Physics › Section O · Current and circuits › Topic O.9
RC circuits
Put a resistor in series with a capacitor and the circuit acquires a sense of time: the capacitor charges and discharges gradually, at a pace set by a single number. That idea times blinking lights, wiper pauses and the first heart pacemakers.
Circuits that change with time
Every circuit so far has been steady: once switched on, its currents stayed constant. A capacitor changes that. It cannot charge instantly through a resistor, because the resistor limits how fast charge can arrive, so the current and voltages change smoothly over time after a switch is closed or opened. An RC circuit is a resistor \(R\) and a capacitor \(C\) together, usually with a battery and a switch. The earlier topics on capacitors gave \(Q = CV\) and the stored energy \(\tfrac{1}{2}CV^2\); here we add time. Throughout, the battery is ideal and the capacitor starts uncharged unless stated.
Charging: the story
Close the switch on a battery of emf \(\mathcal{E}\), a resistor and an uncharged capacitor in series. At first the capacitor has no charge and so no voltage across it, so the whole emf is across the resistor and the current starts at its maximum, \(I_0 = \mathcal{E}/R\). The capacitor behaves, for that instant, like a plain wire. As charge builds up, the capacitor's voltage \(V_C = q/C\) grows and opposes the battery, leaving less voltage across the resistor, so the current falls and the charging slows. The loop rule holds at every moment: \(\mathcal{E} = IR + q/C\). Eventually \(V_C = \mathcal{E}\), the current is zero, and the capacitor holds \(Q = C\mathcal{E}\), behaving like a break in the circuit.
Charging: the equations
The growth follows an exponential curve. Stated without proof, the capacitor voltage and the current during charging are
where \(e \approx 2.718\) is the base of natural logarithms. The charge follows the voltage, \(q = C V_C\). The product \(RC\) is the time constant, \(\tau = RC\). Its units are seconds, because \(\Omega \cdot \mathrm{F} = (\mathrm{V/A})(\mathrm{C/V}) = \mathrm{C/A} = \mathrm{s}\). A larger resistance slows the flow of charge, and a larger capacitance needs more charge, so either one lengthens the time constant. A 10 kΩ resistor with a 100 μF capacitor gives \(\tau = 1.0\) s.
Landmarks of the time constant
Putting \(t = \tau, 2\tau, 3\tau, \ldots\) into the charging equation gives values worth remembering. After one time constant the capacitor reaches \(1 - e^{-1} = 63.2\%\) of its final voltage, and the current has fallen to \(e^{-1} = 36.8\%\) of its starting value. After \(2\tau\) it is at 86.5%, after \(3\tau\) at 95.0%, and after \(5\tau\) at 99.3%. In principle it never quite finishes, but after about five time constants it is full for all practical purposes. Each further time constant closes 63.2% of whatever gap remains, which is the defining pattern of exponential change.
Worked example: charging a timing capacitor
A 9.00 V battery charges a 220 μF capacitor through a 47.0 kΩ resistor. Find the time constant, the starting current, the voltage after 5.00 s, and when the voltage reaches 6.00 V. 1.
2. \(I_0 = \mathcal{E}/R = 9.00/47{,}000\), which is 0.191 mA. 3. At 5.00 s:
4. For 6.00 V: \(1 - e^{-t/\tau} = 2/3\), so \(e^{-t/\tau} = 1/3\) and, taking natural logarithms, \(t = \tau\ln 3 = 11.4\) s. 5. Check: 6.00 V is 66.7% of 9.00 V, a little beyond the 63.2% reached at one time constant, and 11.4 s is a little beyond 10.3 s.
Discharging
Now disconnect the battery and let a charged capacitor discharge through a resistor. It starts at voltage \(V_0\), drives a current \(V_0/R\) through the resistor in the opposite direction to the charging current, and both decay together:
After one time constant only 36.8% of the voltage remains; after \(3\tau\), about 5%; after \(5\tau\), under 1%. The time to fall to half is \(t_{1/2} = \tau\ln 2 = 0.693\tau\), and every further \(t_{1/2}\) halves it again, the same pattern as radioactive decay in a later topic.
