Physics › Section H · Fluids › Topic H.6

Bernoulli's equation and its uses

When a fluid speeds up, something must push it, so its pressure has to change. Bernoulli's equation is conservation of energy written for a flowing fluid, and it links pressure, speed and height in pipes, tanks, spray bottles and aircraft.

Where does the extra speed come from?

Continuity says a liquid speeds up as it enters a narrower pipe. Speeding up needs a net force, and in a level pipe that force can only come from the surrounding fluid, so the pressure behind each parcel must exceed the pressure ahead of it. The parcel gains speed as it moves from higher to lower pressure. So in steady, level flow, wherever the fluid moves faster, its pressure is lower. Bernoulli's equation makes this exact and adds the effect of height.

Bernoulli's equation and its assumptions

Along a streamline,

P + \tfrac{1}{2}\rho v^2 + \rho g h = \text{constant}

where \(P\) is the pressure, \(\rho\) the density, \(v\) the speed and \(h\) the height above any chosen reference level. Between two points 1 and 2 on the same streamline,

P_1 + \tfrac{1}{2}\rho v_1^2 + \rho g h_1 = P_2 + \tfrac{1}{2}\rho v_2^2 + \rho g h_2

The equation is derived for an idealised fluid and holds only when four assumptions are met: the flow is steady, the fluid is incompressible, it has no viscosity (no internal friction), and both points lie on the same streamline. Real water and slow-moving air come close; honey and turbulent flow do not. Daniel Bernoulli set out the idea in his 1738 book Hydrodynamica; Leonhard Euler later gave the equation its modern form.

Energy per unit volume

Each term is an energy per unit volume. Dividing kinetic energy \(\tfrac{1}{2}mv^2\) by volume, with \(m/V = \rho\), gives \(\tfrac{1}{2}\rho v^2\); dividing \(mgh\) by volume gives \(\rho g h\). Pressure fits too, because \(1\ \text{Pa} = 1\ \text{N/m}^2 = 1\ \text{J/m}^3\). So Bernoulli's equation is the work-energy theorem for a fluid: net work done by pressure forces changes the kinetic and gravitational potential energy. With the fluid at rest, \(v = 0\), it reduces to \(P_2 = P_1 + \rho g h\) for a point a depth \(h\) lower, the pressure-depth rule from fluid statics.

Bernoulli's principle

When the height is constant, the \(\rho g h\) terms cancel and

P_1 + \tfrac{1}{2}\rho v_1^2 = P_2 + \tfrac{1}{2}\rho v_2^2

This special case is often called Bernoulli's principle: at the same height, faster flow goes with lower pressure. An atomiser or paint sprayer blows a fast jet of air across the top of a tube dipped in liquid. The pressure at the jet falls below atmospheric, and the higher air pressure on the liquid's surface pushes it up the tube into the stream, where it breaks into droplets. A laboratory water aspirator uses a fast water stream to suck air from a flask in the same way, and wind across a chimney top helps draw smoke up.

Worked example: a narrowing pipe

Water (density \(1.00 \times 10^3\ \text{kg/m}^3\)) flows through a horizontal pipe whose area falls from 30.0 cm² to 10.0 cm². In the wide part the speed is 1.20 m/s and the absolute pressure is \(1.50 \times 10^5\) Pa. Find the pressure in the narrow part, treating the water as ideal. 1. Continuity: \(v_2 = v_1 A_1 / A_2 = 1.20 \times 3.00 = 3.60\) m/s. 2. Bernoulli's principle: \(P_2 = P_1 - \tfrac{1}{2}\rho(v_2^2 - v_1^2)\). 3. Substitute: \(\tfrac{1}{2}(1000)(12.96 - 1.44) = 5760\) Pa, so \(P_2\) is \(1.50 \times 10^5 - 5760\), which is \(1.44 \times 10^5\) Pa. 4. Check: the water speeds up, so its pressure must fall, and it does, by about 4%.

Measuring flow speed

Measuring a pressure difference gives a speed. A Venturi meter is a pipe with a smooth constriction; the pressure drop between its wide and narrow parts, with continuity and Bernoulli's principle, gives the flow rate. A pitot tube, an airspeed indicator on aircraft, compares the pressure in an opening facing the flow, where the air is brought to rest, with that at side openings the air streams past at speed \(v\). The difference is \(\Delta P = \tfrac{1}{2}\rho v^2\), so \(v = \sqrt{2\Delta P/\rho}\). A difference of 600 Pa in air of density \(1.20\ \text{kg/m}^3\) means \(v = \sqrt{1000} = 31.6\) m/s.

