Physics › Section I · Temperature, gases, and heat › Topic I.5

Heat and heat capacity

Heat is energy that moves because one thing is hotter than another. How much the temperature changes when it arrives depends on the mass and on the material, and water, with its unusually high specific heat, shapes everything from kettles to coastal weather.

Heat is energy on the move

Put a cold spoon into hot soup and the spoon warms while the soup cools slightly. Energy passes on its own from hotter to colder until both reach the same temperature, called thermal equilibrium. That transferred energy is heat. An object does not contain heat; it has internal energy, the total kinetic and potential energy of its particles, and heat is one way to change it. Temperature tracks the average kinetic energy of the particles, so a large lukewarm bath holds far more internal energy than a small cup of hot tea.

Units of heat

Heat is energy, so its SI unit is the joule. An older unit survives in chemistry and nutrition: the calorie, first defined as the heat needed to warm 1 g of water by 1 °C and now fixed at exactly 4.184 J (an older version based on water at 15 °C is 4.186 J). The Calorie with a capital C on food labels is a kilocalorie: 1 Cal = 1000 cal = 4184 J. A 250 Calorie snack supplies about \(1.05 \times 10^6\) J.

Joule and the mechanical equivalent of heat

In the 1840s James Prescott Joule used falling weights to turn a paddle wheel in an insulated tank of water. The churned water warmed by an amount that matched the potential energy the weights had lost, apart from small losses. Doing work on the water had the same effect as heating it, which showed that heat is a transfer of energy, measured in the same units as work. So a warm sample cannot tell you whether it was heated or worked on: rub your hands together and they warm with no flame at all.

Heat and temperature change

With no change of phase and no work done, the heat \(Q\) needed to change an object's temperature is proportional to its mass and to the temperature change, and depends on the material:

Q = mc\Delta T

Here \(c\) is the specific heat capacity, or specific heat: the heat needed to warm 1 kg of the substance by 1 °C. Its unit is J/(kg·°C), the same as J/(kg·K), because a change of 1 °C equals a change of 1 K. With \(\Delta T = T_f - T_i\), \(Q\) is positive when the object warms and gains heat, and negative when it cools and loses heat.

Specific heats and heat capacity

Specific heats are measured, vary a little with temperature and depend on the phase. Approximate values in J/(kg·°C): water 4184, ice 2090, steam 2010, aluminium 900, glass 840, iron and steel 450, copper 385 and lead 128. Water's value is one of the highest of any common substance: a kilogram of water needs about eleven times as much heat as a kilogram of copper for the same warming. For a whole object, \(C = mc\) is its heat capacity, in J/°C: the heat that warms it by 1 °C. A 2.0 kg iron pan has \(C = 900\) J/°C.

Worked example: boiling a kettle

How much heat brings 1.20 kg of water from 18.0 °C to 100.0 °C, and how long does a 2.00 kW kettle take, if all its electrical energy goes into the water? 1. \(\Delta T = 100.0 - 18.0 = 82.0\) °C. 2. Heat: Q = (1.20)(4184)(82.0) = 411,706 J, or \(4.12 \times 10^5\) J. 3. Time, from \(E = Pt\) in the power topic: t = 411,706 ÷ 2000 = 206 s, about 3.4 minutes. 4. Check: about 4 kJ per kilogram per degree gives 4 × 1.2 × 82 ≈ 390 kJ, close to the answer. A real kettle takes a little longer, because it also warms itself and the air.

Worked example: heating by work

Each time a closed tube of lead shot is turned over, the shot falls 1.00 m and stops at the bottom. Assume all the lost potential energy warms the shot, none going to the tube or the air. What is the temperature rise after 50 falls? 1. Set the energy per fall equal to the heating: \(mgh = mc\Delta T\), so the mass cancels and \(\Delta T = gh/c\). 2. Per fall: (9.80)(1.00) ÷ 128 = 0.0766 °C. 3. After 50 falls: 50 × 0.0766 = 3.83 °C. 4. Check: any amount of shot warms equally, and lead's small specific heat makes the rise measurable.

