Chemistry › Section M · Equilibrium › Topic M.3
Le Chatelier's principle
An equilibrium mixture left alone never changes, but chemists rarely leave it alone. Le Chatelier's principle predicts how an equilibrium responds when you add or remove a substance, squeeze it, or heat it, and it is how industry pushes reactions towards the products it wants.
Disturbing a balance
In 1884 the French chemist Henri Le Chatelier summed up how equilibria respond to change. His principle states: if a system at equilibrium is disturbed, the equilibrium shifts in the direction that partly counteracts the disturbance, until a new equilibrium is reached. Add a substance and the system uses some of it up; remove one and the system makes some more. The word partly matters: the change is reduced, never fully undone. Behind the principle lies the comparison from the previous topic. A disturbance makes Q differ from K, and the net reaction then runs whichever way brings Q back to K.
Changing a concentration
Adding a reactant raises the denominator of Q, so Q < K and the net reaction runs forward, using up some of the added reactant. Removing a product lowers the numerator, which also makes Q < K and also drives the reaction forward. Adding a product, or removing a reactant, makes Q > K, so the reverse reaction wins. In every case K itself is unchanged: the new equilibrium has different concentrations, but they still give the same value of K at that temperature. Industry often removes a product continuously so that a reaction keeps running forward.
Worked example: adding a reactant
The hydrogen iodide mixture at about 450 °C sits at 0.156 M HI and 0.022 M each of H₂ and I₂, with K ≈ 50. Extra H₂ is injected, raising [H₂] to 0.100 M at once. 1. New Q: \(Q = \frac{0.156^2}{0.100 \times 0.022} = 11\). 2. Compare: 11 < 50, so the net reaction runs forward. 3. Prediction: H₂ and I₂ are used up, HI is made. 4. Solving with the method of the next topic gives about 0.184 M HI, 0.086 M H₂ and 0.0079 M I₂. 5. Check: \(\frac{0.184^2}{0.086 \times 0.0079} \approx 50\), so K is unchanged. [H₂] fell from 0.100 M but stayed above 0.022 M: the disturbance was only partly counteracted.
Changing the pressure by changing the volume
Squeezing a gas mixture into a smaller volume raises every partial pressure and concentration by the same factor. The equilibrium then shifts towards the side with fewer moles of gas, which lowers the total pressure. Expanding the volume does the reverse. Count gas moles only; solids and liquids take no part. If both sides have equal gas moles, as in \(\mathrm{H_2(g) + I_2(g) \rightleftharpoons 2HI(g)}\), a volume change causes no shift. Adding an unreactive gas such as argon at constant volume raises the total pressure but changes no partial pressure, so the equilibrium does not move.
Worked example: squeezing a brown gas
Brown nitrogen dioxide is in equilibrium with colourless dinitrogen tetroxide: \(\mathrm{N_2O_4(g) \rightleftharpoons 2NO_2(g)}\). The volume of the sealed syringe is halved at constant temperature. Predict what happens. 1. At once, both concentrations double. 2. New quotient: \(Q = \frac{(2[\mathrm{NO_2}])^2}{2[\mathrm{N_2O_4}]} = 2 \times \frac{[\mathrm{NO_2}]^2}{[\mathrm{N_2O_4}]} = 2K\). 3. Since Q > K, the net reaction runs in reverse, towards 1 mol of gas instead of 2. 4. What you see: the colour darkens at the moment of squeezing, because the NO₂ is more concentrated, then fades somewhat as NO₂ pairs up into N₂O₄. 5. Check: this matches the rule that compression favours the side with fewer gas moles.
Changing the temperature
Temperature is different: it is the only one of these changes that alters K itself. Treat heat as a reactant for an endothermic reaction (ΔH > 0) and as a product for an exothermic one (ΔH < 0). Heating then shifts the equilibrium in the endothermic direction, and cooling shifts it in the exothermic direction. So heating raises K for an endothermic reaction and lowers K for an exothermic one. A pink solution of cobalt(II) chloride in hydrochloric acid turns blue when heated and pink again when cooled, because forming the blue chloride species is endothermic.
