Physics › Section N · Electric potential and capacitance › Topic N.5
Capacitor combinations and stored energy
Real circuits rarely use a single capacitor, and the reason to charge one is usually the energy it holds. Two simple rules reduce any series or parallel network to one equivalent capacitor, and one formula tells you how much energy it stores.
Networks of capacitors
Several capacitors joined together behave, as far as the rest of the circuit can tell, like one equivalent capacitor: it stores the same total charge at the same applied voltage. The two basic ways to join them are in parallel, side by side across the same two points, and in series, one after another in a single chain. Many more complicated networks can be broken down into series and parallel pieces. Throughout, the connecting wires are treated as ideal conductors, so each wire is an equipotential, and all the capacitors start uncharged.
Capacitors in parallel
In parallel, each capacitor is wired directly across the source, so each has the same voltage \(V\). Each stores its own charge, \(Q_1 = C_1V\), \(Q_2 = C_2V\) and so on, and the total charge drawn from the source is their sum. Writing \(Q = C_pV\) for the equivalent capacitor and cancelling \(V\) gives
The equivalent capacitance is larger than any single one. Physically, putting capacitors in parallel is like making one capacitor with a larger plate area, and a larger area means a larger capacitance.
Capacitors in series
In series, the source moves charge \(+Q\) onto the first plate and \(-Q\) onto the last. The plates in between form isolated, neutral pieces of conductor, so charge is only separated within them, and every capacitor ends up holding the same \(Q\). The voltages add: \(V = V_1 + V_2 + \cdots\), with \(V_1 = Q/C_1\) and so on. Dividing through by \(Q\) gives
The result is smaller than the smallest capacitor, like one capacitor with a wider gap. For exactly two, \(C_s = \frac{C_1C_2}{C_1 + C_2}\). When you meet resistors later, the two rules swap round.
Worked example: two in series
A 3.00 μF and a 6.00 μF capacitor are connected in series across a 12.0 V battery. Find the equivalent capacitance, the charge on each and the voltage across each. 1. Equivalent: \(\frac{1}{C_s} = \frac{1}{3.00} + \frac{1}{6.00} = \frac{1}{2.00}\), so \(C_s = 2.00\) μF. 2. Charge: \(Q = C_sV = (2.00\ \mu\text{F})(12.0\ \text{V}) = 24.0\) μC, the same on each capacitor. 3. Voltages: \(V_1 = 24.0/3.00 = 8.00\) V and \(V_2 = 24.0/6.00 = 4.00\) V. 4. Check: \(8.00 + 4.00 = 12.0\) V, the battery voltage. The smaller capacitor takes the larger share of the voltage, because \(V = Q/C\) with the same \(Q\).
Worked example: a mixed network
A 4.00 μF and a 12.0 μF capacitor are in series, and that pair is in parallel with a 5.00 μF capacitor. The network is connected to 10.0 V. 1. Series pair: \(C_s = \frac{(4.00)(12.0)}{4.00 + 12.0} = 3.00\) μF. 2. Add the parallel branch: \(C_{\text{eq}} = 3.00 + 5.00 = 8.00\) μF. 3. Total charge: \(Q = (8.00\ \mu\text{F})(10.0\ \text{V}) = 80.0\) μC. 4. Split it up: both branches have the full 10.0 V, so the 5.00 μF capacitor holds 50.0 μC and the series pair 30.0 μC, giving 7.50 V across the 4.00 μF and 2.50 V across the 12.0 μF capacitor. 5. Check: \(50.0 + 30.0 = 80.0\) μC, and \(7.50 + 2.50 = 10.0\) V.
Energy stored in a capacitor
Charging a capacitor means moving charge from one plate to the other against a voltage that grows as the charge builds up. The first bit of charge crosses almost no voltage; the last crosses the full \(V\). Because \(V\) rises in proportion to \(Q\), the average voltage during charging is \(V/2\), and the stored energy is
The three forms are equal, using \(Q = CV\). On a graph of \(V\) against \(Q\), the stored energy is the triangular area under the straight line. With \(C\) in farads and \(V\) in volts, the energy is in joules.
