Physics › Section K · Oscillations and waves › Topic K.6

Waves

Sound, light, ocean swell and earthquake tremors are all waves: disturbances that travel and carry energy without carrying the medium along with them. A handful of quantities, linked by one simple equation, describe every one of them.

A travelling disturbance

Drop a stone into a still pond and rings spread outwards, yet a leaf floating on the surface only bobs up and down as they pass. That is the essence of a wave: a disturbance that moves away from where it was created, carrying energy from place to place while the medium itself stays, on average, where it was. The simplest waves repeat for many cycles and are produced by a source in simple harmonic motion, so each bit of the medium also oscillates in SHM as the wave passes.

Mechanical and electromagnetic waves

Waves fall into two broad families. Mechanical waves, such as sound, water waves, waves on a string and seismic waves, are disturbances of a material medium, so they need one: sound cannot cross the vacuum of space. Electromagnetic waves, such as light, radio waves and X-rays, are oscillating electric and magnetic fields, and they travel through empty space. In a vacuum every electromagnetic wave travels at \(c = 2.998 \times 10^8\) m/s, about 870,000 times faster than sound in air. Later sections treat light in detail.

Transverse and longitudinal waves

In a transverse wave, the medium is disturbed perpendicular to the direction the wave travels: flick one end of a rope up and down and a hump runs along it. Waves on guitar strings are transverse, and so are electromagnetic waves. In a longitudinal wave, the medium is disturbed parallel to the direction of travel: push and pull one end of a stretched spring toy and regions of crowded coils, compressions, alternate with stretched regions, rarefactions. Sound in air and water is longitudinal. As the elasticity topic showed, fluids have essentially no shear modulus, so they cannot carry transverse waves through their interior. Solids can carry both kinds. Water surface waves are a mixture: the water near the surface moves in near-circles.

Earthquake waves

An earthquake sends both kinds of wave through the Earth. P-waves (primary, or compressional) are longitudinal and travel fastest, roughly 6 km/s in the upper crust. S-waves (secondary, or shear) are transverse and slower, roughly 3.5 km/s there. Because S-waves are transverse, they cannot pass through a liquid. Seismometers on the far side of the planet from a large earthquake record P-waves but no direct S-waves, and that S-wave shadow is key evidence that Earth's outer core is liquid. Surface waves, travelling along the ground, usually do most of the damage.

Describing a wave

Four quantities describe a simple repeating wave. The amplitude is the greatest disturbance from the undisturbed position, such as the height of a crest above the still water level. The wavelength, \(\lambda\), is the distance between adjacent identical points on the wave, such as crest to crest or compression to compression, measured along the direction of travel. The period, \(T\), is the time for one complete cycle at any one point, and the frequency is \(f = 1/T\), in hertz. Amplitude is independent of the wave's speed: a gentle ripple and a large one on the same pond travel at about the same speed.

The wave equation

In one period, a fixed point sees exactly one complete wave go by, so the wave advances one wavelength in one period. Its speed is therefore

v_w = \frac{\lambda}{T} = f\lambda

This holds for every kind of wave: sound, light, water and seismic waves alike. The speed \(v_w\), also called the propagation speed, is the speed of the disturbance, not of the particles of the medium, which simply oscillate in place. A key rule follows. The source sets the frequency, the medium sets the speed, and the wavelength adjusts to fit: \(\lambda = v_w/f\).

Worked example: one note, two media

A tuning fork vibrates at 440 Hz. Find the wavelength of its sound in air at 20 °C, where sound travels at 343 m/s, and in water, at 1480 m/s. 1. Rearrange \(v_w = f\lambda\): \(\lambda = v_w/f\). 2. Air: \(\lambda = \frac{343}{440} = 0.780\) m. 3. Water: \(\lambda = \frac{1480}{440} = 3.36\) m. 4. Check: the frequency is fixed by the fork in both cases, so the wavelength scales with the speed; water is \(1480/343 = 4.31\) times faster, and \(0.780 \times 4.31 = 3.36\) m. A listener underwater hears the same pitch, because pitch depends on frequency, not wavelength.

