Chemistry › Section L · Kinetics › Topic L.2

Factors affecting rates

The same reaction can crawl or race depending on how it is set up. Five factors control the speed: what the reactants are, how finely divided they are, how concentrated they are, how hot they are, and whether a catalyst is present.

Same chemistry, different speeds

An iron nail left outside rusts over months. Fine steel wool, which is also mostly iron, glows and burns in a flame within seconds. Both involve iron combining with oxygen, so the difference lies in the conditions. Chemists, cooks and engineers all control rates on purpose: a fridge slows the reactions that spoil food, a pressure cooker speeds up cooking, and mills that handle flour or sawdust work hard to stop fine dust from burning explosively. Every one of these choices uses the factors in this topic. A reaction can only happen when reactant particles meet, so most of the factors work by changing how often, or how forcefully, they meet.

The chemical nature of the reactants

Some substances simply react faster than others under the same conditions, because of the bonds that must break and form. Drop sodium into cold water and it fizzes rapidly across the surface:

\mathrm{2Na(s) + 2H_2O(l) \rightarrow 2NaOH(aq) + H_2(g)}\,.

Potassium reacts even more violently, while magnesium reacts with cold water only very slowly. Reactions between oppositely charged ions in solution are usually almost instant: when \(\mathrm{Ag^+(aq)}\) meets \(\mathrm{Cl^-(aq)}\), solid AgCl appears at once, because the ions are already separate and attract each other. Reactions that must break strong covalent bonds, such as the triple bond in N₂, tend to be slow.

Physical state and surface area

Gases mix freely, and so do dissolved substances, so their particles meet throughout the whole volume. When a solid takes part, only the particles on its surface can be reached by the other reactant. Breaking a solid into smaller pieces exposes more surface, and the rate rises. That is why powdered sugar dissolves faster than a sugar cube, and why a pile of flour burns slowly while the same flour dispersed as a dust cloud can explode: each tiny grain is surrounded by air. Stirring helps for a similar reason, by bringing fresh reactant to the solid's surface.

Worked example: cutting up a cube

A 1.0 cm cube of zinc is cut into cubes 1.0 mm (0.10 cm) on a side. How does the surface area change? 1. The original cube has 6 faces of \(1.0 \times 1.0 = 1.0\ \mathrm{cm^2}\), so its area is 6.0 cm². 2. Along each edge, 1.0 cm holds 10 small cubes, so there are \(10^3 = 1000\) of them. 3. Each small cube has area \(6 \times (0.10)^2 = 0.060\ \mathrm{cm^2}\). 4. Total: \(1000 \times 0.060 = 60\ \mathrm{cm^2}\), ten times the original. 5. Check: the zinc has the same volume, but cutting by a factor of 10 along each edge multiplies the surface by 10, so with acid the reaction can run up to about ten times faster at the start.

Concentration

Raising the concentration of a dissolved reactant puts more of its particles into each litre, so they meet the other reactant more often and the rate usually rises. For a gas, the same effect comes from a higher partial pressure. Air is only about 21% oxygen by volume, and the difference pure oxygen makes is dramatic: a wooden splint that is merely glowing in air bursts back into flame when lowered into a tube of pure oxygen. That is the standard laboratory test for oxygen gas. Hospitals ban open flames near oxygen cylinders for the same reason.

Temperature

Nearly all reactions go faster when they are heated. At a higher temperature particles move faster, so they meet more often and, more importantly, more of their collisions are energetic enough to cause a reaction (the collision-theory topic makes this exact). A rough rule of thumb, true for many reactions near room temperature, is that the rate about doubles for every 10 °C rise. It is only a guide: the real factor depends on the reaction and can be much larger or smaller. Cooling has the opposite effect, which is why food keeps longer in a fridge and longer still in a freezer.

Worked example: the 10-degree rule

A reaction runs at a measured rate at 20 °C. Estimate how much faster it runs at 50 °C, and how long milk that keeps 10 days at 4 °C might last at 24 °C. 1. From 20 °C to 50 °C is three 10-degree steps, so the factor is about \(2^3 = 8\). 2. From 4 °C to 24 °C is two steps, so spoilage runs about \(2^2 = 4\) times faster. 3. Time scales inversely with rate: \(10 \div 4 = 2.5\) days. 4. Check the reasoning, not just the arithmetic: each step multiplies by 2, so three steps give 8, not 6. 5. Treat both answers as rough estimates, since the doubling rule is only approximate.

Catalysts

A catalyst is a substance that makes a reaction go faster while not being used up itself. Hydrogen peroxide,

\mathrm{2H_2O_2(aq) \rightarrow 2H_2O(l) + O_2(g)}\,,

decomposes very slowly in a bottle, but a pinch of black manganese(IV) oxide powder, MnO₂, makes it froth with oxygen within seconds. When the fizzing stops, the MnO₂ can be filtered off, dried and weighed, and its mass is unchanged. The enzyme catalase in yeast and potato does the same job in living cells. How catalysts work is the subject of the catalysis topic at the end of this chapter.

Common mistakes to avoid

First, thinking that cutting a solid into pieces changes the amount of reactant: the mass is the same, only the exposed surface grows. Second, adding steps in the 10-degree rule instead of multiplying: a 30 °C rise gives about 2 × 2 × 2 = 8, not 6. Third, treating that rule as a law; it is a rough guide. Fourth, saying a catalyst is used up because it takes part in the reaction; it is regenerated. Fifth, forgetting that temperature works mainly by making collisions more energetic, not only more frequent.

Key takeaways

Five factors set a reaction's rate. The chemical nature of the reactants matters: ions in solution often react at once, while breaking strong covalent bonds is slow. More surface area, from smaller pieces, speeds up reactions involving solids. Higher concentration, or partial pressure for gases, means more frequent encounters. Higher temperature means faster, more energetic particles; many rates roughly double per 10 °C. A catalyst speeds a reaction and is not consumed.

Flashcards

Flashcard

Five rate factors

Nature of reactants, surface area, concentration, temperature, catalyst

Most work by changing how particles meet.

Test your understanding

Question 1 of 5

A 2.0 cm cube of a solid is cut into 1.0 cm cubes. What is the total surface area of the pieces?

Question 2 of 5

Using the rule of thumb that the rate doubles for every 10 °C rise, about how much faster is a reaction at 45 °C than at 15 °C?

Question 3 of 5

Zinc reacts with hydrochloric acid: Zn(s) + 2HCl(aq) → ZnCl₂(aq) + H₂(g). Which change would NOT increase the rate?

Question 4 of 5

Why does a glowing splint burst into flame in pure oxygen but only glow in air?

Question 5 of 5

A student adds 0.50 g of MnO₂ to hydrogen peroxide. After the reaction, what mass of MnO₂ should she recover?

← Previous topicNext topic →