Astronomy › Section H · The Moon, Mercury, Venus, and Mars › Topic H.2
Impact craters
Craters are the most common landform on the solid worlds of the solar system. Understanding how a fast-moving rock blasts one out, and how quickly craters pile up, turns a cratered surface into a clock.
Scars on every solid world
Point even small binoculars at the Moon and you see craters overlapping craters. Mercury, Mars, most moons and the asteroids are scarred the same way. Earth has been hit at least as often for its size, but weather, water, life and plate tectonics have erased or buried most of its craters, leaving only about 200 confirmed impact structures. The Moon, with almost no erosion, kept nearly its whole record. That makes it the reference surface for the solar system: learn how lunar craters form and accumulate, and you can read the history of other worlds.
Volcanoes or impacts?
Until the mid-twentieth century, most scientists assumed lunar craters were volcanic, because nearly all the craters they knew on Earth were. In the 1890s the American geologist Grove Karl Gilbert argued otherwise. Volcanic craters sit on top of mountains and are fairly small, while large lunar craters are much wider, and their floors lie below the surrounding plain. Few people accepted his view at the time. The case was settled in the 1960s, when Eugene Shoemaker and colleagues found shocked minerals at Meteor Crater in Arizona that only an enormous, sudden pressure can make, and Apollo samples later showed impact-shattered rock all over the Moon.
Why craters are round
A puzzle remained: rocks arrive from all directions, so why are craters almost always circular rather than oval? The answer is speed. Anything falling onto a world hits at least at that world's escape speed, about 2.4 km/s for the Moon and 11.2 km/s for Earth, plus whatever speed it already had, so typical impacts happen at 10 to 30 km/s. At such speeds the projectile does not simply dig a hole. Its energy is released almost at once, like an explosion, and explosions dig round craters whatever their direction. Only very shallow, grazing impacts make clearly elongated craters.
How a crater forms
The whole event lasts seconds to minutes. 1. Contact: the projectile drives into the ground, penetrating a distance of about one to a few times its own diameter. 2. Shock: its energy of motion becomes a shock wave that shatters the target rock, and heat that vaporises the projectile and some of the target. 3. Excavation: the expanding shock and vapour throw rock up and out, opening a bowl. 4. Collapse: the bowl's steep walls and floor adjust under gravity, and much of the debris falls back. The finished crater is typically 10 to 20 times wider than the projectile, depending on its speed, the target rock and the world's gravity.
Worked example: the energy of an impact
A rocky body 50 m across, with density 3,000 kg/m³, hits the Moon at 20 km/s. How much energy is released? 1. Radius: \(r = 25\) m. 2. Mass: \(m = \rho \cdot \frac{4}{3}\pi r^3 = 3000 \times \frac{4}{3}\pi(25)^3 = 1.96 \times 10^{8}\) kg. 3. Kinetic energy:
4. Compare: one megaton of TNT releases \(4.18 \times 10^{15}\) J, so this is about 9.4 megatons. 5. Size: a crater 10 to 20 times the body's width would be roughly 0.5 to 1 km across. Speed matters most, because energy grows with its square.
Simple craters, complex craters and basins
Small craters are simple: smooth bowls with raised rims, like Meteor Crater, about 1.2 km wide. Above a certain size, about 15 to 20 km on the Moon and only a few kilometres on Earth, where gravity is stronger, craters become complex. Their floors rebound upwards into a central peak, their walls slump into terraces, and their floors are flatter. The largest impacts make multi-ring basins hundreds of kilometres across, such as the Moon's Orientale basin, a bull's-eye of rings nearly 1,000 km wide. The larger mare basins described in "The Moon and its surface" began as impacts like these before lava flooded them.
Ejecta, secondaries and rays
The rock thrown out of a crater lands as an ejecta blanket, a rough apron that usually extends about one crater diameter beyond the rim. Bigger chunks thrown farther dig secondary craters, often in chains or clusters pointing back to the parent crater. Fine, fresh ejecta can form bright rays reaching hundreds of kilometres; Tycho and Copernicus have the most famous ones. Rays fade over hundreds of millions of years as sunlight and the solar wind slowly darken exposed material, so bright rays mark young craters. To see crater relief yourself, look near first or third quarter phase, when low sunlight casts long shadows; rays show best at full moon.
Craters as clocks
On a surface with little erosion, craters build up steadily, so a heavily cratered area has been exposed longer than a lightly cratered one. Astronomers count craters above a chosen size per unit area, the crater density. Comparing densities gives relative ages directly. To turn them into ages in years, we need the cratering rate, which can be calibrated using Apollo and Luna samples whose ages were measured by radioactive dating. Once calibrated on the Moon, the method can be adjusted for other worlds with no samples, which is how the ages of surfaces on Mars and Mercury are estimated, with larger uncertainties.
Worked example: reading the early bombardment
A highland region has 600 craters at least 1 km wide in 200,000 km², and a mare region has 45 such craters in 150,000 km². Samples date the mare at about 3.7 billion years. 1. Highland density: \(600 \div 200{,}000 = 3.0 \times 10^{-3}\) per km². 2. Mare density: \(45 \div 150{,}000 = 3.0 \times 10^{-4}\) per km². 3. Ratio: the highlands have 10 times the crater density, so they are older. 4. Test a constant rate: the highlands would be \(10 \times 3.7 = 37\) billion years old, older than the 13.8-billion-year-old universe. 5. Conclusion: the assumption fails. Impacts must have been far more frequent before about 3.8 billion years ago. Whether that early era was a smooth decline or included a late spike is still debated.
Common mistakes to avoid
First, assuming lunar craters are volcanic: their wide shape and sunken floors point to impacts. Second, thinking an oval crater is the normal result of an angled hit: the explosion makes craters round except at grazing angles. Third, assuming the crater is the size of the impactor; it is typically 10 to 20 times wider. Fourth, treating crater density as directly proportional to age: the rate was much higher early on. Fifth, forgetting to square the speed when finding impact energy.
Key takeaways
Impact craters dominate the Moon, Mercury and many other worlds; Earth has lost most of its own. Gilbert's reasoning and Shoemaker's shocked minerals showed lunar craters are impact scars. Impacts at 10 km/s or more release energy like an explosion, so craters are round and 10 to 20 times wider than the projectile, with energy \(E = \frac{1}{2}mv^2\). Craters range from simple bowls to complex craters with central peaks to multi-ring basins, surrounded by ejecta, secondaries and rays. Crater density gives relative ages, calibrated by dated samples, and reveals heavy bombardment before about 3.8 billion years ago.
Flashcards
Flashcard
Bowl blasted out by a high-speed collision
Test your understanding
Question 1 of 5
Why are almost all impact craters circular, even though impactors arrive from many directions?
Question 2 of 5
A rock 20 m across (radius 10 m) with density 3,000 kg/m³ hits at 15 km/s. Its kinetic energy is about:
Question 3 of 5
Region X on the Moon has five times the crater density of region Y. What can you safely conclude?
Question 4 of 5
When is the best time to see the relief of lunar craters through binoculars?
Question 5 of 5
Which features mark a complex crater rather than a simple one?