Mixing: heat lost equals heat gained

When a hot object and a cold one share an insulated container, they exchange energy until they reach one final temperature \(T_f\). If no heat escapes and nothing changes phase, the hot object's loss equals the cold one's gain, so the heats add to zero:

m_1c_1(T_f - T_1) + m_2c_2(T_f - T_2) = 0

The hot object's term is negative and the cold one's positive. Solved for the final temperature,

T_f = \frac{m_1c_1T_1 + m_2c_2T_2}{m_1c_1 + m_2c_2}

This is an average weighted by each heat capacity \(mc\). The balance can also be solved for another unknown, such as a specific heat.

Worked example: copper in water

A 0.250 kg copper block at 95.0 °C is dropped into 0.400 kg of water at 20.0 °C in an insulated cup whose own heat capacity is negligible. Find the final temperature. 1. Heat capacities: copper (0.250)(385) = 96.25 J/°C; water (0.400)(4184) = 1673.6 J/°C. 2. Weighted average: T_f = (96.25 × 95.0 + 1673.6 × 20.0) ÷ (96.25 + 1673.6) = 42,616 ÷ 1769.85 = 24.1 °C. 3. Check: copper loses 96.25 × 70.92 ≈ 6.83 kJ; water gains 1673.6 × 4.08 ≈ 6.83 kJ. 4. Reversed, the balance identifies a metal: if 0.200 kg of it at 100.0 °C warms 0.300 kg of water from 20.0 °C to 30.0 °C, then c = (0.300)(4184)(10.0) ÷ [(0.200)(70.0)] = 897 J/(kg·°C), which points to aluminium.

Why water steadies the climate

Water's high specific heat makes it a thermal buffer. A kilogram of water needs about five times as much heat as a kilogram of dry sand (about 800 J/(kg·°C)) for the same warming, and the sea also mixes its heat downwards. So in sunshine the land heats faster, warm air rises above it, and cooler air flows in from the sea: a sea breeze. At night the land cools faster and the breeze reverses. Coastal towns have milder summers and winters than inland ones for the same reason.

Common mistakes to avoid

First, confusing heat with temperature: a large, cooler object can give out more heat than a small hot one. Second, using a final temperature in place of \(\Delta T\). Third, mixing units: specific heats in J/(g·°C) need grams, and J/(kg·°C) needs kilograms. Fourth, treating a food Calorie as a calorie: it is 1000 times larger. Fifth, simply averaging the starting temperatures in a mixing problem, when each object must be weighted by its \(mc\). Sixth, applying \(Q = mc\Delta T\) across a melting or boiling point, where latent heat, the next topic, takes over.

Key takeaways

Heat is energy transferred because of a temperature difference, from hotter to colder, until thermal equilibrium; Joule showed that work changes internal energy in the same way. 1 cal = 4.184 J and 1 food Calorie = 4184 J. With no phase change, Q = mcΔT, with c in J/(kg·°C) and Q positive for heat gained; water's c, 4184, is unusually high. An object's heat capacity is C = mc. In an insulated mixture the heats add to zero, so the final temperature is an average weighted by mc.

Flashcards

Flashcard

Heat

Energy transferred because of a temperature difference

Flows on its own from hotter to colder.

Test your understanding

Question 1 of 5

How much heat is needed to warm 2.00 kg of aluminium (c = 900 J/(kg·°C)) from 20.0 °C to 70.0 °C?

Question 2 of 5

A snack bar is labelled 150 Calories. About how much energy is that in joules?

Question 3 of 5

In an insulated flask, 0.500 kg of water at 80.0 °C is mixed with 1.50 kg of water at 20.0 °C. What is the final temperature?

Question 4 of 5

Equal masses of water and copper each absorb the same amount of heat, with no phase change. Which statement is correct?

Question 5 of 5

Lead shot (c = 128 J/(kg·°C)) falls 1.50 m inside a closed tube each time it is turned over. If all the lost potential energy warms the shot, what is its temperature rise after 20 falls?

← Previous topicNext topic →