Biology › Section O · Hormones, bones, and muscles › Topic O.7

Muscle contraction and locomotion

Every step, heartbeat and breath depends on protein filaments sliding past one another. Following a skeletal muscle from the nerve signal to the pull on a bone shows how electricity, calcium and ATP combine to make movement.

From signal to movement

The topic on animal tissues introduced skeletal, cardiac and smooth muscle. All three contract using the proteins actin and myosin, but skeletal muscle shows the machinery most clearly, so it is the focus here. The human body has more than 600 skeletal muscles, each pulling on bones through tendons; as the topic on joints showed, they work in antagonistic pairs because they can only pull. Locomotion, whether walking, swimming or flying, is a timed sequence of these pulls. The question is how one muscle cell turns a nerve impulse into force.

Inside a muscle fibre

A skeletal muscle cell, called a muscle fibre, is a long cylinder up to about 100 µm across with many nuclei, formed when embryonic cells fuse. Its plasma membrane is the sarcolemma and its cytoplasm the sarcoplasm. The sarcolemma dips into the fibre as narrow transverse tubules, or T-tubules, which carry electrical signals deep inside. Wrapped around the contractile machinery is the sarcoplasmic reticulum, a specialised endoplasmic reticulum that stores calcium ions. Most of the fibre is packed with myofibrils, rods roughly 1 to 2 µm wide running its full length, each a chain of repeating units.

The sarcomere

The repeating unit of a myofibril is the sarcomere, the functional unit of contraction, which runs from one Z disc to the next. Thin filaments anchor to each Z disc and point towards the centre; thick filaments sit in the middle, held together at the M line. The dark A band is the length of the thick filaments, including the regions where thin filaments overlap them. The light I band, bisected by a Z disc, contains thin filaments only. The H zone in the middle of the A band contains thick filaments only. Myofibrils line up band for band across the fibre, so the whole cell looks striped.

Thick and thin filaments

A thick filament is a bundle of myosin molecules whose tails pack together near the M line while their heads project towards both ends, within reach of the thin filaments. Each head binds actin and also binds ATP, acting as an ATPase, an enzyme that splits ATP. A thin filament is mainly actin, a chain of globular proteins each with a myosin-binding site. Two regulatory proteins lie along it. Strands of tropomyosin cover the binding sites in resting muscle. Troponin, a three-part complex, holds tropomyosin in place and binds calcium ions.

The sliding filament model

When a sarcomere contracts, neither kind of filament gets shorter. Myosin heads pull the thin filaments past the thick ones towards the M line, so overlap increases and the Z discs are drawn together. The I band and the H zone shrink, because the other filament slides into each, while the A band keeps its width, because it is defined by the thick filaments themselves. Thousands of sarcomeres in series each shorten a little, so the myofibril, fibre and muscle shorten together.

Worked example: measuring a contracting sarcomere

Suppose each thick filament is 1.6 µm long, each thin filament extends 1.0 µm from its Z disc, and a relaxed sarcomere is 2.6 µm. 1. A band = thick filament length = 1.6 µm. 2. I band = sarcomere minus A band = 2.6 − 1.6 = 1.0 µm, split into 0.5 µm at each end. 3. H zone = sarcomere minus the two thin filaments = 2.6 − 2 × 1.0 = 0.6 µm. 4. Now the sarcomere contracts to 2.2 µm. A band: still 1.6 µm. I band: 2.2 − 1.6 = 0.6 µm. H zone: 2.2 − 2.0 = 0.2 µm. 5. Check: the I band and H zone each lost 0.4 µm, exactly the shortening, while the A band did not change.

The cross-bridge cycle

Myosin heads pull in repeated cycles, each powered by one ATP. 1. A fresh ATP binds the myosin head, which makes the head let go of actin. 2. The head's ATPase splits ATP into ADP and phosphate, and the released energy cocks the head into a high-energy position. 3. If a binding site on actin is exposed, the head attaches, forming a cross-bridge. 4. Releasing the phosphate triggers the power stroke: the head pivots and drags the thin filament towards the M line. 5. ADP leaves, but the head stays attached until another ATP arrives. When ATP runs out after death, heads cannot detach, which is why muscles stiffen in rigor mortis.

