Physics › Section H · Fluids › Topic H.7
Viscosity, Poiseuille's law, and turbulence
Real fluids are sticky: syrup pours slowly, and water needs a push to flow along a pipe. Viscosity measures that stickiness, Poiseuille's law shows how strongly a tube's width controls flow, and the Reynolds number predicts when smooth flow breaks into turbulence.
Fluids with friction
Bernoulli's equation ignores internal friction, but real fluids have it, and the property is called viscosity: juice pours freely, while syrup clings and oozes because its viscosity is far higher. In laminar flow the fluid moves in smooth layers that slide past one another without mixing, and the streamlines stay neat. In turbulent flow the layers break up into eddies and swirls that mix the fluid. Smoke rising from a snuffed candle shows both: a smooth column at first, then a sudden tangle of curls.
Measuring viscosity
Trap a thin layer of fluid, of thickness \(L\), between two plates of area \(A\). Hold the bottom plate still and slide the top one at speed \(v\). The fluid touching each plate moves with that plate, so the fluid's speed varies smoothly from \(v\) to zero across the gap. For laminar flow the force needed is
which defines the coefficient of viscosity \(\eta\) (Greek eta). Its SI unit is the pascal-second, \(\text{Pa} \cdot \text{s}\). Water at 20 °C has \(\eta \approx 1.0 \times 10^{-3}\ \text{Pa} \cdot \text{s}\), air about \(1.8 \times 10^{-5}\ \text{Pa} \cdot \text{s}\), whole blood at body temperature roughly 3 to 4 millipascal-seconds, and honey several pascal-seconds.
Viscosity and temperature
Viscosity changes a great deal with temperature, and liquids and gases behave in opposite ways. Heating a liquid lowers its viscosity: water at 37 °C has about 0.69 times its viscosity at 20 °C, and cold engine oil is so thick that the oil-pressure gauge reads high until the engine warms up. Heating a gas raises its viscosity, because its faster molecules carry more momentum between neighbouring layers. Because the fluid touching a wall is held at rest and viscosity passes that drag inwards, a viscous fluid in a pipe moves fastest along the centre line and is at rest right against the wall.
Pressure drives flow against resistance
A fluid flows along a horizontal pipe only if the pressure at one end exceeds the pressure at the other, and it flows from high pressure to low. The flow rate is
where \(R\) is the resistance to flow, which includes everything about the pipe and fluid except the pressure. Read the other way round, \(P_1 - P_2 = QR\): a flow through a resistance causes a pressure drop. That is why water pressure in a house can sag when the whole street is running taps; a large flow along the water main loses more pressure on the way.
Poiseuille's law
For steady laminar flow of an incompressible fluid through a long, rigid, horizontal tube of uniform radius \(r\) and length \(L\), the resistance is
so the flow rate is
This is Poiseuille's law. More push gives more flow, while a thicker fluid or a longer tube gives less, as you would expect. The surprise is the fourth power of the radius. Double a tube's radius and, with everything else fixed, the flow rises by a factor of \(2^4 = 16\).
Worked example: a slightly narrower artery
Deposits narrow an artery so its radius is 20% smaller. Assuming laminar flow and the same length and viscosity, by what factor must the pressure difference rise to keep the blood flow the same? 1. Poiseuille's law: \(Q \propto r^4 \Delta P\), so for equal flow \(r_1^4 \Delta P_1 = r_2^4 \Delta P_2\). 2. With \(r_2 = 0.80\, r_1\): \(\Delta P_2 / \Delta P_1 = 1 / 0.80^4\). 3. \(0.80^4 = 0.410\), so the factor is \(1 \div 0.410 = 2.44\). 4. Check the other way: at the old pressure the flow would fall to 41% of normal. Such sensitivity is why the body controls blood flow mainly by widening and narrowing its vessels.