Worked example: a bleeder resistor
Power supplies often fit a resistor across their large capacitors so that the stored charge drains away after switch-off. A 470 μF capacitor charged to 160 V discharges through a 100 kΩ bleeder. Find the time constant, the voltage after 60.0 s, and how long it takes to fall to 5.0 V. 1.
2. At 60.0 s: \(V = 160e^{-60.0/47.0} = 44.6\) V. 3. For 5.0 V: \(e^{-t/\tau} = 5.0/160\), so \(t = \tau\ln 32 = 47.0 \times 3.47 = 163\) s, nearly 3 minutes. 4. Check: 160 V halves five times to reach 5.0 V, and \(5 \times 0.693 \times 47.0 = 163\) s.
Where the energy goes
The bleeder's capacitor stored
and discharging turns all of it into heat in the resistor. Charging has a surprise. The battery moves charge \(Q = C\mathcal{E}\) through its emf, so it supplies energy \(Q\mathcal{E} = C\mathcal{E}^2\), but the capacitor ends up storing only \(\tfrac{1}{2}C\mathcal{E}^2\). The other half is dissipated in the resistor, whatever its value: a smaller \(R\) means a larger current for a shorter time, and the total heat comes out the same.
RC circuits at work
Because the time constant can be set simply by choosing \(R\) and \(C\), RC circuits are used wherever a delay or a rhythm is needed. In a simple flasher, a capacitor charges through a resistor until its voltage reaches the level at which a lamp or switching component conducts; the capacitor then discharges quickly, the device switches off, and the cycle repeats, with a period set by \(RC\). Intermittent windscreen wipers use an adjustable resistor to change the pause. Early pacemakers used RC timing to set the beat. RC combinations also act as filters, smoothing out rapid changes in a signal while passing slow ones.
Common mistakes to avoid
First, mixing up the charging and discharging forms: charging uses \(1 - e^{-t/\tau}\), discharging uses \(e^{-t/\tau}\). Second, forgetting prefixes: μF is \(10^{-6}\) F and kΩ is \(10^3\ \Omega\), so 47.0 kΩ and 220 μF give 10.3 s, not 10,340 s. Third, thinking the capacitor is half charged after one time constant; it is at 63.2%, and half takes \(0.693\tau\). Fourth, saying no current flows when the switch first closes; the current is largest then. Fifth, believing a capacitor is ever exactly full or empty; after \(5\tau\) it is within 1%.
Key takeaways
An RC circuit charges and discharges gradually, with time constant τ = RC in seconds. Charging: V_C = ε(1 − e^(−t/RC)) and I = (ε/R)e^(−t/RC); the current starts at ε/R and falls to zero as the capacitor reaches ε. Discharging: V_C = V₀e^(−t/RC). After one τ, charging reaches 63.2% and discharging leaves 36.8%; after about 5τ the change is over 99% complete. The half-time is 0.693τ. Charging through a resistor dissipates as much energy as the capacitor stores. RC circuits time flashers, wipers and early pacemakers, and filter signals.
Flashcards
Flashcard
A resistor and a capacitor that charge or discharge over time
Test your understanding
Question 1 of 5
What is the time constant of a circuit with a 2.0 kΩ resistor and a 50 μF capacitor?
Question 2 of 5
An uncharged capacitor is charged through a resistor by a 9.0 V battery. What is the capacitor's voltage after one time constant?
Question 3 of 5
A charged capacitor discharges through a resistor. What fraction of its initial voltage remains after three time constants?
Question 4 of 5
A switch connects a 12.0 V battery, a 4.0 kΩ resistor and an uncharged capacitor in series. What current flows the instant the switch closes?
Question 5 of 5
A capacitor discharges through a resistor with a time constant of 47.0 s. How long does its voltage take to fall to half its starting value?