What sets the wave speed

A wave's speed depends on the medium: a stiffer medium snaps back faster and speeds the wave up, while a more massive one responds more sluggishly and slows it down. On a stretched string,

v_w = \sqrt{\frac{F_T}{\mu}}

where \(F_T\) is the tension (written this way here because \(T\) already means the period) and \(\mu\) is the mass per unit length in kg/m. Tighten a string and its waves speed up; thicken it and they slow down. Sound travels at about 343 m/s in air at 20 °C, about 1480 m/s in water and roughly 5000 to 6000 m/s in steel, because stiffness rises far faster than density from gas to solid.

Worked example: a wave on a string

A string with mass per unit length \(4.00 \times 10^{-3}\) kg/m is held at a tension of 100 N. Find the wave speed, the wavelength of a 300 Hz wave on it, and the speed if the tension is raised to 400 N. 1. Speed: \(v_w = \sqrt{\frac{100}{4.00 \times 10^{-3}}} = \sqrt{25{,}000} = 158\) m/s. 2. Wavelength: \(\lambda = \frac{158.1}{300} = 0.527\) m. 3. Four times the tension: \(v_w = \sqrt{\frac{400}{4.00 \times 10^{-3}}} = 316\) m/s. 4. Check: speed goes as the square root of tension, so four times the tension should double the speed, and \(2 \times 158 = 316\) m/s.

Worked example: locating an earthquake

A seismometer records the first P-waves from an earthquake 40.0 s before the first S-waves. Taking speeds of 6.00 km/s and 3.50 km/s, how far away was the earthquake? Assume both waves follow the same path at constant speed. 1. Travel times are \(d/6.00\) and \(d/3.50\) seconds, with \(d\) in km. 2. The lag is their difference: \(\frac{d}{3.50} - \frac{d}{6.00} = 40.0\). 3. So \(d(0.2857 - 0.1667) = 40.0\), giving \(d = 336\) km. 4. Check: P-waves take 56.0 s and S-waves 96.0 s, a 40.0 s gap. Three stations' distances together pinpoint the source.

Common mistakes to avoid

First, thinking a wave carries the medium along; it carries energy, while the medium oscillates in place. Second, confusing the wave speed with the speed of the oscillating particles, which keeps changing. Third, believing frequency changes when a wave enters a new medium; the source fixes it, and the wavelength changes instead. Fourth, mixing up the two types: sound in air is longitudinal, and waves on a string are transverse. Fifth, unit slips with prefixes, such as treating 100 MHz as \(10^6\) Hz instead of \(10^8\) Hz.

Key takeaways

A wave is a travelling disturbance that carries energy without carrying the medium. Mechanical waves need a medium; electromagnetic waves cross a vacuum at c = 2.998 × 10⁸ m/s. Transverse waves disturb the medium perpendicular to their travel; longitudinal waves disturb it parallel, in compressions and rarefactions. Fluids carry only longitudinal waves through their interior, which is how S-waves revealed a liquid outer core. Amplitude, wavelength λ, period T and frequency f describe a wave, and v = fλ. The medium sets the speed; on a string v = √(F_T/μ).

Flashcards

Flashcard

Wave

A disturbance that travels from its source, carrying energy

The medium oscillates in place.

Test your understanding

Question 1 of 5

An FM radio station broadcasts at 100 MHz. Radio waves travel at 2.998 × 10⁸ m/s. What is the wavelength?

Question 2 of 5

In a longitudinal wave, how do the particles of the medium move?

Question 3 of 5

Why do direct S-waves fail to reach seismometers on the far side of the Earth from a large earthquake?

Question 4 of 5

A moored buoy rises and falls 12 times per minute as waves pass, and the crests are 15 m apart. What is the wave speed?

Question 5 of 5

A string with mass per unit length 0.010 kg/m is under a tension of 64 N. What is the speed of waves on it?

← Previous topicNext topic →