Worked example: a thin tube
Water at 20 °C (\(\eta = 1.00 \times 10^{-3}\ \text{Pa} \cdot \text{s}\)) flows through a thin tube of radius 0.50 mm and length 10.0 cm, with a pressure difference of 2000 Pa between its ends. Find the flow rate. 1. Convert: \(r = 5.0 \times 10^{-4}\) m and \(L = 0.100\) m. 2. \(r^4 = 6.25 \times 10^{-14}\ \text{m}^4\). 3.
about 29 mL per minute. 4. Mean speed: \(v = Q/(\pi r^2) = 0.63\) m/s. The card after next checks that this flow really is laminar, as Poiseuille's law requires.
The Reynolds number
Whether flow in a tube is laminar or turbulent depends on a dimensionless quantity, the Reynolds number:
where \(v\) is the mean speed and \(r\) the radius, so \(2r\) is the diameter. Approximately, flow is laminar for \(N_R\) below about 2000 and turbulent above about 3000; in between it is unstable and can flip between the two, depending on roughness and disturbances. Some sources put the upper limit nearer 4000. Turbulence is favoured by high speed, wide tubes, dense fluids, low viscosity and obstructions, and it raises the resistance far above the Poiseuille value.
Worked example: laminar or turbulent?
Classify two water flows, using \(\rho = 1.00 \times 10^3\ \text{kg/m}^3\) and \(\eta = 1.00 \times 10^{-3}\ \text{Pa} \cdot \text{s}\). 1. The thin tube from the previous example: diameter \(1.0 \times 10^{-3}\) m and \(v = 0.625\) m/s, so
That is well below 2000, so the flow is laminar and Poiseuille's law applies. 2. A household pipe of diameter 2.0 cm carrying water at 1.5 m/s:
That is far above 3000, so the flow is turbulent, as in most household plumbing.
Objects moving through a fluid
A ball moving through still air feels the same flow as a still ball in a wind. A Reynolds number can be defined for the object as well, using its size, such as a sphere's diameter. When it is small, roughly 1 or less, as for pollen, fine dust or blood cells in plasma, the fluid flows smoothly round the object and the drag is proportional to speed, as in Stokes's law from the drag topic. For balls, cars and people the number is thousands to millions, a turbulent wake forms behind the object, and the drag grows roughly as \(v^2\). Either way, a falling object reaches a terminal speed when drag and buoyancy together balance its weight.
Common mistakes to avoid
First, treating the radius as if it entered Poiseuille's law to the first or second power: it is the fourth, so small changes in radius matter enormously. Second, using the diameter where the formula needs the radius, which makes \(r^4\) sixteen times too large. Third, applying Poiseuille's law to turbulent flow; check the Reynolds number first. Fourth, assuming viscosity always falls with temperature: that is true for liquids, but gases become more viscous when heated. Fifth, quoting viscosity in the wrong unit; the SI unit is the pascal-second.
Key takeaways
Viscosity η is internal friction, defined by F = ηvA/L and measured in Pa·s; liquids get runnier when heated, gases more viscous. Flow needs a pressure difference: Q = (P₁ − P₂)/R. Poiseuille's law, R = 8ηL/(πr⁴), makes Q proportional to r⁴, so doubling the radius gives 16 times the flow. The Reynolds number N_R = 2ρvr/η predicts the flow type: laminar below about 2000, turbulent above about 3000. Small, slow objects feel drag proportional to v; large, fast ones feel drag roughly proportional to v².
Flashcards
Flashcard
A fluid's internal friction
Test your understanding
Question 1 of 5
The radius of a tube is doubled while the pressure difference, length and fluid stay the same. By what factor does the laminar flow rate change?
Question 2 of 5
Water (density 1000 kg/m³, viscosity 1.0 × 10⁻³ Pa·s) flows at 0.10 m/s through a tube of diameter 1.0 cm. What is the Reynolds number, and what type of flow is it?
Question 3 of 5
A blood vessel's radius shrinks by 10% while the pressure difference stays the same. Assuming laminar flow, what fraction of the original flow remains?
Question 4 of 5
Which single change increases the laminar flow through a tube the most?
Question 5 of 5
How do the viscosities of a liquid and a gas change when each is heated?
