Physics › Section R · Electromagnetic waves and geometric optics › Topic R.7

Image formation by mirrors

A bathroom mirror, a magnifying make-up mirror and the bulging security mirror in a shop each form a different kind of image. Curved mirrors obey the same equations as lenses, so once the sign convention is clear, every mirror image can be predicted.

Mirrors everywhere

Mirrors form images by reflection: each ray leaves the surface at the same angle to the normal as it arrived. A flat mirror shows you at full size. A concave mirror, curved inwards like the inside of a spoon, can magnify a face or focus sunlight. A convex mirror, bulging outwards like the back of a spoon, shows a wide but shrunken view, so it is used for wing mirrors and shop security. One set of rules covers all three.

The plane mirror

Rays from a point on an object reflect from a flat mirror and spread out as if they came from a single point behind it. Tracing two reflected rays backwards, equal angles put that point at the same distance behind the glass as the object stands before it. So a plane mirror forms a virtual image that is upright and the same size as the object. No light actually travels behind the glass. The image is reversed front to back, not left to right: your raised right hand stays on the right, but the image faces the opposite way, so it looks like a left hand.

Spherical mirrors and f = R/2

A spherical mirror is part of a sphere with centre of curvature C and radius of curvature \(R\). The axis runs through C and the centre of the mirror, its vertex V. Rays parallel to the axis reflect from a concave mirror through a focal point F, and from a convex mirror they spread as if from a focal point behind it. In both cases

f = \frac{R}{2}

Why: a radius from C to the point P where a parallel ray strikes is the normal there, so the ray reflects at angle \(\theta\) on each side of CP. The angle at C is also \(\theta\), so triangle CFP is isosceles with FC = FP. For rays near the axis, FP is almost FV, so F sits halfway between C and V.

When the sphere is not enough

The result \(f = R/2\) holds for rays close to the axis, so it describes mirrors small compared with their radius of curvature. Rays striking a deep spherical mirror far from the axis cross nearer the mirror and blur the focus: spherical aberration. A parabolic mirror brings all parallel rays to one exact focus, so telescopes and satellite dishes use parabolic shapes. Run backwards, the same idea makes a beam: a bulb at the focus of a concave reflector sends its light out parallel, as in a torch or a car headlight.

Ray diagrams in words

To locate an image, trace two rays from the top of the object. For a concave mirror: a ray parallel to the axis reflects through F; a ray through F reflects parallel to the axis; a ray through C strikes along a normal and reflects straight back; and a ray hitting the vertex leaves mirrored across the axis. For a convex mirror: a parallel ray reflects as if from F behind the mirror, a ray aimed at that F reflects parallel to the axis, and the vertex ray behaves as before. The image is where the reflected rays cross in front of the mirror, or where their extensions cross behind it.

Same equations, mirror signs

Mirrors use the same two equations as thin lenses:

\frac{1}{f} = \frac{1}{d_o} + \frac{1}{d_i} \qquad m = -\frac{d_i}{d_o}

The sign convention: the real side of a mirror is in front, where the light returns. \(d_o\) is positive for an ordinary object. \(d_i\) is positive for a real image in front of the mirror and negative for a virtual image behind it. \(f\) and \(R\) are positive for a concave mirror and negative for a convex mirror, so \(f = R/2\) holds with signs. A positive \(m\) means upright, a negative \(m\) inverted. A plane mirror is the limit of a huge \(R\): \(1/f\) becomes zero, giving \(d_i = -d_o\) and \(m = +1\).

Worked example: a real image from a concave mirror

An object stands 30.0 cm in front of a concave mirror with \(R = 40.0\) cm. Find the image. 1. Focal length: \(f = R/2 = +20.0\) cm. 2. Rearrange: \(1/d_i = 1/f - 1/d_o = 1/20.0 - 1/30.0\), which is \(0.01667\) cm⁻¹, so \(d_i = +60.0\) cm. 3. Positive, so the image is real, 60.0 cm in front of the mirror. 4. Magnification: \(m = -60.0/30.0 = -2.00\), inverted and twice the height. 5. Check with rays: the object is between F (20.0 cm) and C (40.0 cm); the parallel ray reflects through F, the ray through C returns on itself, and they cross beyond C, below the axis.