How a wing makes lift

A wing set at a small angle to the oncoming air, usually with a curved profile, turns the air passing it downwards. By Newton's third law, the air pushes the wing upwards. The same fact can be described with pressure: the curved flow leaves the pressure above the wing lower than the pressure below, and the air over the top moves faster, as Bernoulli's principle requires. Both descriptions are correct. One popular explanation is wrong: it claims air over the top must rejoin the air from underneath at the trailing edge. Nothing forces that, and measurements show the upper air actually arrives first.

Worked example: a draining tank

A large open tank has a small hole in its side 1.80 m below the water surface. Find the speed of the emerging water. Assume an ideal fluid and a tank wide enough that the surface falls negligibly slowly. 1. Point 1 is the surface and point 2 the hole; both are open to the air, so \(P_1 = P_2\) and the pressures cancel. 2. With \(v_1 \approx 0\): \(\rho g h_1 = \tfrac{1}{2}\rho v_2^2 + \rho g h_2\). 3. Density cancels, and with \(h = h_1 - h_2 = 1.80\) m,

v_2 = \sqrt{2gh} = \sqrt{2(9.80)(1.80)} = 5.94\ \text{m/s}

4. Check: this is Torricelli's theorem, and it matches the speed of a stone dropped 1.80 m from rest.

Worked example: water to a top floor

A water pipe of diameter 2.50 cm carries water at 1.00 m/s at ground level, at a gauge pressure of \(3.00 \times 10^5\) Pa. It rises 12.0 m and narrows to 1.25 cm. Find the gauge pressure at the top, ignoring friction. 1. Continuity: halving the diameter quarters the area, so \(v_2 = 4.00\) m/s. 2. Solve Bernoulli's equation for \(P_2\), with \(h_1 = 0\):

P_2 = P_1 + \tfrac{1}{2}\rho(v_1^2 - v_2^2) - \rho g h_2

3. Speed term: \(500(1.00 - 16.0) = -7500\) Pa. Height term: \(1000(9.80)(12.0) = 1.176 \times 10^5\) Pa. 4.

P_2 = 3.00 \times 10^5 - 7500 - 1.176 \times 10^5 = 1.75 \times 10^5\ \text{Pa}

gauge. 5. Check: rising and speeding up both cost pressure, and most of the drop comes from the height.

Power in fluid flow

Each Bernoulli term is joules per cubic metre, and a flow rate is cubic metres per second, so their product is joules per second: power. A pump that raises the pressure of a flow \(Q\) by \(\Delta P\), without changing its speed or height, supplies

\text{power} = Q \, \Delta P

A fire-engine pump that raises the pressure of 0.020 m³/s of water by \(4.0 \times 10^5\) Pa gives the water 8.0 kW. In units, \(\text{Pa} \times \text{m}^3/\text{s} = \text{N} \cdot \text{m/s} = \text{W}\).

Common mistakes to avoid

First, forgetting the \(\tfrac{1}{2}\) in the kinetic term, which doubles every pressure change. Second, subtracting the speeds before squaring: the term is \(v_2^2 - v_1^2\), not \((v_2 - v_1)^2\). Third, mixing gauge and absolute pressures in one equation; either works if you use the same kind at both points. Fourth, using Bernoulli's equation where its assumptions fail, such as viscous flow in a long, thin tube or turbulent flow. Fifth, explaining lift by "equal transit time": the air over a wing is not required to meet the air underneath.

Key takeaways

Bernoulli's equation, P + ½ρv² + ρgh = constant along a streamline, is energy conservation per unit volume for steady, incompressible, non-viscous flow. At constant height it gives Bernoulli's principle, faster flow with lower pressure, which explains atomisers, Venturi meters and pitot tubes. A wing turns air downwards, leaving lower pressure above it. Torricelli: v = √(2gh). A pump supplies power Q × ΔP.

Flashcards

Flashcard

Bernoulli's equation

P + ½ρv² + ρgh = constant along a streamline

Energy conservation per unit volume.

Test your understanding

Question 1 of 5

Water (density 1000 kg/m³) speeds up from 2.0 m/s to 6.0 m/s in a horizontal pipe. Treating it as an ideal fluid, by how much does its pressure fall?

Question 2 of 5

Water leaves a small hole 5.0 m below the surface of a large open tank. Ignoring friction, what is its speed?

Question 3 of 5

Which statement best explains how an aircraft wing produces lift?

Question 4 of 5

In which situation is Bernoulli's equation least reliable?

Question 5 of 5

A pitot tube in air of density 1.20 kg/m³ records a pressure difference of 960 Pa. What is the airspeed?

← Previous topicNext topic →