Calculus › Section H · Applications of integrals › Topic H.6

Moments, centres of mass, and centroids

Balancing a see-saw is moments in disguise: mass times distance, added on both sides until the sums match. This topic turns balancing into calculus — moments for point masses, then for flat plates where the sums become integrals — and delivers the centre of mass, the centroid, and Pappus's volume theorem.

Balancing acts

Why does a see-saw balance when a light child sits far out and a heavy adult sits close in? Mass and position trade against each other, and the quantity that measures the trade is the moment: mass times distance. First, a few point masses on a line. Second, point masses scattered in a plane, needing two moments at once. Third, a flat plate, where the masses become infinitely many and the sums become integrals. The rewards are the centre of mass, the centroid, and Pappus's volume theorem.

Moments along a line

A mass \(m\) sitting at position \(x\) on a wire has moment \(mx\) about the origin — the mass weighted by its signed distance. For several masses, moments add: \(M = \sum m_i x_i\), where positions left of the origin count as negative. The balance point \(\bar{x}\) is where a single support holds the whole system level:

\bar{x} = \frac{M}{m} = \frac{\sum m_i x_i}{\sum m_i}

It is a weighted average of the positions, with each mass pulling the balance point toward itself. The check that makes the name honest: computing moments about \(\bar{x}\) itself gives \(\sum m_i(x_i - \bar{x}) = 0\) — the weights cancel exactly. Moments carry units of mass times length, kilograms times metres.

Worked example: two masses on a beam

A 2-kilogram mass sits at \(x = -1\) on a light beam and a 6-kilogram mass sits at \(x = 3\). Where does the beam balance? Total mass \(m = 2 + 6 = 8\) kg, total moment \(M = 2(-1) + 6(3) = -2 + 18 = 16\) kg·m, so

\bar{x} = \frac{16}{8} = 2

The support goes at \(x = 2\). Check by taking moments about that point: \(2(-1 - 2) + 6(3 - 2) = -6 + 6 = 0\). Notice the balance point sits closer to the heavier mass — three times as close, exactly as the mass ratio 6 to 2 predicts.

From a line to a plane

Masses scattered in a plane can tip forward and back and also left and right, so each mass carries two moments, one about each axis. The moment about the \(y\)-axis, \(M_y = \sum m_i x_i\), collects horizontal distances: it measures the tendency to rotate about the vertical axis. The moment about the \(x\)-axis, \(M_x = \sum m_i y_i\), collects vertical ones. The centre of mass is

(\bar{x}, \bar{y}) = \left(\frac{M_y}{m}, \; \frac{M_x}{m}\right)

Mind the crossing subscripts: \(M_y\) is built from \(x\)-coordinates, because rotation about the \(y\)-axis responds to horizontal distance. Pin the plane through \((\bar{x}, \bar{y})\) and the moments about the pin vanish in both directions.

Laminas: from sums to integrals

A lamina is a thin flat plate covering a region, with constant density \(\rho\) — mass per unit area. Take the region between a top curve \(f(x)\) and a bottom curve \(g(x)\) for \(a \le x \le b\), and slice it into vertical strips of width \(dx\). The strip at \(x\) is a thin rectangle of height \(f(x) - g(x)\): its mass is \(\rho\,[f(x) - g(x)]\,dx\), acting at its midpoint height \(\frac{f(x) + g(x)}{2}\). Summing over all strips turns the sums into integrals:

m = \rho\int_a^b [f(x) - g(x)]\,dx, \quad M_x = \frac{\rho}{2}\int_a^b \left([f(x)]^2 - [g(x)]^2\right)\,dx, \quad M_y = \rho\int_a^b x[f(x) - g(x)]\,dx

The same ratios \(\bar{x} = M_y/m\) and \(\bar{y} = M_x/m\) then locate the balance point.

Worked example: centroid under a parabola

Find the balance point of the region under \(y = 4 - x^2\) and above the \(x\)-axis, taking \(\rho = 1\). The curve meets the axis at \(x = \pm 2\). First the mass, which here is just the area:

m = \int_{-2}^{2}(4 - x^2)\,dx = 2\left[4x - \tfrac{x^3}{3}\right]_0^2 = 2\left(8 - \tfrac{8}{3}\right) = \tfrac{32}{3}

The region is symmetric about the \(y\)-axis, so \(\bar{x} = 0\) with no integration at all. For the height, each strip runs from \(g = 0\) up to \(f = 4 - x^2\):

M_x = \tfrac{1}{2}\int_{-2}^{2}(4 - x^2)^2\,dx = \tfrac{1}{2}\left[16x - \tfrac{8x^3}{3} + \tfrac{x^5}{5}\right]_{-2}^{2} = \tfrac{1}{2}\cdot\tfrac{512}{15} = \tfrac{256}{15}

so \(\bar{y} = M_x/m = \tfrac{256}{15}\cdot\tfrac{3}{32} = \tfrac{8}{5}\). The balance point \((0, 1.6)\) sits below mid-height — right, since the parabola is widest near the bottom.

