Physics › Section Q · Electromagnetic induction and AC circuits › Topic Q.1
Induced emf, Faraday's law, and Lenz's law
Currents make magnetic fields, and in 1831 Michael Faraday showed the reverse: a changing magnetic field can drive a current. That discovery, with Lenz's rule for its direction, is the working principle behind every generator, transformer and wireless charger.
Currents from changing fields
Currents produce magnetic fields, as the magnetism section showed. In 1831 Michael Faraday in England, and independently Joseph Henry in the United States, found the reverse. Push a bar magnet into a coil wired to a sensitive current meter and the needle kicks; hold the magnet still and it returns to zero; pull the magnet out and it kicks the other way. With two coils on one iron ring, switching the current in one on or off gives a brief pulse in the other, but a steady current gives nothing. What matters is change. What appears is an induced emf, in volts, which drives a current whenever the circuit is complete.
Magnetic flux
To make "change" precise, Faraday used the magnetic flux, a measure of how much field passes through a loop:
Here \(B\) is a uniform field, \(A\) the loop's area, and \(\theta\) the angle between the field and the normal to the loop, a line at right angles to its surface. The unit is the weber, \(1\ \text{Wb} = 1\ \text{T}\cdot\text{m}^2\). The flux is largest, \(BA\), when the field passes straight through (\(\theta = 0\)), and zero when the field lies in the loop's plane (\(\theta = 90^\circ\)). It changes if \(B\), \(A\) or \(\theta\) changes. Sliding a loop sideways while it stays wholly inside a uniform field changes none of them, so the flux stays the same.
Faraday's law
Faraday's law states that the emf induced in a coil equals the number of turns times the rate of change of flux through each turn:
Each turn has the same emf induced in it, and the turns are in series, so their emfs add. If the flux does not change steadily, this gives the average emf over \(\Delta t\). The same change made twice as fast gives twice the emf. Units: \(1\ \text{Wb/s} = 1\ \text{V}\). A coil of resistance \(R\) carries \(I = \mathcal{E}/R\). The minus sign carries the direction, which Lenz's law explains.
Worked example: a coil in a growing field
A flat circular coil of 250 turns and radius 4.00 cm faces a uniform magnetic field head-on. The field rises steadily from 0.120 T to 0.480 T in 0.0600 s. Find the induced emf and, if the coil's resistance is 3.00 Ω, the current. 1. Area: \(A = \pi(0.0400\ \text{m})^2\), which is \(5.03 \times 10^{-3}\ \text{m}^2\). 2. With \(\theta = 0\), the flux change per turn is
3. The size of the emf is
4. Current: \(I = 7.54/3.00\), which is 2.51 A. 5. Check: one turn would give about 0.03 V, and 250 turns in series multiply that by 250.
Lenz's law
Lenz's law gives the direction: the induced current flows so that its own magnetic field opposes the change in flux that produced it. It opposes the change, not the field. For increasing flux the induced field points against the applied field; for decreasing flux it points along it, trying to keep the flux as it was. The law follows from energy conservation. If the induced current helped the change, a magnet nudged towards a coil would be pulled in faster, inducing more current and pulling harder still: electrical energy from nothing. Instead you must do work to push a magnet into a coil, and that work becomes the electrical energy delivered to the circuit.
Finding the direction, step by step
Lenz's law becomes a reliable four-step method. 1. Find which way the applied field points through the loop. 2. Decide whether the flux is increasing or decreasing. 3. The induced field points against the applied field if the flux is increasing, and along it if decreasing. 4. Use the right-hand rule for a coil from the magnetism section, read in reverse: point your right thumb along the induced field inside the loop, and your fingers curl the way the current flows. Always state the viewpoint, such as "anticlockwise as seen from above", because the same current looks clockwise from the other side.
Worked example: a magnet approaching a loop
A vertical bar magnet, north pole down, is lowered towards a horizontal wire loop. Which way does the induced current flow, seen from above? 1. Field lines leave a north pole, so the field through the loop points down. 2. As the magnet nears, the field at the loop grows, so the downward flux increases. 3. The induced field opposes the increase, so it points up. 4. With the right thumb pointing up, the fingers curl anticlockwise as seen from above. 5. Check: an upward field makes the loop's top face act as a north pole, which repels the approaching north pole, opposing the motion as Lenz's law requires. Lifting the magnet away reverses every step: the current is clockwise from above, and the loop attracts the departing magnet.
Worked example: turning a coil
A rectangular coil of 40 turns measures 0.150 m by 0.200 m and sits in a uniform 0.350 T field, with the field perpendicular to its plane. It is turned through 90° in 0.0250 s, until the field lies in its plane. Find the average induced emf. 1. Area: \(A = 0.150 \times 0.200 = 0.0300\ \text{m}^2\). 2. Initial flux per turn, with \(\theta = 0\): \(BA = 0.0105\) Wb. Final flux, with \(\theta = 90^\circ\): zero. 3. Size of the average emf:
4. Check: a 180° turn in the same time would take the flux from \(+BA\) to \(-BA\), a change of \(2BA\), doubling the average emf to 33.6 V. The field never changed; turning the coil was enough.
Induction at work
Electric guitar pickups contain a magnet that magnetises the steel string above it; when the string vibrates, the flux through the pickup's coil changes and induces an emf that follows the vibration. Wireless phone chargers pass an alternating current through a coil in the pad, so the flux through a coil in the phone keeps changing and induces an emf that charges the battery. In a dynamic microphone, sound moves a coil near a magnet, inducing an emf that copies the sound wave. Lenz's law shows up in a striking demonstration: a strong magnet dropped down a copper pipe drifts down slowly, because the currents induced in the pipe oppose its motion. The next topics follow the same law into moving conductors, generators and transformers.
Common mistakes to avoid
First, expecting a strong but steady field to induce an emf; only a change in flux does. Second, measuring \(\theta\) from the plane of the loop instead of from the normal, which swaps the sine and cosine. Third, forgetting the factor \(N\), or putting an area in square centimetres into a formula that needs square metres. Fourth, saying the induced field always opposes the applied field; it opposes the change, so for falling flux it points the same way. Fifth, thinking a coil flipped through 180° has no net flux change; the flux reverses, a change of \(2BA\).
Key takeaways
A changing magnetic flux through a circuit induces an emf. Flux is Φ = BA cos θ, in webers, with θ measured from the normal to the loop; it changes when B, A or θ changes. Faraday's law: emf = −N ΔΦ/Δt, so more turns and faster changes give a larger emf. Lenz's law: the induced current's field opposes the change in flux, which follows from energy conservation. To find a direction, find the applied field, decide whether the flux is rising or falling, choose the induced field, and apply the right-hand rule, stating the viewpoint.
Flashcards
Flashcard
A changing magnetic flux through a circuit induces an emf
Test your understanding
Question 1 of 5
A uniform 0.40 T field passes through a flat loop of area 0.050 m², at 60° to the normal to the loop. What is the flux through the loop?
Question 2 of 5
The flux through each turn of a 500-turn coil changes steadily by 2.0 × 10⁻⁴ Wb in 0.020 s. What is the size of the induced emf?
Question 3 of 5
A bar magnet with its north pole pointing down is lifted upwards, away from a horizontal loop below it. Seen from above, which way does the induced current flow?
Question 4 of 5
A single loop of area 0.020 m² starts perpendicular to a uniform 0.50 T field and is flipped through 180° in 0.10 s. What is the size of the average induced emf?
Question 5 of 5
A wire loop sits in a uniform magnetic field. Which of these does NOT induce an emf in it?
