Chemistry › Section R · Metals, metalloids, and nonmetals › Topic R.1
Periodicity of the elements
An element's place in the periodic table tells you a great deal about how it will behave before you ever see a sample. This topic puts that idea to work on the representative metals, from soft, explosive sodium to liquid mercury and heavy lead.
Reading chemistry from position
The representative, or main-group, elements are those whose outermost electrons fill s and p orbitals: groups 1 and 2 on the left and groups 13 to 18 on the right. Many textbooks, including the one this course follows, also count group 12 (zinc, cadmium and mercury), because its d subshell is already full and only its outer s electrons take part in bonding. These groups contain metals, metalloids and nonmetals. Metals tend to lose electrons and form cations; nonmetals tend to gain or share them. A metal and a nonmetal usually combine to give a salt, an ionic compound of cations and anions, such as \(\mathrm{NaCl}\).
Reactive, yet long-lasting
Representative metals give up electrons easily, so in nature they are almost always found combined: sodium in rock salt, calcium in limestone, aluminium in bauxite. Yet magnesium, aluminium, zinc and tin survive for years in air. Their surfaces react to form a thin, tightly bonded film of oxide or basic carbonate that shields the metal beneath. This protection is called passivation. An aluminium window frame lasts because of its oxide film, not because aluminium is unreactive. Beryllium, cadmium, mercury and lead also react only slowly with air, but their toxicity limits their use.
Group 1: the alkali metals
Lithium, sodium, potassium, rubidium, caesium and francium each have one valence electron, \(ns^1\), outside a noble-gas core. They have the largest atoms and lowest first ionisation energies in their periods, so they easily form 1+ ions, and reactivity increases down the group. They are soft enough to cut with a knife, and lithium, at about 0.53 g cm⁻³, is the least dense metal. Each reacts with water to give hydrogen and a strongly basic hydroxide:
Lithium fizzes steadily, sodium melts into a darting ball, and potassium's hydrogen catches fire, so all are stored under oil. Their compounds colour flames, an emission spectrum: lithium crimson, sodium yellow, potassium lilac.
Group 2: the alkaline earth metals
The group 2 metals, from beryllium down to radium, have two valence electrons, \(ns^2\), and form 2+ ions. A greater nuclear charge makes them smaller, with higher first ionisation energies, than the alkali metal in the same period, so they are less reactive, though reactivity again rises down the group. Beryllium barely reacts with water and magnesium only slowly with hot water, but calcium, strontium and barium react with cold water:
Many of their salts, such as \(\mathrm{CaCO_3}\) and \(\mathrm{BaSO_4}\), are insoluble because 2+ ions give high lattice energies. Flame colours: calcium orange-red, strontium crimson, barium pale green. Burning magnesium even takes oxygen from carbon dioxide,
so a carbon dioxide extinguisher cannot put out a magnesium fire.
Worked example: sodium in water
A 2.30 g piece of sodium reacts completely with water, and the solution is made up to 500.0 mL. Find the volume of hydrogen at 273.15 K and 1 bar, and the concentration of sodium hydroxide. 1. Equation:
2. Moles of sodium: \(2.30 \div 22.99 = 0.1000\) mol. 3. Moles of hydrogen: half that, 0.0500 mol. 4. Volume: at 273.15 K and 1 bar an ideal gas occupies 22.71 L mol⁻¹, so \(V = 0.0500 \times 22.71 = 1.14\) L. 5. Moles of NaOH equal moles of Na, so \(c = 0.1000 \div 0.5000 = 0.200\) M. 6. Check: 2.3 g is a tenth of a mole of sodium, giving a twentieth of a mole of hydrogen.
Group 12: zinc, cadmium and mercury
These elements have a full d subshell with two s electrons outside it, and usually form 2+ ions by losing the s pair. Unlike groups 1 and 2, they become less reactive down the group: zinc is the most reactive, mercury the least. Zinc and cadmium displace hydrogen from acids:
Mercury does not. It is the one metal that is a liquid at 25 °C, it dissolves many other metals to form amalgams, and besides \(\mathrm{Hg^{2+}}\) it forms mercury(I) compounds containing the paired ion \(\mathrm{Hg_2^{2+}}\). Roughly half of all zinc goes to galvanising steel, where the zinc corrodes in preference to the iron. Cadmium and mercury are toxic.