The symmetry principle

When the density is constant, the balance point depends only on the shape of the region, and it earns its own name: the centroid. Symmetry then does the work that integrals would. The symmetry principle says that if a region is symmetric about a line, its centroid lies on that line; and if two symmetry lines cross, the centroid sits at their crossing. A circle's centroid is its centre; a rectangle's is where its diagonals meet; the region under \(y = 4 - x^2\) had its \(\bar{x}\) handed to us for free. One warning: the centroid need not lie inside the region — a horseshoe's centroid floats in the open air of its gap.

Worked example: Pappus and the doughnut

Pappus's theorem links centroids to volumes: rotate a plane region about a line in its plane that the region never crosses, and the solid swept out has volume

V = 2\pi d\,A

where \(A\) is the region's area and \(d\) is the distance from the axis to the centroid, which rides a circle of radius \(d\), travelling \(2\pi d\). Spin a circle of radius 2 metres about an axis 5 metres from its centre: the region's area is \(\pi(2)^2 = 4\pi\), so

V = 2\pi(5)(4\pi) = 40\pi^2 \approx 395\ \text{m}^3

Cross-check with the standard torus formula \(2\pi^2 R r^2\) at \(R = 5, r = 2\): again \(40\pi^2\). The axis must stay outside the region, or \(d\) stops measuring one clean travelled circle.

Centres of mass in the real world

Engineers track centres of mass constantly. A car corners safely when its centre of mass is low: the lower it sits, the larger the sideways force needed to tip the car over its outer wheels, so the tyres lose grip long before the car could roll. Crane operators place counterweights so that the machine's balance point stays inside its support base; a heavy load far out on the boom shifts it outward, and the calculation is redone with one more moment term. In each case the method is the one built here: split the object into pieces whose individual balance points are obvious, and let moments add the pieces up.

Common mistakes to avoid

The classic slip is crossing the subscripts wrongly: \(M_y\) is built from \(x\)-coordinates and \(M_x\) from \(y\)-coordinates, so \(\bar{x} = M_y/m\) really does pair an \(x\) with a \(y\) — write the pair out and confirm the crossing is deliberate. In lamina integrals, do not lose the \(\tfrac{1}{2}\) in \(M_x\): each strip's mass acts at its midpoint height, which is what produces half the difference of squares. Do not compute \(\bar{y}\) as the average height of the boundary curve: under \(y = 4 - x^2\) that average is \(\frac{8}{3}\), but \(\bar{y} = \frac{8}{5}\), because \(M_x\) weights each strip by its mass and its midpoint. And in Pappus's theorem, \(d\) runs from the axis to the centroid, never to the nearest edge, and the axis must not cut the region.

Key takeaways

A moment is mass times signed distance, and moments add. On a line, \(\bar{x} = \frac{\sum m_i x_i}{\sum m_i}\). In a plane, \(\bar{x} = M_y/m\) and \(\bar{y} = M_x/m\), with \(M_y = \sum m_i x_i\) and \(M_x = \sum m_i y_i\) — subscripts crossed on purpose. For a lamina of density \(\rho\) between \(f\) and \(g\): mass \(\rho\int(f-g)\,dx\), \(M_x = \tfrac{\rho}{2}\int(f^2 - g^2)\,dx\), \(M_y = \rho\int x(f-g)\,dx\). At constant density the balance point depends on shape alone — the centroid — and lines of symmetry locate it for free. Pappus's theorem turns rotation into volume: \(V = 2\pi dA\) about an external axis.

Flashcards

Flashcard

Moment (on a line)

Mass times signed distance, mx

Positions left of the origin count negative.

Test your understanding

Question 1 of 5

A 4-kilogram mass sits at x = 1 on a light beam and an 8-kilogram mass sits at x = 4. Where should the support go so the beam balances?

Question 2 of 5

For a lamina of density ρ between y = f(x) on top and y = g(x) below, which integral gives the moment M_x about the x-axis?

Question 3 of 5

A flat plate's shape is symmetric about the vertical line x = 3. What is the x-coordinate of its centroid?

Question 4 of 5

A circle of radius 2 metres rotates about an axis 5 metres from its centre, and the axis never touches the circle. What volume does Pappus's theorem give?

Question 5 of 5

When is a region's centre of mass the same as its centroid?

Standards: Beyond AP

← Previous topicNext topic →