tissue, creating the carpal tunnel for tendons and the median nerve. The palm contains five metacarpals, numbered 1 to 5 from the thumb. The digits contain 14 phalanges: the thumb (pollex) has a proximal and a distal phalanx, and each finger has proximal, middle and distal phalanges.
Worked example: counting the upper limb
How many bones are in both pectoral girdles and upper limbs? 1. One limb: humerus 1 + ulna 1 + radius 1 = 3 long bones of arm and forearm. 2. Add the hand: 8 carpals + 5 metacarpals + 14 phalanges = 27. 3. One limb total: 3 + 27 = 30. 4. One girdle: clavicle + scapula = 2. 5. One side: 30 + 2 = 32. 6. Both sides: 2 × 32 = 64. 7. Check the phalanges: 4 fingers × 3 + thumb × 2 = 14. Notice that more than half of each limb's 30 bones are in the hand and wrist, which is what gives the hand its fine control.
Worked example: a fall on an outstretched hand
A typical textbook case: a person trips and lands on an extended wrist with the palm flat. Trace where the force goes. 1. It enters the palm and passes into the carpals, especially the scaphoid and lunate, which sit against the radius. 2. Because the radius forms most of the wrist joint, it takes most of the load; the distal radius is a classic fracture site. 3. The scaphoid itself can crack, typically giving pain in the small hollow beside the thumb's base. 4. Force continues up the forearm bones and humerus to the scapula, then along the clavicle, which may break. 5. Conclude: the bones at risk follow the force path. For study only; a suspected fracture needs a qualified professional.
Common mistakes to avoid
First, putting the ulna on the thumb side: in anatomical position, the radius is lateral (thumb side) and the ulna medial. Second, swapping the distal humerus surfaces: the trochlea meets the ulna, the capitulum meets the radius. Third, confusing the necks: the anatomical neck rims the head, while the surgical neck is lower and fractures more often. Fourth, giving the thumb three phalanges: it has two, so the hand has 14, not 15. Fifth, saying the scapula joins the ribs: it is held by muscles, and the girdle's only joint with the axial skeleton is the sternoclavicular joint.
Key takeaways
The pectoral girdle is the clavicle and scapula, attached to the axial skeleton only at the sternoclavicular joint, which makes the shoulder mobile but less stable. The scapula has a shallow glenoid cavity, a spine ending in the acromion and a coracoid process. The humerus has a head, anatomical and surgical necks, tubercles, epicondyles, and a trochlea for the ulna and a capitulum for the radius. The ulna is medial with the olecranon; the radius is lateral and forms most of the wrist. Each limb has 30 bones: 3 long bones, 8 carpals, 5 metacarpals and 14 phalanges.
Flashcards
Flashcard
Clavicle and scapula
Test your understanding
Question 1 of 5
In anatomical position, which bone lies on the thumb side of the forearm?
Question 2 of 5
Which part of the distal humerus articulates with the ulna?
Question 3 of 5
How many bones are in one wrist and hand together?
Question 4 of 5
What is the only joint between the pectoral girdle and the axial skeleton?
Question 5 of 5
Which list gives the proximal row of carpal bones from lateral to medial?