Group 13: aluminium and its relatives
Boron is a metalloid; aluminium, gallium, indium and thallium are metals. With \(ns^2np^1\) valence electrons, they typically show the oxidation state +3. Aluminium is amphoteric: it reacts with both acids and bases, releasing hydrogen each time:
The oxides and hydroxides of aluminium and gallium are amphoteric too, while those of indium and thallium are only basic: metallic character grows down the group. Gallium melts at about 30 °C, just above room temperature.
The inert pair effect
Heavier p-block metals often form ions with a charge two below the group's usual oxidation state: \(\mathrm{Tl^+}\) in group 13, \(\mathrm{Sn^{2+}}\) and \(\mathrm{Pb^{2+}}\) in group 14, \(\mathrm{Bi^{3+}}\) in group 15. In these large atoms the valence s pair is held unusually tightly, partly because filled d and f subshells shield the nucleus poorly, so it tends to stay out of bonding. The effect strengthens down each group. Tin forms both tin(II) and tin(IV) compounds, and tin(II) is a reducing agent because it is easily oxidised to tin(IV). For lead, +2 is the stable state, so lead(IV) oxide, \(\mathrm{PbO_2}\), is a strong oxidising agent. In water, \(\mathrm{Tl^+}\) is more stable than \(\mathrm{Tl^{3+}}\).
Worked example: predicting strontium's chemistry
Use strontium's position, period 5 of group 2, to predict its behaviour. 1. Charge: group 2 metals lose both s electrons, so strontium forms \(\mathrm{Sr^{2+}}\) and its chloride is \(\mathrm{SrCl_2}\). 2. Reactivity: it lies below calcium, with a lower first ionisation energy, so it should react with cold water, more vigorously than calcium. 3. Equation:
with 1 Sr, 4 H and 2 O on each side. 4. Solubility: calcium and barium sulfates are only sparingly soluble, so strontium sulfate should be too. 5. Check: all four predictions match what is observed for strontium.
Common mistakes to avoid
First, assuming reactivity increases down every group of metals: it does in groups 1 and 2, but zinc is more reactive than mercury. Second, treating passivated metals such as aluminium as unreactive. Third, writing mercury(I) as a lone \(\mathrm{Hg^+}\) ion instead of \(\mathrm{Hg_2^{2+}}\). Fourth, giving heavy p-block metals only their group oxidation state, when the inert pair effect makes \(\mathrm{Tl^+}\) and \(\mathrm{Pb^{2+}}\) the stable ions. Fifth, forgetting that aluminium dissolves in strong bases as well as acids. Sixth, unbalanced metal and water equations: two sodium atoms give one \(\mathrm{H_2}\) molecule.
Key takeaways
Representative elements fill s and p orbitals, and this course also counts group 12. Their metals occur combined in nature, and many survive in air only through passivation. Alkali metals form 1+ ions and alkaline earth metals 2+ ions; both react with water to give hydrogen and a hydroxide, more vigorously down the group. Group 12 metals form 2+ ions but grow less reactive down the group, and mercury also forms \(\mathrm{Hg_2^{2+}}\). Aluminium is amphoteric. The inert pair effect makes the lower oxidation state, such as \(\mathrm{Tl^+}\) or \(\mathrm{Pb^{2+}}\), more stable for heavy p-block metals.
Flashcards
Flashcard
Elements whose outer electrons fill s and p orbitals: groups 1, 2 and 13-18
Test your understanding
Question 1 of 5
Which equation correctly shows potassium reacting with water?
Question 2 of 5
Which of these metals does NOT give hydrogen gas when added to hydrochloric acid?
Question 3 of 5
4.60 g of sodium reacts completely with water. What volume of hydrogen forms at 273.15 K and 1 bar, where 1 mol of gas occupies 22.71 L?
Question 4 of 5
Thallium is in group 13. Which oxidation state does it show in its most stable ion in water?
Question 5 of 5
Aluminium is a reactive metal, so why does aluminium foil not crumble away in air?
