Macroeconomics › Section O · Monetary policy and bank regulation › Topic O.5

Monetary policy and economic outcomes

A change in one overnight interest rate ends up affecting whether firms build factories, families buy houses and prices rise faster or slower. This topic follows that chain from the policy rate to aggregate demand, and tests it against half a century of Federal Reserve decisions.

Loose and tight policy

When a central bank cuts interest rates to encourage borrowing, its policy is called expansionary, or loose. One that raises interest rates and discourages borrowing is contractionary, or tight. The previous topic showed how the Fed moves its target range for the federal funds rate. In the textbook model, lower rates come from a rightward shift in the supply of loanable funds as reserves are added: the equilibrium interest rate falls and more is borrowed. A tighter policy shifts supply left, raising the rate and reducing borrowing. Whatever the mechanics, the aim is the same: to change spending in the economy.

From the policy rate to other rates

The federal funds rate is an overnight rate, but it pulls on rates across the economy: bank prime lending rates, credit card rates, car loans and, more loosely, mortgages and corporate bonds. A one-point change in the funds rate usually moves long-term rates by less than one point, because long rates also reflect expected future policy, inflation expectations and risk. If markets expect the Fed to keep raising rates, long rates can rise before it acts; if they expect cuts, long rates may fall early. So the Fed influences the whole spectrum of interest rates, but supply and demand in each market set the exact rate.

Channels to spending

Interest rates reach aggregate demand through several channels. The interest rate channel: lower rates make borrowing cheaper and saving less rewarding, so firms invest more in equipment and buildings and households buy more houses, cars and other big items. The wealth channel: lower rates tend to raise share and house prices, so owners feel richer and spend more. The exchange rate channel: lower US rates make dollar assets less attractive, the dollar tends to weaken, and US exports become cheaper abroad. The expectations channel: forward guidance, the Fed's statements about the likely path of rates, shapes long-term rates and wage and price setting today.

Monetary policy in the AD/AS model

In the aggregate demand and aggregate supply model, these channels shift aggregate demand. Suppose an economy is in recession, producing below potential GDP with high unemployment. Expansionary policy lowers rates, raises investment and consumption, and shifts AD to the right, raising real GDP towards potential with some rise in the price level. Now suppose the economy is producing above potential and inflation is building. Contractionary policy raises rates, cuts interest-sensitive spending and shifts AD to the left, cooling output back towards potential and easing inflation. Policy that leans against the business cycle in this way is called countercyclical.

Worked example: closing a recessionary gap

Potential GDP is $25 trillion, but the economy is producing $24.5 trillion and unemployment is rising. Inflation is 1.5%, below the 2% goal. 1. Identify the gap: output is \(25 - 24.5 = 0.5\) trillion below potential, a recessionary gap of \(\frac{0.5}{25} = 2\%\). 2. Choose the policy: both goals point the same way, so the FOMC lowers its target range. 3. Trace the effects: cheaper loans raise investment and car and house purchases, shifting AD right. 4. Outcome: real GDP moves towards $25 trillion and inflation rises towards 2%. 5. Caution: cutting too far pushes AD past potential and triggers inflation, so policymakers move in steps and watch the data.

A rule of thumb: the Taylor rule

In 1993 the economist John Taylor proposed a simple guide for the policy rate \(i\):

i = r^* + \pi + 0.5(\pi - \pi^*) + 0.5(\text{gap})

Here \(r^*\) is the neutral real interest rate, which neither speeds up nor slows down the economy, \(\pi\) is inflation, \(\pi^*\) is the inflation target and the gap is the output gap, actual output's percentage distance from potential. When inflation is above target or output is above potential, the rule calls for a higher rate. Central banks treat it as a reference, not a formula they must obey, partly because \(r^*\) and the output gap cannot be measured directly and are estimated with error.

Worked example: applying the Taylor rule

Take \(r^* = 1\%\) and a 2% target. 1. Case A: inflation 3% and output 1% below potential, a gap of \(-1\). Then

i = 1 + 3 + 0.5(1) + 0.5(-1) = 4.0\%

The inflation and output terms pull in opposite directions and cancel. 2. Case B: inflation 5% and a gap of \(+1\). Then

i = 1 + 5 + 0.5(3) + 0.5(1) = 8.0\%

High inflation in an overheating economy calls for a much tighter stance. 3. Case C: inflation 1% and a deep recession with a gap of \(-4\). Then \(i = 1 + 1 - 0.5 - 2 = -0.5\%\). 4. Interpret Case C: the rule asks for a negative rate, a problem the next topic explores.

The Volcker disinflation

History shows both the power and the cost of tight policy. By 1980 US consumer price inflation had reached about 13.5%. Under Chair Paul Volcker, appointed in 1979, the Fed tightened hard: the federal funds rate averaged about 16% in 1981 and at times went higher. Back-to-back recessions followed in 1980 and 1981 to 1982, and unemployment peaked near 11% in late 1982. Inflation fell to about 3% by 1983 and stayed far lower for decades. Economists still debate whether a gentler path was possible, but the episode established that a determined central bank can bring down inflation, and it raised the credibility of later Fed promises.

Recent decisions

The Fed has kept leaning against the cycle. It cut rates in the early 1990s and early 2000s recessions and raised them as booms threatened inflation. In 2008 and again in March 2020 it cut its target to a range of 0% to 0.25% to cushion collapsing demand. As inflation surged after the pandemic, it raised rates from 2022, reaching 5.25% to 5.50% in July 2023. It then cut in several steps between September 2024 and December 2025, to 3.50% to 3.75%, before raising the range by 0.25 point in September 2026 to 3.75% to 4%, stating that inflation remained elevated. It held that range in October 2026.

Common mistakes to avoid

First, thinking expansionary policy raises rates: it lowers them, and contractionary policy raises them. Second, expecting long-term rates to move one for one with the funds rate. Third, getting the exchange rate channel backwards: lower rates tend to weaken the currency and raise net exports. Fourth, writing the Taylor rule's gap term with the wrong sign: output below potential lowers the suggested rate. Fifth, treating policy effects as immediate: they arrive with long and variable lags, a pitfall the next topic examines.

Key takeaways

Expansionary policy lowers interest rates and shifts aggregate demand right; contractionary policy raises rates and shifts it left. The effects run through borrowing costs, wealth, the exchange rate and expectations, and long-term rates move less than the policy rate. Countercyclical policy aims to close recessionary and inflationary gaps without overshooting. The Taylor rule links the policy rate to inflation and the output gap. The Volcker years showed tight policy can end high inflation at a heavy cost. After October 2026 the target range was 3.75% to 4%.

Flashcards

Flashcard

Expansionary (loose) policy

Lower interest rates to raise borrowing and spending

Shifts AD to the right.

Test your understanding

Question 1 of 5

The economy is producing above potential GDP and inflation is rising. Which policy fits, and what does it do in the AD/AS model?

Question 2 of 5

With r* = 0.5%, a 2% target, inflation of 4% and output 1% below potential, what rate does the Taylor rule suggest?

Question 3 of 5

The Fed cuts its policy rate. Through the exchange rate channel, what tends to happen?

Question 4 of 5

The Fed lowers the federal funds rate by one percentage point. What usually happens to 30-year mortgage rates?

Question 5 of 5

What did the Volcker disinflation of 1979 to 1983 show?

← Previous topicNext topic →