Chemistry › Section N · Acid-base equilibria › Topic N.5
Polyprotic acids
Carbonic acid in fizzy water, phosphoric acid in cola and sulfuric acid in a car battery can each give up more than one proton. They do it one proton at a time, each step weaker than the last, and that pattern makes their chemistry simpler than it first looks.
Counting the acidic protons
Acids are classed by how many protons each molecule can donate. HCl, \(\mathrm{HNO_3}\) and HF are monoprotic. Acetic acid, \(\mathrm{CH_3COOH}\), has four hydrogen atoms but is also monoprotic: only the hydrogen on the oxygen of the COOH group is acidic, while the three bonded to carbon are not. Acids that can donate two protons, such as sulfuric acid, \(\mathrm{H_2SO_4}\), and carbonic acid, \(\mathrm{H_2CO_3}\), are diprotic. Phosphoric acid, \(\mathrm{H_3PO_4}\), is triprotic. Together, acids with more than one acidic proton are called polyprotic. Bases can be polyprotic too, accepting more than one proton.
One proton at a time
A polyprotic acid never loses all its protons at once. It ionises in steps, each a separate equilibrium with its own constant. For carbonic acid at 25 °C:
The product of one step is the acid of the next, so the intermediate ion, here hydrogen carbonate, is amphiprotic. Strictly, most dissolved carbon dioxide stays as \(\mathrm{CO_2(aq)}\) rather than \(\mathrm{H_2CO_3}\); the \(K_{a1}\) value quoted counts both together as carbonic acid.
Why each step is weaker
The first proton leaves a neutral molecule. The second must leave an ion that is already negative, and so is held back by the extra attraction of that charge. The third, from a 2− ion, is harder still. So for every polyprotic acid \(K_{a1} > K_{a2} > K_{a3}\), usually by large factors. Phosphoric acid at 25 °C shows the pattern clearly: \(K_{a1} = 7.5 \times 10^{-3}\) (\(\mathrm{p}K_{a1}\) 2.12), \(K_{a2} = 6.2 \times 10^{-8}\) (7.21) and \(K_{a3} = 4.2 \times 10^{-13}\) (12.38). Each step is about \(10^5\) times weaker than the one before.
Treating the steps one at a time
Because the constants are so far apart, nearly all the hydronium in a solution of a weak polyprotic acid comes from the first step. That allows a two-stage method. First, treat the acid as monoprotic with \(K_{a1}\), using an ICE table as for any weak acid; this gives \(\mathrm{[H_3O^+]}\) and the first conjugate base, which come out equal. Second, put those values into the next \(K_a\) expression. For a weak diprotic acid \(\mathrm{H_2A}\), \(K_{a2} = \frac{\mathrm{[H_3O^+][A^{2-}]}}{\mathrm{[HA^-]}}\), and since \(\mathrm{[H_3O^+] \approx [HA^-]}\), these cancel, leaving the useful result \(\mathrm{[A^{2-}]} \approx K_{a2}\).
Worked example: carbonated water
Take a carbonated water that holds 0.040 M carbonic acid. Find its pH, \(\mathrm{[HCO_3^-]}\) and \(\mathrm{[CO_3^{2-}]}\) at 25 °C. 1. First step: \(K_{a1} = \frac{x^2}{0.040 - x}\), so \(x \approx \sqrt{4.3 \times 10^{-7} \times 0.040} = 1.3 \times 10^{-4}\) M. 2. Test: 0.33% of 0.040 M, well under 5%. 3. So \(\mathrm{[H_3O^+] = [HCO_3^-]} = 1.3 \times 10^{-4}\) M, and pH = −log(1.31 × 10⁻⁴) = 3.88. 4. Second step: \(\mathrm{[CO_3^{2-}]} \approx K_{a2} = 4.7 \times 10^{-11}\) M. 5. Check: the second step adds only about \(5 \times 10^{-11}\) M of hydronium, one for each carbonate ion, a negligible amount, which confirms the method.
Worked example: phosphoric acid
Find the pH of 0.10 M phosphoric acid and estimate \(\mathrm{[PO_4^{3-}]}\). 1. First step: the shortcut gives \(x = \sqrt{7.5 \times 10^{-4}} = 0.027\) M, which is 27% of 0.10 M, so solve \(x^2 + 7.5 \times 10^{-3}x - 7.5 \times 10^{-4} = 0\). 2. The positive root is \(x = 0.024\) M, so pH = −log(0.0239) = 1.62. 3. Second step: \(\mathrm{[HPO_4^{2-}]} \approx K_{a2} = 6.2 \times 10^{-8}\) M. 4. Third step: \(\mathrm{[PO_4^{3-}]} = \frac{K_{a3}\mathrm{[HPO_4^{2-}]}}{\mathrm{[H_3O^+]}} = \frac{(4.2 \times 10^{-13})(6.2 \times 10^{-8})}{0.0239} = 1.1 \times 10^{-18}\) M. 5. Check: each species is far scarcer than the one before it.