From nerve impulse to calcium

Excitation-contraction coupling links the nerve signal to the filaments. A motor neuron's action potential releases acetylcholine at the neuromuscular junction, as in the topic on neuron communication. Acetylcholine binds receptors on the motor end plate, the sarcolemma beneath the axon terminal, opening sodium channels and depolarising the membrane. An action potential sweeps along the sarcolemma and down the T-tubules, making the sarcoplasmic reticulum release calcium. Calcium binds troponin, which shifts tropomyosin off actin's binding sites, and cross-bridge cycling begins. To relax, acetylcholinesterase destroys the acetylcholine and ATP-driven pumps return calcium to the sarcoplasmic reticulum, so tropomyosin covers the sites again.

Controlling force

One motor neuron and all the fibres it controls form a motor unit; each impulse makes every fibre in the unit twitch. So force is graded mainly by recruitment: lifting a pencil activates a few small motor units, lifting a heavy box many more, including large ones. Firing rate matters too: rapid impulses keep calcium high, so twitches add into a stronger, sustained contraction. Tension also depends on length, because cross-bridges form only where thick and thin filaments overlap. An overstretched sarcomere has little overlap; an overly shortened one jams its filaments together. Tension peaks at an intermediate length.

Worked example: predicting the effect of a toxin

Use the coupling sequence to predict three effects. 1. Curare, a plant toxin, blocks acetylcholine receptors at the motor end plate. Acetylcholine is released but cannot bind, so no end-plate depolarisation occurs, no calcium is released, and the muscle stays limp: flaccid paralysis. 2. Certain nerve agents block acetylcholinesterase. Acetylcholine lingers and keeps stimulating the fibre, causing uncontrolled twitching; then the overstimulated fibres stop responding, and paralysis follows, deadly when it reaches the breathing muscles. 3. After death, ATP is used up. Calcium leaks from the sarcoplasmic reticulum and cross-bridges form, but without ATP they cannot release: rigor mortis. 4. Each answer comes from locating which step of the sequence fails.

Common mistakes to avoid

First, filaments do not shorten during contraction; they slide, and only the sarcomere shortens. Second, the A band keeps its width; it is the I band and H zone that narrow. Third, calcium binds troponin, not actin or myosin; troponin then moves tropomyosin. Fourth, ATP is also needed to release myosin from actin and to pump calcium back, so relaxation costs energy too. Fifth, force is not raised by sending a bigger impulse: action potentials are all-or-nothing, so force rises mainly by recruiting more motor units and partly by firing them faster. Sixth, the power stroke happens when phosphate is released, not at the moment ATP is split.

Key takeaways

A muscle fibre is packed with myofibrils made of sarcomeres: myosin thick filaments in the middle, actin thin filaments anchored at the Z discs. Contraction is sliding: Z discs move closer, the I band and H zone shrink, the A band stays constant. Each cross-bridge cycle uses one ATP: binding ATP releases the head, splitting it cocks the head, and phosphate release drives the power stroke. Acetylcholine triggers an action potential that travels down the T-tubules and releases calcium, which binds troponin and moves tropomyosin aside. Force is graded by motor unit recruitment, firing rate and filament overlap.

Flashcards

Flashcard

Muscle fibre

A single skeletal muscle cell, long and multinucleate

Packed with myofibrils.

Test your understanding

Question 1 of 5

As a sarcomere contracts, which region stays the same width?

Question 2 of 5

What is the direct role of calcium ions in triggering contraction?

Question 3 of 5

In the cross-bridge cycle, what happens when a new ATP molecule binds to a myosin head that is attached to actin?

Question 4 of 5

Curare blocks acetylcholine receptors at the motor end plate. What happens to a muscle exposed to curare when its motor neuron fires?

Question 5 of 5

How does the nervous system make the biceps exert more force to lift a heavy box than a pencil?

← Previous topicNext topic →