Catalysts change speed, not position
A catalyst provides a route with a lower activation energy, and it lowers the barrier for the forward and the reverse reactions alike. Both rates rise, so the system reaches equilibrium sooner, but the equilibrium composition and the value of K are unchanged. Adding a catalyst to a mixture that is already at equilibrium therefore causes no shift at all. Catalysts matter enormously in industry precisely because they let a reaction reach a useful equilibrium quickly at a temperature low enough for that equilibrium to be favourable.
Worked example: designing the Haber process
Ammonia is made by \(\mathrm{N_2(g) + 3H_2(g) \rightleftharpoons 2NH_3(g)}\), ΔH° = −92.2 kJ. Choose conditions. 1. Gas moles fall from 4 to 2, so high pressure favours ammonia; plants run at roughly 150 to 250 atm. 2. The reaction is exothermic, so low temperature favours ammonia: K is about 5.6 × 10⁵ at 25 °C, but \(K_p\) falls to about 4 × 10⁻³ at 300 °C and 1.5 × 10⁻⁵ at 500 °C. 3. At low temperature, though, the reaction is far too slow. 4. The compromise is roughly 400 to 500 °C with an iron catalyst for speed. 5. Ammonia is cooled out as a liquid and the unreacted gases recycled, so removing product keeps the reaction moving forward.
Equilibrium in your blood
Haemoglobin in red blood cells carries oxygen. A simplified view of each binding step is \(\mathrm{Hb + O_2 \rightleftharpoons HbO_2}\). In the lungs the oxygen pressure is high, so the equilibrium shifts right and haemoglobin loads up. In working tissues oxygen is being used and its pressure is low, so the equilibrium shifts left and oxygen is released where it is needed. At high altitude, lower oxygen pressure means less loading in the lungs. Over several weeks the body responds by making more red blood cells, and the extra haemoglobin pushes the equilibrium back towards oxygen carrying.
Common mistakes to avoid
First, thinking concentration or pressure changes alter K; they shift the position, and only temperature changes K. Second, thinking a catalyst shifts an equilibrium; it only speeds up both directions. Third, counting solids and liquids when judging a pressure change; count gas moles only. Fourth, assuming any rise in total pressure causes a shift; an inert gas added at constant volume does nothing. Fifth, believing the shift fully reverses the disturbance; it only partly counteracts it. Sixth, getting the temperature effect backwards: heating favours the endothermic direction.
Key takeaways
When an equilibrium is disturbed, it shifts to partly counteract the change, because Q no longer equals K. Adding a reactant or removing a product shifts it forward; adding a product shifts it back. Reducing the volume favours the side with fewer gas moles; equal gas moles, or an inert gas at constant volume, mean no shift. Heating favours the endothermic direction and is the only change that alters K. Catalysts speed up both directions equally and do not move the equilibrium. The Haber process balances all of these against reaction speed.
Flashcards
Flashcard
A disturbed equilibrium shifts to partly counteract the disturbance
Test your understanding
Question 1 of 5
For the exothermic reaction N₂(g) + 3H₂(g) ⇌ 2NH₃(g), which change increases the equilibrium amount of NH₃?
Question 2 of 5
Which change alters the value of K for an equilibrium?
Question 3 of 5
For the endothermic reaction N₂O₄(g) ⇌ 2NO₂(g), what happens when the sealed mixture is heated?
Question 4 of 5
Argon is pumped into a rigid, sealed container holding 2SO₂(g) + O₂(g) ⇌ 2SO₃(g) at equilibrium, at constant temperature. What happens?
Question 5 of 5
A mixture of H₂, I₂ and HI is at equilibrium. Extra I₂ is added. Once equilibrium returns, how does [I₂] compare with its value just after the addition?
