Physics › Section K · Oscillations and waves › Topic K.7

Superposition, interference, and wave energy

When two waves meet, they simply add. That one rule explains loud and quiet spots in a room, the notes a guitar string can play and the throbbing of two nearly matched tones, and the energy a wave delivers depends on the square of its amplitude.

When waves meet

Send a pulse along a rope from each end at once. Where the pulses cross, the rope takes on a shape neither had alone, and afterwards each pulse carries on exactly as before, as if the other had never been there. Waves cross without colliding. While they overlap, the total disturbance at each point is the sum of the separate disturbances. This is the principle of superposition. For waves disturbing the medium along the same line, the displacements add with their signs: an upward displacement of 2.0 cm and a downward one of 1.5 cm at the same point give 0.5 cm upwards.

Constructive and destructive interference

The adding of overlapping waves is called interference. Two identical waves that arrive exactly in phase, crest on crest and trough on trough, give pure constructive interference: a wave of the same wavelength and twice the amplitude. Shift one of them by half a wavelength, so every crest meets a trough, and the result is pure destructive interference: complete cancellation. Most real overlaps fall in between and vary from place to place, which is why one spot in a room near two loudspeakers can sound loud and another quiet. Noise-cancelling headphones put the effect to work, producing a sound wave shaped to arrive out of phase with the incoming noise.

Standing waves

Overlap two identical waves travelling in opposite directions, as happens when a wave meets its own reflection, and the result does not seem to travel at all. Instead the medium oscillates in place in a fixed pattern called a standing wave. Some points, the nodes, never move, because there the two waves always cancel. Midway between nodes are the antinodes, where the two waves reinforce and the oscillation reaches twice the amplitude of either wave. Adjacent nodes are half a wavelength apart, \(\lambda/2\). Standing waves form on instrument strings and in organ pipes.

Standing waves on a string

A string fixed at both ends must have a node at each end, because it cannot move there. Only waves that fit a whole number of half-wavelengths into the length \(L\) can form standing waves: \(L = n\lambda/2\), so \(\lambda_n = \frac{2L}{n}\) with \(n = 1, 2, 3, \ldots\). Using \(v_w = f\lambda\), the allowed frequencies are

f_n = \frac{n v_w}{2L} = n f_1

The lowest, \(f_1 = v_w/2L\), is the fundamental frequency, with one antinode in the middle. The others are whole-number multiples of it, called harmonics; \(f_2\) is also called the first overtone. Since \(v_w = \sqrt{F_T/\mu}\) from the previous topic, tightening a string raises all these frequencies.

Worked example: a violin string

A violin string vibrates over a length of 0.325 m and its fundamental is 196 Hz. Find the wave speed on the string, its next two harmonics and, if the string's mass per unit length is \(3.00 \times 10^{-3}\) kg/m, its tension. 1. From \(f_1 = v_w/2L\): \(v_w = 2Lf_1 = 2(0.325)(196) = 127\) m/s. 2. Harmonics: \(f_2 = 2f_1 = 392\) Hz and \(f_3 = 3f_1 = 588\) Hz. 3. Tension, from \(v_w = \sqrt{F_T/\mu}\): \(F_T = \mu v_w^2 = (3.00 \times 10^{-3})(127.4)^2 = 48.7\) N. 4. Check: pressing the string at its midpoint halves \(L\), so the fundamental should double to 392 Hz, one octave up, matching \(f_2\).

Beats

Superpose two sound waves of equal amplitude but slightly different frequencies, \(f_1\) and \(f_2\). At some moments they are in phase and add to a loud sound; a little later one has drifted half a cycle ahead and they nearly cancel. The result is a tone at the average frequency whose loudness rises and falls regularly. These pulses of loudness are beats, and they come at the beat frequency

f_B = |f_1 - f_2|

Two notes at 440 Hz and 444 Hz give 4 beats per second. As the two frequencies get closer the beats slow down, and when they match, the beats disappear. That is how musicians and piano tuners match strings to a reference.