Sulfuric acid is a special case
Sulfuric acid's first proton is lost completely, because \(\mathrm{H_2SO_4}\) is a strong acid. The second step,
is only partial, with \(K_{a2} \approx 1.2 \times 10^{-2}\). That value is large for a weak acid, so the second step adds real hydronium. In 0.010 M sulfuric acid, the first step gives 0.010 M of hydronium; solving the second step with an ICE table that starts from 0.010 M of both \(\mathrm{HSO_4^-}\) and \(\mathrm{H_3O^+}\) adds about 0.0045 M more. The pH is 1.84, not 2.00, from the first proton alone, nor 1.70, from both protons fully lost.
Which form dominates at a given pH?
Rearranging any \(K_a\) expression gives \(\frac{\mathrm{[A^-]}}{\mathrm{[HA]}} = \frac{K_a}{\mathrm{[H_3O^+]}}\). When the pH equals the \(\mathrm{p}K_a\) of a step, the two forms in that step are equal. Below that pH the more protonated form dominates; above it, the less protonated one. For phosphate, \(\mathrm{H_3PO_4}\) dominates below pH 2.12, \(\mathrm{H_2PO_4^-}\) from 2.12 to 7.21, \(\mathrm{HPO_4^{2-}}\) from 7.21 to 12.38, and \(\mathrm{PO_4^{3-}}\) above 12.38. Inside cells, at pH near 7.2, \(\mathrm{H_2PO_4^-}\) and \(\mathrm{HPO_4^{2-}}\) are present in similar amounts, which matters in the next topic, on buffers.
Polyprotic bases
The same stepwise pattern runs in reverse for bases. Carbonate, \(\mathrm{CO_3^{2-}}\), can accept two protons, first becoming \(\mathrm{HCO_3^-}\) and then \(\mathrm{H_2CO_3}\), so it is a diprotic base. Its constants come from the acid's, with the steps paired in reverse order: \(K_{b1} = \frac{K_w}{K_{a2}} = \frac{1.0 \times 10^{-14}}{4.7 \times 10^{-11}} = 2.1 \times 10^{-4}\), and \(K_{b2} = \frac{K_w}{K_{a1}} = 2.3 \times 10^{-8}\). Again the first step dominates, so the pH of a sodium carbonate solution is found from \(K_{b1}\) alone, exactly as for a monoprotic weak base.
Common mistakes to avoid
First, counting every hydrogen as acidic: acetic acid is monoprotic. Second, assuming a diprotic acid gives twice its concentration in hydronium; for a weak one, the second step adds almost nothing. Third, the reverse slip with sulfuric acid: its second step is large enough to count. Fourth, setting \(\mathrm{[A^{2-}]}\) equal to \(\mathrm{[HA^-]}\) instead of to \(K_{a2}\). Fifth, pairing the wrong constants for a polyprotic base: \(K_{b1}\) uses the last acid step, \(K_{a2}\) for carbonate. Sixth, skipping the 5% test on the first step, which fails for phosphoric acid.
Key takeaways
Polyprotic acids donate protons one at a time, each step with its own constant, and Ka1 > Ka2 > Ka3 because each proton leaves a more negative ion. With constants far apart, find [H₃O⁺] from the first step alone; for a weak diprotic acid the fully ionised anion is then about equal to Ka2. Sulfuric acid is the exception: its first step is complete and its second, with Ka2 ≈ 1.2 × 10⁻², is significant. The pKa values mark where each pair of forms is equal. Polyprotic bases, such as carbonate, follow the same pattern, with Kb1 = Kw ÷ Ka2.
Flashcards
Flashcard
Donates one proton per molecule
Test your understanding
Question 1 of 5
What is the pH of 0.010 M carbonic acid at 25 °C? (Ka1 = 4.3 × 10⁻⁷, Ka2 = 4.7 × 10⁻¹¹)
Question 2 of 5
In 0.040 M carbonic acid, what is the approximate concentration of carbonate ion, CO₃²⁻?
Question 3 of 5
Why is Ka2 of a polyprotic acid always smaller than Ka1?
Question 4 of 5
Phosphoric acid has pKa values of 2.12, 7.21 and 12.38. Which form is present in the largest amount at pH 10.0?
Question 5 of 5
Why is the pH of 0.010 M sulfuric acid lower than 2.00?