Why not QV?
The energy \(QV\) would be right for a charge \(Q\) moved across a fixed voltage \(V\), but a capacitor's voltage starts at zero, so the stored energy is only half of that. A battery that charges a capacitor does push all the charge through its full voltage and does work \(QV\). The other half does not reach the capacitor: it is turned into thermal energy in the wires and the battery as the charging current flows. Notice also that the energy grows with the square of the voltage, so doubling the voltage on a capacitor stores four times the energy.
Worked example: a camera flash
A camera flash capacitor of 150 μF is charged to 330 V. Find the energy stored, and the average power if it is all released in 1.00 ms. 1. Energy: \(PE = \tfrac{1}{2}CV^2 = \tfrac{1}{2}(150 \times 10^{-6})(330)^2 = 8.17\) J. 2. Check with the charge: \(Q = CV = 4.95 \times 10^{-2}\) C, and \(\tfrac{1}{2}QV = \tfrac{1}{2}(4.95 \times 10^{-2})(330) = 8.17\) J. 3. Power: \(P = \frac{8.17\ \text{J}}{1.00 \times 10^{-3}\ \text{s}} = 8.17 \times 10^3\) W. 4. The energy is modest, but releasing it in a millisecond gives a power of over 8 kW, which is the whole point of using a capacitor rather than the battery directly.
Worked example: finding a capacitance
A defibrillator must store 360 J in a capacitor charged to 5.00 kV. What capacitance is needed? 1. Choose the form with \(C\) and \(V\): \(PE = \tfrac{1}{2}CV^2\). 2. Rearrange: \(C = \frac{2PE}{V^2}\). 3. Substitute:
or 28.8 μF. 4. Check: \(\tfrac{1}{2}(2.88 \times 10^{-5})(5.00 \times 10^3)^2 = 360\) J. A network stores the energy of its equivalent capacitor: two 10.0 μF capacitors on 100 V store 0.100 J in parallel but only 0.0250 J in series.
Common mistakes to avoid
First, swapping the rules: capacitances add directly in parallel and as reciprocals in series, the reverse of resistors. Second, forgetting to invert at the end of a series sum: \(1/C_s = 0.5\ \mu\text{F}^{-1}\) means \(C_s = 2\) μF. Third, giving series capacitors the same voltage; they share the same charge, and their voltages add. Fourth, dropping the \(\tfrac{1}{2}\) or the square in \(\tfrac{1}{2}CV^2\). Fifth, leaving μF or kV unconverted before computing energy in joules.
Key takeaways
Parallel capacitors share the same voltage, their charges add and C(p) = C₁ + C₂ + …, larger than any one. Series capacitors share the same charge, their voltages add and 1/C(s) = 1/C₁ + 1/C₂ + …, smaller than any one. Reduce mixed networks one series or parallel group at a time. A capacitor stores energy ½QV = ½CV² = Q²/(2C), half of the QV a charging battery supplies. Energy grows with the square of voltage, and fast release gives capacitors their high power.
Flashcards
Flashcard
One capacitor storing the same charge at the same voltage as a network
Test your understanding
Question 1 of 5
Capacitors of 2.0 μF, 3.0 μF and 5.0 μF are wired side by side in parallel. Find the capacitance of the combination.
Question 2 of 5
A 6.0 μF and a 3.0 μF capacitor are connected in series. What is the equivalent capacitance?
Question 3 of 5
How much energy is stored in a 50.0 μF capacitor charged to 200 V?
Question 4 of 5
The voltage on a capacitor is doubled. By what factor does its stored energy change?
Question 5 of 5
A 2.0 μF and an 8.0 μF capacitor are connected in series to a battery. Which has the larger voltage across it?
