Chemistry › Section L · Kinetics › Topic L.3
Rate laws
Concentration speeds most reactions up, but by how much depends on the reaction. A rate law states the exact relationship, and it can only be found by experiment, usually by comparing initial rates.
From factors to an equation
The factors topic showed that raising a reactant's concentration usually speeds a reaction up. But doubling a concentration does not always double the rate. For one reaction the rate doubles, for another it quadruples, and for some it does not change at all. To predict a rate, or to compare reactions fairly, chemists need an equation linking rate to concentration at a fixed temperature. That equation is the rate law. Finding it is one of the first things done when a reaction is studied, because it also gives clues about the steps by which the reaction happens.
The form of a rate law
For a reaction \(a\mathrm{A} + b\mathrm{B} \rightarrow \text{products}\), the rate law usually takes the form
The power m is called the order with respect to A, and n the order with respect to B, and their sum, m + n, is the overall order. The rate constant k is a number fixed for a given reaction at a given temperature: it does not change when the concentrations change, but it does change with temperature. Orders are most often 0, 1 or 2, though fractional and negative orders exist. The rate law holds at each moment, using the concentrations present then; initial rates are just the easiest to measure.
Orders come from experiment
The orders are not, in general, the coefficients of the balanced equation, and must be measured. For
the coefficient of iodide is 3, yet the measured rate law is \(\text{rate} = k[\mathrm{S_2O_8^{2-}}][\mathrm{I^-}]\), first order in each ion. The balanced equation shows only the overall change, while the rate law reflects how the reaction actually happens. Some rate laws do match the coefficients: \(\mathrm{2NO_2(g) \rightarrow 2NO(g) + O_2(g)}\) has \(\text{rate} = k[\mathrm{NO_2}]^2\). But you can only know that from data.
What each order means
The order tells you how the rate responds when that one concentration is multiplied by a factor x. Zero order: the rate does not change, because \(x^0 = 1\). First order: the rate changes by the same factor x, so doubling the concentration doubles the rate. Second order: the rate changes by \(x^2\), so doubling gives four times the rate and tripling gives nine times. The decomposition of N₂O₅ is first order. The removal of ethanol from the blood by the liver is close to zero order at typical levels: roughly the same amount is removed each hour, however much is present.
The method of initial rates
To find the orders, run the reaction several times, changing one starting concentration at a time, and measure each initial rate. Compare two runs in which only [A] changes:
because k and every other concentration cancel. When the ratios are simple, the order can be seen at a glance; otherwise take logarithms: \(m = \frac{\log(\text{rate ratio})}{\log(\text{concentration ratio})}\). Repeat for each reactant. Finally, substitute any one run's data into the rate law to find k, and check the result against another run.
Worked example: the persulfate and iodide reaction
Illustrative initial rates for \(\mathrm{S_2O_8^{2-} + 3I^-}\): run 1, both ions 0.010 M, rate \(8.0 \times 10^{-7}\) M s⁻¹; run 2, \([\mathrm{S_2O_8^{2-}}] = 0.020\) M, \([\mathrm{I^-}] = 0.010\) M, rate \(1.6 \times 10^{-6}\); run 3, \([\mathrm{S_2O_8^{2-}}] = 0.010\) M, \([\mathrm{I^-}] = 0.030\) M, rate \(2.4 \times 10^{-6}\). 1. Runs 1 and 2: persulfate doubles and the rate doubles, so its order is 1. 2. Runs 1 and 3: iodide triples and the rate triples, so its order is 1. 3. Rate law: \(\text{rate} = k[\mathrm{S_2O_8^{2-}}][\mathrm{I^-}]\), overall order 2. 4. From run 1: \(k = \frac{8.0 \times 10^{-7}}{(0.010)(0.010)} = 8.0 \times 10^{-3}\ \mathrm{L\,mol^{-1}\,s^{-1}}\). 5. Check with run 3: \(8.0 \times 10^{-3} \times 0.010 \times 0.030 = 2.4 \times 10^{-6}\).
Worked example: a ratio that is not a doubling
For \(\mathrm{A + 2B \rightarrow C}\), raising [A] from 0.10 M to 0.15 M with [B] fixed raises the initial rate from \(2.0 \times 10^{-3}\) to \(4.5 \times 10^{-3}\) M s⁻¹. Tripling [B] with [A] at 0.10 M leaves the rate at \(2.0 \times 10^{-3}\) M s⁻¹. 1. Order in A: \(1.5^m = 2.25\), so \(m = \frac{\log 2.25}{\log 1.5} = 2\). 2. Order in B: the rate is unchanged, so the order is 0, even though B's coefficient is 2. 3. Rate law: \(\text{rate} = k[\mathrm{A}]^2\). 4. \(k = \frac{2.0 \times 10^{-3}}{(0.10)^2} = 0.20\ \mathrm{L\,mol^{-1}\,s^{-1}}\). 5. Predict the rate at [A] = 0.050 M: \(0.20 \times (0.050)^2 = 5.0 \times 10^{-4}\) M s⁻¹, a quarter of run 1's rate, as halving a second-order concentration should give.
Units of the rate constant
Rate always has units of mol L⁻¹ s⁻¹, so the units of k must make the rate law balance, and they depend on the overall order. Overall zero order: k has the units of a rate, \(\mathrm{mol\,L^{-1}\,s^{-1}}\). First order: \(\mathrm{s^{-1}}\). Second order: \(\mathrm{L\,mol^{-1}\,s^{-1}}\). Third order: \(\mathrm{L^2\,mol^{-2}\,s^{-1}}\). The pattern for overall order n is \((\mathrm{mol\,L^{-1}})^{1-n}\,\mathrm{s^{-1}}\). Reading the units of a quoted k is therefore a quick way to tell a reaction's overall order.
Common mistakes to avoid
First, writing orders from the balanced coefficients without data. Second, comparing two runs in which more than one concentration has changed; pick runs where only one differs. Third, reading a rate that quadruples on doubling as order 4: since \(2^2 = 4\), the order is 2. Fourth, thinking k changes with concentration; it changes only with temperature. Fifth, giving k the wrong units: work them out from the overall order. Sixth, counting a zero-order reactant as order 1 when adding up the overall order.
Key takeaways
A rate law has the form rate = k[A]^m[B]^n, where m and n are the orders and their sum is the overall order. Orders are found by experiment and need not equal the coefficients. Multiplying a concentration by x changes the rate by x to the power of its order. In the method of initial rates, compare runs where only one concentration changes, then substitute into the rate law to find k. The rate constant depends on temperature, not concentration, and its units follow from the overall order.
Flashcards
Flashcard
rate = k[A]^m[B]^n
Test your understanding
Question 1 of 5
A reaction has the rate law rate = k[A]²[B]. If [A] is doubled and [B] is halved, what happens to the rate?
Question 2 of 5
Tripling the concentration of X, with everything else unchanged, makes the initial rate nine times larger. What is the order with respect to X?
Question 3 of 5
A reaction is second order overall. What are the units of its rate constant?
Question 4 of 5
A reaction has rate = k[A][B]², with k = 0.50 L² mol⁻² s⁻¹. What is the rate when [A] = 0.20 M and [B] = 0.30 M?
Question 5 of 5
Which statement about the orders in a rate law is correct?
