Chemistry › Section I · Gases › Topic I.4

Effusion and diffusion

Gas molecules never stop moving, so gases spread out and leak through the smallest gaps. How fast they do it depends on how heavy their molecules are, a relationship simple enough to identify an unknown gas and important enough to have shaped the nuclear industry.

Gases on the move

Open a bottle of ammonia solution in one corner of a laboratory and, before long, someone across the room notices the smell. A helium party balloon goes soft within a day, while an identical balloon blown up with air stays firm for much longer. Both observations come from the constant motion of gas molecules, which travel at hundreds of metres per second at room temperature. This topic separates the two processes involved, diffusion and effusion, and shows why light molecules win both races.

Diffusion

Diffusion is the gradual mixing of gases as their molecules spread out through space because of their random motion. No molecule is aiming anywhere: each moves in a straight line until it hits another molecule and changes direction. But where a gas is more concentrated, more of its molecules are moving away from that region than into it, so there is a net flow from high to low concentration. In a closed container, diffusion continues until the mixture is uniform. The molecules still move after that, but equal numbers now cross any plane in each direction, so there is no further net change.

Why diffusion is slow

If a nitrogen molecule moves at about 500 m/s at room temperature, why does a smell take seconds or minutes to cross a room? Because the molecule never travels far in a straight line. At 1 atm and 25 °C, a molecule in air travels on average only about 70 nm between collisions, a distance called the mean free path, and it collides billions of times every second. Each collision sends it off in a new direction, so its path is a random zigzag, and its net progress is far slower than its speed. At lower pressure the molecules are further apart and the mean free path is longer. In a real room, air currents usually carry a smell much faster than diffusion alone.

Effusion

Effusion is the escape of gas molecules through a tiny hole into a vacuum or a region of much lower pressure. The hole must be small compared with the mean free path, so molecules pass through it one at a time, without jostling each other, rather than flowing out as a stream. The rate of effusion then depends on how often molecules happen to arrive at the hole, which depends on how fast they move. Gas leaking through a pinhole into an evacuated chamber is a true example. Helium seeping out of a rubber balloon is not strict effusion, because it works its way through the rubber itself, but it shows the same preference for light molecules.

Graham's law

As the next topic shows, at a given temperature the molecules of every gas have the same average kinetic energy, \(\frac{1}{2}mu^2\). A lighter molecule must therefore move faster, with its speed proportional to \(\frac{1}{\sqrt{M}}\). In the 1830s and 1840s the Scottish chemist Thomas Graham measured exactly this: each gas effuses at a rate that varies as one over the square root of its molar mass. For two gases A and B at the same temperature and pressure:

\frac{\text{rate}_A}{\text{rate}_B} = \sqrt{\frac{M_B}{M_A}}

Note that the heavier gas's molar mass goes on top. Graham's law holds strictly for effusion. Diffusion follows the same trend, light gases spreading faster, but collisions make the square-root relationship only approximate.

Worked example: a helium balloon

How many times faster does helium effuse than nitrogen, the main gas in air, under the same conditions? 1. Molar masses: \(M_{\mathrm{He}} = 4.003\) g/mol and \(M_{\mathrm{N_2}} = 28.02\) g/mol. 2. Apply Graham's law, with the heavier gas on top: \(\frac{\text{rate}_{\mathrm{He}}}{\text{rate}_{\mathrm{N_2}}} = \sqrt{\frac{28.02}{4.003}}\). 3. Evaluate: \(\sqrt{7.000} = 2.65\). 4. Interpret: through a pinhole, helium escapes about 2.65 times as fast. Leaking through rubber is not strict effusion, but the same trend is why a helium balloon softens long before an air-filled one. 5. Check: the lighter gas has the higher rate, and the ratio is the square root of the mass ratio of 7, not 7 itself.