Worked example: tuning by beats

A guitarist plays a string together with a 440 Hz tuning fork and hears 3 beats per second. After tightening the string slightly, she hears 1 beat per second. What were the string's frequencies before and after? 1. Beat frequency 3 Hz means the string was at \(440 + 3 = 443\) Hz or \(440 - 3 = 437\) Hz. 2. Tightening raises the wave speed and so the frequency. 3. If the string had started at 443 Hz, raising it would give more beats, not fewer. So it started at 437 Hz. 4. With 1 beat per second after tightening, it is now at 439 Hz. 5. Check: 437 to 439 Hz is a rise, as tightening requires, and \(|440 - 439| = 1\) Hz.

Waves carry energy

Every wave carries energy, from the gentle push of sound on an eardrum to the destruction an earthquake brings. That energy depends on the amplitude. Creating a wave means displacing the medium against a restoring force, and, as with a spring's \(\tfrac{1}{2}kx^2\), the energy stored grows as the square of the displacement. So the energy goes as the square of the amplitude: double the amplitude, four times the energy. Pure constructive interference of two identical waves therefore gives four times the energy of one wave at that spot. Energy is still conserved, because destructive interference leaves other places with none.

Intensity

How strongly a wave affects what it strikes depends on how its energy is spread out and how fast it arrives. Intensity is the power carried by a wave per unit area perpendicular to its direction:

I = \frac{P}{A}

Its SI unit is the watt per square metre, W/m². Because energy goes as amplitude squared, so does intensity: \(I \propto (\text{amplitude})^2\). Sunlight just above Earth's atmosphere has an intensity of about 1360 W/m², and on a clear day at noon about 1000 W/m² reaches the ground. A magnifying glass that squeezes sunlight onto a smaller area raises the intensity enough to scorch paper, without adding any power.

Worked example: a laser pointer

A 5.00 mW laser pointer produces a beam 1.00 mm in diameter. Find its intensity and compare it with sunlight above the atmosphere. Assume the power is spread evenly across the beam. 1. Area: \(A = \pi r^2 = \pi(0.500 \times 10^{-3})^2 = 7.85 \times 10^{-7}\) m². 2. Intensity: \(I = \frac{5.00 \times 10^{-3}}{7.85 \times 10^{-7}} = 6.37 \times 10^3\) W/m². 3. Ratio: \(6370/1360 = 4.7\). 4. Check: a tiny power on a minuscule area can still give a large intensity. The eye's lens focuses the beam further, which is why you must never look into a laser.

Common mistakes to avoid

First, adding amplitudes without signs; a crest and a trough partly cancel. Second, thinking interfering waves destroy energy; destructive interference in one place is balanced by constructive interference elsewhere. Third, using \(\lambda = L\) for a string's fundamental; it is \(2L\). Fourth, giving the beat frequency as the average or the sum of the two frequencies; it is the difference. Fifth, assuming intensity is proportional to amplitude; it goes as amplitude squared. Sixth, using a diameter where \(A = \pi r^2\) needs the radius.

Key takeaways

Overlapping waves superpose: their displacements add, and afterwards each continues unchanged. In phase, identical waves interfere constructively to double the amplitude; out of phase, they cancel. Opposite-travelling identical waves form standing waves with nodes λ/2 apart. A string fixed at both ends has λₙ = 2L/n and fₙ = nv/2L = nf₁. Two close frequencies give beats at f(B) = |f₁ − f₂|. A wave's energy and intensity go as amplitude squared, and intensity is I = P/A in W/m².

Flashcards

Flashcard

Superposition

Overlapping waves' displacements add at each point

Afterwards each wave carries on unchanged.

Test your understanding

Question 1 of 5

Two identical waves, each of amplitude 3.0 cm, meet exactly in phase. What is the amplitude where they overlap?

Question 2 of 5

Waves travel at 240 m/s on a string 0.80 m long, fixed at both ends. What is the frequency of its third harmonic?

Question 3 of 5

Two tuning forks of 256 Hz and 260 Hz are sounded together. What beat frequency is heard?

Question 4 of 5

A wave delivers 25.0 W evenly over an area of 0.0400 m² perpendicular to its direction. What is its intensity?

Question 5 of 5

The amplitude of a wave is doubled while everything else stays the same. What happens to its intensity?

← Previous topicNext topic →