Physics › Section L · Sound and hearing › Topic L.1

Sound and the speed of sound

Every sound you hear is a pressure ripple racing through the air at a few hundred metres per second. This topic explains what that ripple is, what sets its speed, and why the speed changes with the medium and the temperature but not with the pitch.

Sound is a pressure wave

Strike a drum and its skin bulges outwards, crowding the air in front of it into a slightly denser, higher-pressure layer called a compression. As the skin springs back it leaves a thinner, lower-pressure layer, a rarefaction. As the skin keeps vibrating, a train of compressions and rarefactions spreads outwards. Each parcel of air only shuffles back and forth along the direction of travel, so sound in a gas or liquid is a longitudinal wave. Even a painfully loud sound changes the air pressure by well under 1% of the 101 kPa background. Because sound is a disturbance of matter, it cannot cross a vacuum.

Frequency, pitch and wavelength

Sound obeys the same relation as every other wave:

v = f\lambda

Here \(v\) is the wave speed, \(f\) the frequency in hertz and \(\lambda\) the wavelength, the distance from one compression to the next. The source sets the frequency: a string vibrating 440 times a second sends out 440 compressions a second. Your ear senses frequency as pitch, so a higher frequency sounds higher. All sounds in air share one speed, so a higher pitch means a shorter wavelength. That is why a church organ needs pipes several metres long for its lowest notes but only finger-sized ones for its highest.

What sets the speed: stiffness against density

The speed of sound depends on the medium, not on the source. Two properties pull in opposite directions. Stiffness, the resistance to being compressed, makes each layer push hard on the next and speeds the wave up. Density, the mass that must be set moving, slows it down. Gases are easy to squeeze, so sound in them is slow. Liquids and solids are enormously stiffer, and that wins even though they are denser. Typical values: air at 20 °C, 343 m/s; helium at 20 °C, about 1,000 m/s, fast because its atoms are so light; fresh water, about 1,480 m/s; steel, roughly 6,000 m/s.

Temperature and sound in air

In a gas the wave is handed on by colliding molecules, so it travels faster when the molecules move faster, that is, when the gas is warmer. For dry air the speed is well described by

v = 331\ \text{m/s} \times \sqrt{\frac{T}{273\ \text{K}}}

where \(T\) is the absolute temperature in kelvin. At 0 °C (273 K) this gives 331 m/s, and at 20 °C (293 K) it gives 343 m/s, the standard value in this course. The dependence is gentle: near room temperature the speed rises by about 0.6 m/s for each degree Celsius. At a fixed temperature, changing the air pressure alone has almost no effect on the speed.

Worked example: a note on a frosty morning

A trumpeter plays concert A, 440 Hz, outdoors at −10 °C. Find the speed of sound and the wavelength of the note, and compare it with a 20 °C hall. Assume dry, still air. 1. Convert to kelvin: \(T = -10 + 273 = 263\) K. 2. Speed: \(v = 331\sqrt{263/273}\) m/s \(= 324.9\) m/s, about 325 m/s. 3. Wavelength: \(\lambda = v/f = 324.9/440 = 0.738\) m. 4. In the hall: \(\lambda = 343/440 = 0.780\) m. 5. Check: the cold air carries sound about 5% more slowly, and with the frequency fixed by the trumpet, the wavelength must be about 5% shorter. It is.

Crossing into a new medium

When sound passes from one medium into another, for example from air into a lake, its speed changes but its frequency does not. Each compression reaching the boundary gives the new medium one push, so compressions leave at the rate they arrive. With \(f\) fixed and \(v\) changed, the wavelength must change in proportion, \(\lambda = v/f\): a faster medium means a longer wavelength. A 1,000 Hz tone is therefore 0.343 m long in air at 20 °C but 1.48 m long in water. Most of the sound striking an air-water surface is reflected, but the part that gets through obeys this rule.

Speed does not depend on pitch

In open air, every audible sound, from about 20 Hz to 20,000 Hz, travels at essentially the same speed. At an outdoor concert, the drums and the flute reach the back of the field delayed but still in time; if high notes outran low ones, the music would smear apart with distance. So in a given medium at a given temperature \(v\) is constant, and frequency and wavelength are inversely proportional: double the frequency and the wavelength halves. At 20 °C the wavelength runs from about 17 m at 20 Hz down to about 17 mm at 20 kHz.

Worked example: timing a thunderstorm

You see a lightning flash and hear its thunder 4.50 s later. The air is at 20 °C. How far away was the strike? 1. Light crosses a couple of kilometres in a few millionths of a second, so treat the flash as arriving instantly. 2. The sound made a one-way trip lasting 4.50 s: \(d = vt = 343 \times 4.50\) m = 1,544 m, or 1.54 km. 3. Check with the rule of thumb that sound covers about 1 km every 3 s: 4.5 s gives 1.5 km, in agreement. 4. There is no factor of 2 here, because the thunder travels from the strike to you only once.

Worked example: an echo from a cliff

A hiker shouts towards a cliff on a 15 °C day and hears the echo 1.20 s later. How far away is the cliff? 1. Speed at 288 K: \(v = 331\sqrt{288/273}\) m/s \(= 340.0\) m/s. 2. The sound goes to the cliff and back, so its path is twice the distance: \(2d = vt\). 3. Solve: \(d = vt/2 = 340.0 \times 1.20 / 2 = 204\) m. 4. Check: with 343 m/s the answer would be 206 m, so the temperature correction is small, as the square-root law predicts. Bats, sonar and medical ultrasound use the same round-trip timing.

Common mistakes to avoid

First, putting a Celsius temperature into the square-root formula: \(331\sqrt{20/273}\) gives about 90 m/s, which is absurd. Always use kelvin. Second, dropping the square root: the speed is proportional to \(\sqrt{T}\), so doubling the kelvin temperature raises it by a factor of about 1.41, not 2. Third, believing high notes travel faster; in one medium a higher frequency means a shorter wavelength, not a higher speed. Fourth, expecting the frequency to change at a boundary; it is the wavelength that changes. Fifth, forgetting the factor of 2 for an echo, or adding one to a one-way trip such as thunder.

Key takeaways

Sound is a longitudinal pressure wave of compressions and rarefactions; it needs a medium and cannot cross a vacuum. It obeys v = fλ, with the frequency set by the source and heard as pitch. Stiffness raises its speed and density lowers it, so sound is slowest in gases. In air v = 331 m/s × √(T/273 K) with T in kelvin, giving 343 m/s at 20 °C. The speed is the same for all audible frequencies. At a boundary the frequency stays the same and the wavelength changes. One-way timing gives d = vt; an echo gives d = vt/2.

Flashcards

Flashcard

Sound

A longitudinal pressure wave travelling through a medium

It cannot cross a vacuum.

Test your understanding

Question 1 of 5

Using v = 331 m/s × √(T / 273 K), what is the speed of sound in air at 30 °C?

Question 2 of 5

A 250 Hz tone travels through air at 20 °C, where sound moves at 343 m/s. What is its wavelength?

Question 3 of 5

A sound wave passes from air into water. Which quantity stays the same?

Question 4 of 5

Thunder is heard 6.0 s after the lightning is seen, with sound travelling at 343 m/s. About how far away was the strike?

Question 5 of 5

Steel is about 6,500 times denser than air, yet sound travels much faster in steel. Why?

← Previous topicNext topic →