Worked example: a make-up mirror

A concave make-up mirror has \(f = 25.0\) cm, and a face is 15.0 cm from it. Find the image. 1. \(1/d_i = 1/25.0 - 1/15.0 = -0.02667\) cm⁻¹, so \(d_i = -37.5\) cm. 2. Negative, so the image is virtual, 37.5 cm behind the mirror. 3. Magnification: \(m = -(-37.5)/15.0 = +2.50\), upright and two and a half times as large. 4. Check: with the face inside the focal length, the reflected rays spread apart as if from a point behind the glass, just as with a magnifying glass. Beyond 25.0 cm the image would turn upside down.

Worked example: a convex wing mirror

A convex wing mirror has a radius of curvature of magnitude 1.60 m. A following car is 10.0 m from the mirror. Find the image. 1. Convex, so \(R = -1.60\) m and \(f = -0.800\) m. 2. \(1/d_i = 1/(-0.800) - 1/10.0 = -1.350\) m⁻¹, so \(d_i = -0.741\) m, a virtual image behind the mirror. 3. Magnification: \(m = -(-0.741)/10.0 = +0.0741\), upright and much smaller. 4. Check: a convex mirror always gives a small, upright, virtual image inside its focal length. The small image looks like a distant car, hence the warning that objects are closer than they appear.

Concave and convex compared

A concave mirror behaves like a converging lens, except that its real images form in front of it, on the same side as the object. Object beyond C: real, inverted and smaller, between F and C. Object at C: real, inverted, same size, at C. Object between C and F: real, inverted and larger, beyond C. Object at F: the light leaves parallel and no image forms. Object inside F: virtual, upright and larger, behind the mirror. A convex mirror behaves like a diverging lens: for any object it gives a virtual, upright, smaller image behind the mirror, closer than the focal point.

Common mistakes to avoid

First, using \(R\) in place of \(f\): halve the radius of curvature first. Second, giving a convex mirror a positive focal length: convex mirrors have negative \(f\) and \(R\). Third, carrying over the lens picture of where real images form: for a mirror, a real image with positive \(d_i\) is in front, on the object's side, and a virtual image is behind. Fourth, adding \(1/f\) and \(1/d_o\) instead of subtracting. Fifth, saying a plane mirror swaps left and right: it reverses front and back.

Key takeaways

A plane mirror forms a virtual, upright, same-size image at the object's distance behind the glass. A spherical mirror has f = R/2, with f and R positive for concave and negative for convex mirrors. The thin-lens equations, 1/f = 1/d_o + 1/d_i and m = −d_i/d_o, apply to mirrors. Positive d_i is a real image in front of the mirror; negative d_i is a virtual image behind it. Concave mirrors act like converging lenses: real, inverted images beyond F, magnified virtual images inside F. Convex mirrors act like diverging lenses: always virtual, upright and smaller.

Flashcards

Flashcard

Law of reflection

Angle of reflection equals angle of incidence, both from the normal

Every mirror image follows from it.

Test your understanding

Question 1 of 5

An object is 45.0 cm in front of a concave mirror whose radius of curvature is 30.0 cm. Using the sign convention in this topic, what is the image distance?

Question 2 of 5

A convex mirror has a focal length of −20.0 cm, and an object stands 20.0 cm from it. Using the sign convention in this topic, which describes the image?

Question 3 of 5

You stand 1.50 m in front of a flat wall mirror. How far are you from your image?

Question 4 of 5

A face is 20.0 cm from a concave make-up mirror of focal length 30.0 cm. What is the magnification?

Question 5 of 5

A convex security mirror has a radius of curvature of magnitude 1.20 m. Using the sign convention in this topic, what is its focal length?

← Previous topicNext topic →