Rates, times and molar masses

A rate is an amount per unit time, so for the same amount of gas the time taken is inversely proportional to the rate. Times therefore follow the opposite pattern to rates:

\frac{t_A}{t_B} = \sqrt{\frac{M_A}{M_B}}

The heavier gas takes longer. Graham's law can also run backwards to find a molar mass. If an unknown gas effuses at a measured fraction of the rate of a known gas, square the rate ratio and rearrange: \(M_{\text{unknown}} = M_{\text{known}} \times \left(\frac{\text{rate}_{\text{known}}}{\text{rate}_{\text{unknown}}}\right)^2\). Comparing the result with molar masses of likely candidates often identifies the gas.

Worked example: identifying a gas

Under the same conditions, a sample of nitrogen takes 85.0 s to effuse through a pinhole, and an equal amount of carbon dioxide is tested next. (a) How long does the carbon dioxide take? (b) An unknown gas effuses at 0.629 times the rate of oxygen. What is its molar mass? 1. (a) Heavier gas, longer time: \(t_{\mathrm{CO_2}} = 85.0 \times \sqrt{\frac{44.01}{28.02}} = 107\) s. 2. (b) The unknown is slower, so heavier: \(M = 32.00 \times \left(\frac{1}{0.629}\right)^2 = 80.9\) g/mol. 3. Identify: hydrogen bromide, HBr, has \(M = 80.91\) g/mol, a good match. 4. Check: \(\sqrt{\frac{32.00}{80.91}} = 0.629\), reproducing the measured ratio.

Separating uranium isotopes

Graham's law was put to work on an industrial scale to enrich uranium. Natural uranium is only about 0.72% uranium-235, the isotope that sustains a chain reaction, and most power reactors need 3 to 5%. Uranium is turned into gaseous uranium hexafluoride, \(\mathrm{UF_6}\), and pumped through porous barriers. The molar masses of \(\mathrm{^{235}UF_6}\) and \(\mathrm{^{238}UF_6}\) are about 349.0 and 352.0 g/mol, so the lighter molecule passes through only \(\sqrt{\frac{352.0}{349.0}} = 1.004\) times as fast. Plants needed cascades of more than a thousand stages. Because the process uses huge amounts of energy, gas centrifuges have now replaced it worldwide.

Common mistakes to avoid

First, putting the molar masses the wrong way up: the rate ratio is the square root of the heavier gas's molar mass over the lighter one's when the lighter gas's rate is on top. Second, forgetting the square root and using the plain ratio of molar masses. Third, treating times like rates: the gas with the higher rate takes less time, so the time ratio is inverted. Fourth, confusing the two processes: effusion is escape through a tiny hole, while diffusion is mixing through space. Fifth, comparing gases at different temperatures, since Graham's law assumes the same temperature.

Key takeaways

Diffusion is the mixing of gases by random molecular motion, with a net flow from high to low concentration; collisions, with a mean free path of about 70 nm in air at 1 atm, make it far slower than molecular speeds. Effusion is the escape of molecules through a tiny hole into a vacuum. Graham's law: at the same temperature and pressure, rate_A/rate_B = √(M_B/M_A), so light gases effuse faster. Effusion times follow the inverse ratio. Measured rate ratios give molar masses, and the same principle once enriched uranium.

Flashcards

Flashcard

Diffusion

Mixing of gases as molecules spread through space by random motion

Net flow from high to low concentration.

Test your understanding

Question 1 of 5

Under the same conditions, how many times faster does hydrogen, H₂ (2.016 g/mol), effuse than carbon dioxide, CO₂ (44.01 g/mol)?

Question 2 of 5

A sample of oxygen, O₂ (32.00 g/mol), takes 60.0 s to effuse through a pinhole. Under the same conditions, how long does the same amount of hydrogen, H₂ (2.016 g/mol), take?

Question 3 of 5

An unknown gas effuses at exactly half the rate of oxygen, O₂ (32.00 g/mol), under the same conditions. What is its molar mass?

Question 4 of 5

Which process is effusion?

Question 5 of 5

Nitrogen molecules at room temperature move at about 500 m/s. Why does a gas take far longer than this suggests to diffuse across a room of still air?

← Previous topicNext topic →